Dell PowerEdge 2900 Support Question
Dell PowerEdge 2900 Support Question
Find answers below for this question about Dell PowerEdge 2900.Need a Dell PowerEdge 2900 manual? We have 9 online manuals for this item!
Question posted by FloydDa on March 20th, 2014
How To Configure Poweredge 2900 Bios Boot From Usb?
The person who posted this question about this Dell product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Dell PowerEdge 2900 Manual Pages
Installing a SATA Optical Drive - Page 3
... peripheral bay and remove the optical drive from the back of the optical drive.
6 PowerEdge 2900 and 1900 systems only: Perform the following steps.
b Remove the center fans and the...for specific step instructions. See "Opening the System" in your Hardware Owner's Manual.
4 PowerEdge 1950 systems only: Disconnect and remove the SAS controller daughter card. Before you begin this procedure...
Installing a SATA Optical Drive - Page 4
... 2970 Optical Drive
NOTE: If you must be replaced with the drive tray provided with the system is used for the SATA optical drive. The PowerEdge 2900 and 1900 systems do not reuse the interposer board attached to the old drive.
1 Pull outward on the left side of the drive.
4
Installing a SATA...
Installing a SATA Optical Drive - Page 9
... board.
See "Closing the System" in your Hardware Owner's Manual.
11 Reconnect the system to an available power supply cable.
5 Replace the center fan bracket.
PowerEdge 2900 and 1900
1 If the mounting screws are not attached to the drive, install them now.
2 Align the mounting screws with the bay slide slots and...
Installing a SATA Optical Drive - Page 10
... 1900
3
2
4
5 1
1 optical drive 3 SATA data cable 5 SATA power connector on SAS
backplane (PowerEdge 2900 only)
2 SATA power cable 4 SATA connector on system board
8 Reconnect the cables to power and turn on the system and attached peripherals.
10
Installing a SATA ...
Information Update - Page 1
Dell™ PowerEdge™ 2900 Systems
Information Update
Information Update - Page 3
...6 Installing the Optional Internal USB Memory Key 7
Processor Upgrades - Safeguarding Encrypted Data 9
System Message Update 10
LCD Status Messages Update 14
System Setup Program Update 19 Memory Screen 19 CPU Information Screen 20 Integrated Devices Screen 20 System Security Screen 21 Serial Communication Screen 22
Contents
3 PowerEdge 2900 II and PowerEdge 2900 III Systems 9
System...
Information Update - Page 5
... for iSCSI boot. New Security Features
• Trusted Program Module (TPM) support for improved security. • Optional support for optional SAS 6i/R and PERC 6/i adapters. This document provides updated information for your system on the following topics: • New system features for PowerEdge™ 2900 III systems • Internal USB memory key for PowerEdge 2900 III...
Information Update - Page 6
... the internal USB connector, the Internal USB Port option must be used as a boot device, security key, or mass storage device. To use with a USB flash memory key (see Figure 1-1).
Figure 1-1. The USB memory key can be enabled in the Integrated Devices screen of the System Setup program. Optional Internal USB Memory Key
The PowerEdge 2900 III system...
Information Update - Page 9
... before you are using Windows Server® 2008, you can access the encrypted files on the latest processor upgrade options for your system is upgradeable to create a recovery key during system setup. See support.dell.com for information on your hard drive(s). Processor Upgrades - PowerEdge 2900 II and PowerEdge 2900 III Systems
• If the...
Information Update - Page 10
...the configuration has changed (for complete information about safety precautions, working inside the system. Check other system messages for additional information for the PowerEdge 2900 ...the Hardware Owner's Manual.
!!*** Error: Remote Access Controller initialization failure *** RAC virtual USB devices may not be supported.
slot.
10
Information Update See your Product Information Guide...
Information Update - Page 14
... information on valid memory configurations, please see "Troubleshooting System Memory" in the Hardware Owner's Manual. Corrective Actions
Ensure that can occur on the technical support web site. If the problem persists, see the system documentation on the PowerEdge 2900 III system and the probable cause for each message. Faulty USB device, USB medium, optical drive...
Information Update - Page 21
... in the system. The operational state of the TPM is set to On without Pre-boot Measurements, the system reports the TPM to minimize IRQ sharing among devices.
When set to ... to the operating system and bypasses pre-boot measurements. When set to Off (default), presence of the TPM remains unchanged (all user settings for the PowerEdge 2900 III system.
When set to Distributed, ...
Information Update - Page 23
...a system running RHEL Version 4 Update 5 and Demand-Based Switching is enabled in the BIOS, cat/proc/cpuinfo and cat/sys/devices/system/cpu/cpuxx/cpufreq/scaling_ cur_freq displays an ... is supported by the PowerEdge 2900 and 2900 II systems, but not by the PowerEdge 2900 III system. SATA Optical Drive Support on RHEL3 and SLES9
SATA optical drives are supported on the Server OS Install tab.
Information Update - Page 46
...表 1-6 PowerEdge 2900 III TPM。
TPM Security （TPM TPM。
表 1-6. 新的 System Security
选项
说明
TPM Security
TPM
（TPM Off [
关
]）
Off TPM
设置为 On with Pre-boot Measurements POST TPM TPM。
设置为 On without Pre-boot Measurements TPM
TPM...
Information Update - Page 48
Microsoft Windows 2000
System Build and Update Utility Microsoft® Windows® 2000 将位于 Server OS Install PowerEdge 2900 和 2900 II PowerEdge 2900 III
Customize Log output file pathname USB
1-3
48
信息更新
Information Update - Page 116
Memory configuration does not support Node Interleaving.
れかの DIMM
ださい。
116 PowerEdge 2900 III 1-1
表 1-1
原因
対応処置
Alert! Node Interleaving disabled!
Information Update - Page 133
... Xeon 54xx BIOS で Demand-Based Switching cat/proc/cpuinfo および cat/sys/devices/system/cpu/cpuxx/cpufreq/scaling_ cur_freq
• RHEL 3 9 Intel Xeon 54xx proc/cpuinfo
RHEL 4
Microsoft Windows 2000
System Build and Update Utility Server OS Install OS OS Microsoft® Windows® 2000 PowerEdge 2900/2900 II OS PowerEdge 2900 III
133
Information Update - Page 146
표 1-1 PowerEdge 2900 III
표 1-1
메시지
원인
Alert! DIMM
!!*** Error: Remote Access Controller initialization failure *** RAC virtual USB devices may not be available...
PCIe PCIe SAS
146 Node Interleaving disabled! RAC
Invalid PCIe card found in the Internal_Storage slot!
Memory configuration does not ...
Information Update - Page 158
표 1-6에는 PowerEdge 2900 III TPM TPM Security(TPM TPM
표 1-6
옵션 TPM Security (TPM Off ( 끄기 ))
TPM Activation (TPM 활성화 )
설명
TPM
Off TPM
On with Pre-boot Measurements TPM POST TPM
On without Pre-boot Measurements TPM
TPM
Activate TPM
Deactivate TPM
No Change TPM TPM TPM...
Information Update - Page 160
...;전 4 5 BIOS cat/proc/cpuinfo 및 cat/sys/devices/system/cpu/cpuxx/cpufreq/scaling_ cur_freq
• Intel Xeon 54xx RHEL 버전 3 9 proc/cpuinfo
RHEL 4 Update
Microsoft Windows 2000
Microsoft® Windows® 2000 이 Server OS Install(서버 OS PowerEdge 2900 III 대신 PowerEdge 2900 및 2900 II
USB
160
Similar Questions
Dell Poweredge 2950 Not Booting
Dell Poweredge 2950 not booting server display panel show error e1410 system fatal error.
Dell Poweredge 2950 not booting server display panel show error e1410 system fatal error.
(Posted by rblasad 5 years ago)
