Bosch WFVC540SUC Support Question
Bosch WFVC540SUC Support Question
Find answers below for this question about Bosch WFVC540SUC - Vision 500 Series Front Load Washer.Need a Bosch WFVC540SUC manual? We have 1 online manual for this item!
Question posted by cmccaherty on May 23rd, 2018
â??i Have A Bosch 500 Vision Series And I Am Getting An E12.
I have a Bosch 500 Vision Series and I am getting an E12. I ordered an intake water valve but it is the wrong piece. Please help! I need clean laundry
Current Answers
Answer #1: Posted by Odin on May 24th, 2018 9:52 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Per hunker.com:
These codes will appear together with the indicator light "spin." This means there is a leak in the hose, the water tap is not on, the water pressure is too low, or the hose is kinked or clogged. Turn off the water and check the hose for kinks. Clean any debris you find from the inlet strainers; it may be impeding water flow.
If a merchant supplied the wrong part, return it for the right one or a refund.
These codes will appear together with the indicator light "spin." This means there is a leak in the hose, the water tap is not on, the water pressure is too low, or the hose is kinked or clogged. Turn off the water and check the hose for kinks. Clean any debris you find from the inlet strainers; it may be impeding water flow.
If a merchant supplied the wrong part, return it for the right one or a refund.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Bosch WFVC540SUC Manual Pages
User Manual - Page 2
..., Bosch Vision gets the most efficient and accurate water heating method for the toughest stains. By adding water faster and constantly raining water back down on the market. Exclusive Hinge and Gasket System
A reinforced hinge and our unique gasket design help seal in the home without causing a disturbance. Baby Caret Cycle
The littlest people in the
Bosch Vision washer for...
User Manual - Page 3
... bolts 11
Water connection 12
Electrical connection 14
Leveling procedure 15
Transporting the Washer 16
OPERATING INSTRUCTION 17
Panel 17
Before Using For the First Time 18
Using For the First Time 18
First washing cycle (without laundry 18
Preparing the laundry 18
Sorting the laundry 19
Degrees of soiling 19
Loading the laundry 19
Laundry Detergents and...
User Manual - Page 4
...produced in a hot water system that has not been used for regular cotton loads. These operating and installation...products can not cover all laundry chemicals and aids in the appropriate places. Definitions d WARNING
WARNING - BOSCH washers are indicated in a ...machine to obtain superior cleaning results. Low noise level for several minutes before using your washer. Large door with...
User Manual - Page 5
... transport fixing bolts have shutĆoff valve(s) at high temperatures.
22. Do not...cleaning products out of the reach of the washing machine.
14. all water connections to the washing machine have been removed.
29. Precautions should be stored on or in the washer or on the washer... user maintenance instructions or in subsequent wash loads causing skin irritation.
26. SAVE THESE ...
User Manual - Page 6
...in accordance with all possible conditions which may occur.
Connect to whether the washer is properly grounded. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. B. GROUNDING INSTRUCTIONS
...local codes and ordinances. Common sense, caution and care must be grounded.
Check with the washer.
6
d WARNING
Improper connection of electric shock by a qualified electrician. DO NOT modify ...
User Manual - Page 7
... the washing machine.
For cleaning machine-washable
fabrics in the pump or water inlet hose(s) must be ...washer door to prevent children from shipping carton and packaging components to a better environment by disposing of laundry and water... - Water supply hose for your model are missing, contact your washer. Water supply hose for high efficiency and front loading washers.
...
User Manual - Page 8
The accessory parts bag contains: 1. Socket wrench13 mm 3. Risk of water-resistant plywood (at least 3/4" thick) to extend underneath both the washer and the dryer for best results and even height of the washing machine with holding brackets (set) from Bosch Customer Service (WMZ 2200).
8 This appliance must leave thread of height-adjustable feet...
User Manual - Page 9
... of the stacking kits shown on page 9.
Refer to wall as venting or water connection will add approximately 15 inches to be fitted with vents of a specified ...washer). d CAUTION
Appliance must be installed in undercounter installation section on the location of the exhaust air connection, a minimum distance of 5 ¼ inch (13.4 cm) must be provided for the laundry...
User Manual - Page 10
... cm)
Appliance must not be mounted on a pedestal for under counter installations.
10
The washer must not be mounted on a pedestal for stacked installations.
d WARNING
(More than two ... cm)
H Width
27.50 in. (69.9 cm)
Width* 54.75 in. (139.1 cm)
* washer and dryer side by side recessed or closet installation are shown in the illustration below . cm)
Required Installation Space...
User Manual - Page 11
... the washer into place
connect the water supply lines and
12
drain pipe
connect the electrical power
14
slide the washer into ...retaining slot, then pull it before first use, run a cleaning cycle 18
Removing the transport bolt assemblies
d CAUTION
To avoid...all four bolt assemblies in the order shown in (A) and slide the cover towards the open washer door to removing the transport bolt...
User Manual - Page 12
...help reduce the risk of damaged or kinked hoses is not necessary to remove the washer to the faucet) an additional two-thirds turn on and at the wall faucet. NOTICE
To prevent water damage, the hot and cold water valves...clean the strainer.
A short extension hose (part no. 645787 ) is exceeded. Check seal with hot (max. 140 °F / 60 °C) and cold tap water. Water connection
Water...
User Manual - Page 13
...more than 5 feet (152.4 cm) from the end of
the washer. Water drainage
NOTICE
Do not bend or pull the water drainage hose.
q Use a strap or cable tie to the machine...valve in the AquaStopt hose and a floating switch in place. q The hose and elbow should be properly extended into the wall drain approximately three and a half to the end of the hose and insert the end of the washer...
User Manual - Page 14
... socket. Do not insert/remove the power plug with an equipmentĆgrounding conductor and a grounding plug. Connection specifications as well as to whether the washer has been properly grounded. Replacement power cords are stipulated below:
Volts 110-120
Hertz 60
Amperes 15
Watts 1350 (max.)
Make sure that: - d WARNING
Improper...
User Manual - Page 15
... final position, check to see if it is correctly positioned.
15 Try pushing down upon , it is necessary to place a large bowl nearly full of water on the corner of Leveling the Washer
The high spin speeds realized by tightening the locknut back up against the bottom of the...
User Manual - Page 16
... locked in place against the bottom of the sleeve. Disconnect the washing machine
from the washer for each corner. The locknut should not rock or move , repeat the process. Install... washer leveling feet. If any rocking or movement of the washer is inserted in .) wrench, or pair of slip joint pliers, to turn when turning the locknut, or the height of the washer. Turn off the water...
User Manual - Page 17
...
Cycle selector Switches the machine on 300 Series washers)
Buttons for the washing
cycle. Can be delayed in both directions.
Delay Start button (500/DLX Series)
The Start time can be turned in... "Pause" can be started, the door is lit red.
The Start time is displayed (500/DLX Series) if the delay start function is additionally selected (not on and off : Program is finished...
User Manual - Page 18
...the washer off lint and dirt. Pour 1-2 Tbsp. The Start/Pause indicator light flashes (red).
9. When Remove laundry" is closed.
7. A small amount of residual water may ...laundry in a mesh laundry bag: q Baby socks (small items) q Hosiery q Belts q Underwired bras (due to risk of the wire coming loose during washing and causing appliance damage).
3. d WARNING
Before using your initial load...
User Manual - Page 22
... R
1200
Baby Caret
1200
Drain & Spin
* 300 Series maximum spin speed is pressed, an additional rinsing cycle will vary depending on cycle selected, temperature and pressure of incoming water, water hardness, size of load, type of fabrics and amount of tough, ground-in part on the laundry fabric type. Cycle times will be selected by...
User Manual - Page 32
..., as is the best way for purposes of this warranty and this Statement of Limited Product Warranty applies only to the Bosch Visiont Clothes Washer (Product") sold as Your Exclusive Remedy: During this warranty period, Bosch or one or more than 100 miles from an authorized service provider) or is under conditions of...
User Manual - Page 33
outdoors, use the Product, or visits where there is nothing wrong with local fire and building codes and regulations; (5) ordinary wear ...exposed parts; and resetting of installation problems (you should contact the nearest Bosch authorized service center. How to use of the Product in conjunction with air or water-going vessels); (2) any party's willful misconduct, negligence, misuse, abuse,...
Similar Questions
E 12 Error Five Times Before Load Is Done!!! Vision 300.
e12 code over and over. Plenty of water pressure. Iron in water though. Cleaned filter area. Leveled...
e12 code over and over. Plenty of water pressure. Iron in water though. Cleaned filter area. Leveled...
(Posted by Bubbawinslow 8 years ago)
Wat Is Error Codee12
(Posted by cgalvin1212 8 years ago)
Door Locked On Bosch Vision 500 Front Load Washer With E13 Code Displayed.
how can i open it manually to get the clothes out?
how can i open it manually to get the clothes out?
(Posted by amendieta 11 years ago)
E13 Error On A Bosch 500 Series Front Load Washer
(Posted by Kelloggrk 11 years ago)
E12 Error Code
(Posted by rgarcia43 12 years ago)