2006 Chrysler PT Cruiser Support Question
2006 Chrysler PT Cruiser Support Question
Find answers below for this question about 2006 Chrysler PT Cruiser.Need a 2006 Chrysler PT Cruiser manual? We have 1 online manual for this item!
Question posted by mstidd12 on March 25th, 2014
What Do I Have To Remove To Install Rt Headlight Assembly On 2006 Pt Cruiser
The person who posted this question about this Chrysler automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by waelsaidani1 on March 26th, 2014 4:15 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,777
Member since:
May 12th, 2013 Points: 19,501,777
Related Manual Pages
Owner Manual - Page 27
... 10 seconds. 2. Test the flash lamps with the ignition in the LOCK position, and the key removed. On non EVIC equipped vehicles perform the following steps: 1. On Electronic Vehicle Information Center (EVIC)..., while you are in the EVIC section of eight fobs can be shipped from the assembly plants with the Security Alarm activated will cause the alarm to ЉPersonal SettingsЉ...
Owner Manual - Page 30
... If you touch a battery, clean it with your fingers. To assemble the transmitter case, snap the two halves together. Remove and replace the batteries. NOTE: If the key fob is equipped ...until snug. With the transmitter buttons facing down, use a flat blade to damage the elastomer seal during removal.
2. Skin oils may cause battery deterioration. Make sure not to pry the two halves of the ...
Owner Manual - Page 36
... key, power door lock switch, or the Keyless Entry Transmitter and close all doors. 3. Remove and replace the batteries. If something triggers the alarm, the system will flash for about 18...first 3 minutes the horn will sound and the headlights, park lights, tail lights and the indicator light in the cluster will automatically disarm. Remove the keys from the ignition switch and get out...
Owner Manual - Page 69
...panel. Maintaining Your Airbag System
WARNING!
•
Modifications to any way (including removal or loosening/tightening of the airbag system could allow the passenger frontal airbag to modify...69
WARNING! Have the airbags, seat belt pretensioners, and the front passenger seat belt retractor assembly, replaced by an authorized dealer as soon as well. You need it is necessary to tell...
Owner Manual - Page 85
... have been damaged (bent retractor, torn webbing, etc.).
If necessary, slide the latch plate down the webbing to the rear seats.
2
WARNING! Seat belt assemblies must be removed from the guide to allow the belt to retract fully. The belt will automatically retract to improve seat belt accessibility. Seat Belt Webbing Guide...
Owner Manual - Page 108
...8226; Before buying any restraint system, make sure that it . This indicates that can install the child restraint in the automatic locking mode. Follow the instructions of the webbing has ... plate is all removed from the retractor until all applicable Safety Standards. We also recommend that you make sure that it has a label certifying that you install the restraint improperly,...
Owner Manual - Page 109
...Your vehicle is not in use, secure it in the vehicle with the seat belt or remove it could strike the occupants or seat backs and cause serious personal injury. They are round... with the child restraint anchorage system called LATCH, which stands for Lower Anchors and Tether for the installation of the seat cushion. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
109
belt several times to the ...
Owner Manual - Page 117
...; Convertible Top Operation ...121 ▫ To Lower The Top ...121 ▫ To Raise The Top ...124 ▫ Convertible Top Boot Cover Installation-If Equipped ...126 ▫ Convertible Top Boot Cover Removal And Storage ...130 ▫ Convertible Top Manual Override ...132 Ⅵ Mirrors ...133 ▫ Inside Day/Night Mirror - If Equipped ...135 ▫...
Owner Manual - Page 118
... Rear Seat (Sedan) ...169 ▫ Tumbling Rear Seat (Convertible) ...171 ▫ Rear Seat Removal (Sedan) ...175 Ⅵ To Open And Close The Hood ...177 Ⅵ Lights ...178 ▫... ...179 ▫ Interior Lights ...180 ▫ Multi-Function Control Lever ...181 ▫ Headlights, Parking Lights, Instrument Panel Lights ...182 118
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
▫ ...
Owner Manual - Page 176
... the floor attachments. Release Lever Location Tumbling Seat Release Strap
• Using the handle on the seat, the seat assembly can now be easily moved when removed from the vehicle.
• Lift up the seat and tumble the seat forward.
176
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
• Pull the release lever...
Owner Manual - Page 316
... repair) the original tire at the first opportunity. Installation of vehicle control. Installation of this tire, do so could result in loss... of this manual. 316
STARTING AND OPERATING
Limited Use Spare - This tire is not.
Failure to the cold tire inflation pressure listed on the limited use spare tire and wheel assembly...
Owner Manual - Page 331
...exerted on your vehicle. You must consider this as if it should not be installed between the hitch receiver and the trailer tongue
that typically provides adjustable friction associated with... rating is important that connect the spring bars to the tow vehicle, plus a removable hitch head and spring bar assembly that fits into the receiver opening and hook up brackets that you do not exceed...
Owner Manual - Page 349
Loosen, but do not remove, the wheel nuts by jacking on the crossmember below the radiator, on the front suspension crossmember, or on to ...the lug wrench.
To reinstall the cap, make sure it is properly lined up before pushing it on the rear axle assembly.
Remove the scissors jack and lug wrench from the stowage bag. Jacking Locations Do not attempt to raise the vehicle by turning ...
Owner Manual - Page 350
...off the jack, do not tighten the nuts fully until the vehicle has been lowered. WARNING! Install the spare wheel and wheel nuts with any sharp edges. Finish tightening the nuts. Raise the ... could slip off the hub. When reinstalling original wheel, properly align the wheel cover to remove the tire. 5. Remove the wheel nuts and pull the wheel and wheel covers where applicable off the jack and ...
Owner Manual - Page 375
... air cleaner unless such removal is periodic maintenance required.
WARNING!
When servicing the battery, always reinstall the battery ...the engine compartment before starting the vehicle with the air cleaner removed. The air cleaner box should be cleaned out and a new make-upair filter element should be installed during the normal air filter maintenance procedure. Failure to add water...
Owner Manual - Page 380
... regular intervals. Windshield Washer Reservoir The washer fluid reservoir is located in place. Fill the reservoir with windshield washer solvent (not radiator antifreeze). Install the new blade assembly onto the wiper arm tip until it locks in the rear of the engine compartment on the windshield. 3. Push the release tab shown in...
Owner Manual - Page 394
...contaminated with water.
Frequency Of Fluid Change Under normal operating conditions, the fluid installed at the factory will give satisfactory lubrication for any fluid additives to Maintenance Schedule...has occurred, refer to the transaxle. Fluid Level Check Check the fluid level by removing the fill plug. Fluid changes are not necessary unless the following conditions exist: &#...
Owner Manual - Page 399
...warm water to stone breakage than glass headlights. Cleaning Headlights Your vehicle has plastic headlights that you are lighter and less ...susceptible to restore the low glare surface.
7 Plastic is not as scratch resistant as glass and therefore different lens cleaning procedures must be cleaned on the towel or rag that are using. To remove...
Owner Manual - Page 408
Remove the headlight access cover splash shield, located in the front wheel well opening. 2. 408
MAINTAINING YOUR VEHICLE
BULB REPLACEMENT Headlight Bulb Replacement
CAUTION! Oil contamination will severely shorten bulb life. 1. Rotate the socket to the left one quarter turn and replace the bulb. Do not touch the new headlight bulb with your fingers.
Disconnect...
Owner Manual - Page 409
MAINTAINING YOUR VEHICLE
409
Front Park/Turn Signal/Side Marker Lights 1. If Equipped 1. Twist and remove the bulb from the fog light housing. 3.
Remove the headlight access cover splash shield, located in the front wheel well opening. 2. Remove the fasteners attaching the lower splash shield to gain access to replace and replace the bulb. Disconnect...
Similar Questions
2006 Pt Cruiser Car Stopped And Family Got Out And Car Caught Fire.
I changed a faulty Starter on a 2006 PT Cruiser drove it for 2 days w/o issue ,. On the third day wi...
I changed a faulty Starter on a 2006 PT Cruiser drove it for 2 days w/o issue ,. On the third day wi...
(Posted by Anonymous-149746 9 years ago)
My 2006 Pt Cruiser Is Over Heating, What Causes This To Happen?
Every five minutes i have to pull over and turn the ignition off so that the engine can cool off. Th...
Every five minutes i have to pull over and turn the ignition off so that the engine can cool off. Th...
(Posted by waltercbyrdmil 10 years ago)
I Have 2006 Pt Cruiser Chrylser & It Wont Go Into Reverse. Standard Shift
I drove my car to my brothers and it drove just fine, I backed up before I left my driveway. When I ...
I drove my car to my brothers and it drove just fine, I backed up before I left my driveway. When I ...
(Posted by lisaann1966 10 years ago)
My 2006 Pt Cruiser Basic Was Having A Problem With The Battery Light Staying On
That problem seemed to resolve itself after I had the battery, alternator and starter checked..ok......
That problem seemed to resolve itself after I had the battery, alternator and starter checked..ok......
(Posted by annemax 11 years ago)