Rheem RARL-JEC Support and Manuals
Get Help and Manuals for this Rheem item
View All Support Options Below
Free Rheem RARL-JEC manuals!
Problems with Rheem RARL-JEC?
Ask a Question
Free Rheem RARL-JEC manuals!
Problems with Rheem RARL-JEC?
Ask a Question
Popular Rheem RARL-JEC Manual Pages
Installation Instructions - Page 2
... Customer Satisfaction Issues 8 3.6 Unit Mounting 8 3.7 Factory-Preferred Tie-Down Method 8 4.0 REFRIGERANT CONNECTIONS 9 4.1 Tools Required for Installing & Servicing R-410A Models 9 4.2 Specifications of R-410A 10 4.3 Quick Reference Guide for R-410-A 10 5.0 REPLACEMENT UNITS 11 6.0 INDOOR COIL 11 6.1 Location 11 7.0 INTERCONNECTING TUBING 11 7.1 Vapor and Liquid Lines 11 7.2 Maximum...
Installation Instructions - Page 5
...
2.0 GENERAL INFORMATION
The (-)ARL-series of installation is the heat energy measured on and off too quickly and does not properly remove humidity, producing an uncomfortable living space.
A heat gain calculation begins by humidity removal.
There are equipped with these components to the engineering Specification Sheets for installation and setup using Comfort Control2 or...
Installation Instructions - Page 6
...SERVICE ACCESS TO ELECTRICAL & VALVES ALLOW 24" [610 mm] CLEARANCE ONE SIDE
BOTTOM VIEW SHOWING DRAIN OPENINGS (\\\\\ SHADED AREAS).
2.4 ELECTRICAL & PHYSICAL DATA
TABLE 1
(-)ARL-JEC ELECTRICAL DATA
ELECTRICAL
PHYSICAL
DIMENSIONAL DATA
Model...DIMENSIONS AND INSTALLATION CLEARANCES
AIR ADIRIDSISCCHHARAGERGE ALLOW 6A0LL"OW[16050 [215424 mmm]mCLE]ARCANLCEE ARANCE
W
UNIT MODEL NUMBER EXPLANATION...
Installation Instructions - Page 7
...codes and ordinances for energy efficiency when matched with a good automobile polish will provide longer life and simplified servicing... Installation Instruction Manual and reference the applicable Engineering Specification Sheet when installing this...parts of the cabinet with appropriate coil components. Failure to confirm proper charge and airflow may be installed outdoors. Installation...
Installation Instructions - Page 9
...Finish unit assembly per unit's installation instructions.
4.0 REFRIGERANT CONNECTIONS
All units ...service equipment or components on concrete where 4 holes will be made to prevent system contamination.
4.1 Tools Required For Installing & Servicing R-410A Models
Manifold Sets: -Up to 800 PSIG High side -Up to break.
FIGURE 2
RECOMMENDED ELEVATED INSTALLATION
STEP 3: Using basepad as a guide...
Installation Instructions - Page 10
...
Manifold sets need to 800 psig high-side and 250 psig low-side with POE oils.
10 Hoses need to range up to have a 400 psig service pressure rating... 3
SCREW LOCATIONS
TABLE 2
DIMENSIONS
MODEL NUMBER (-)ARL-024/036/048/060
L
W
A
B
C
D
41.5 29.813 15
38
3.5
26.5
4.2 Specifications of R-410A:
Application: R-410A is not a drop-in replacement for R-410A. It cannot be ...
Installation Instructions - Page 15
...
• Assemble tubing part way into fitting. silver alloy ...repair.
! Leak test all around the copper stub and the service valves before soldering.
Always keep the flux from service...- Back out counterclockwise.
• Replace the valve cap finger tight then ... Testing
• Pressurize line set and coil through the tubing ...CCH is standard on these models due to prevent dripping (...
Installation Instructions - Page 16
... TO RESET. All heaters are standard on all models.
10.0 HIGH AND LOW PRESSURE CONTROLS 10.0 ...of the entire service procedure. Moisture chemically reacts with the thermostat. These attack motor windings and parts, causing breakdown. ...compressor stays off .)
9.0 HARD START COMPONENTS
Factory-installed start -up or after extended shutdown periods, make sure the heater is...
Installation Instructions - Page 27
... thermostat and outdoor unit.
27 First stage operation
Y2 - Compressor will flash the above codes. Control mis-operation • Flash 9 - Low voltage wiring may be used if .... CONVENTIONAL THERMOSTAT WIRING
11.7 Conventional 24VAC Thermostat Control Wiring
The (-)ARL series of heat pumps allow the installer to a conventional thermostat that is L terminal compatible, the thermostat display ...
Installation Instructions - Page 36
... Startup
Connect the system. 16.0 ACCESSORIES
16.1 Remote Outdoor Temperature Kit (Part No. 47-102709-03)
This is a kit that has a longer remote sensor that can be installed away from the outdoor unit for better thermostat temperature display.
17.0 TROUBLESHOOTING
IMPORTANT: The JEC series units with the ICC (Integrated Compressor Control) provide status and diagnostic...
Installation Instructions - Page 40
...set too high • Defective contactor
• Blown fuses / tripped breaker • Transformer defective • High pressure control open • Replace fuses / reset breaker • Check wiring-replace... Replace - 17.5 General Trouble Shooting Chart
! should be ... • Repair or replace • Recover refrigerant, evacuate & recharge
• Change to unit service panel •...
Installation Instructions - Page 41
...
Restriction in supply air stream Differential setting too close Customer misuse Internal foreign matter Power element failure Valve too small Distributor tube/tubes restricted Restricted with correct rotation motor Correct installation Check for dryer vent near unit Check for recirculation from previous compressor failure
41 17.6 Service Analyzer Charts
COMPRESSOR OVERHEATING SYMPTOMS High...
Warranty Guide - Page 4
...RARL-JEZ
-
-
-
-
-
RHPN
-
-
-
-
-
- CONDENSING UNITS
RANL-JEZ
-
-
-
-
- RASL-JEZ
-
-
-
-
-
RHPL
-
-
-
-
-
-
in the original installation; RGJD
-
-
-
- Series™
LIMITED WARRANTY GUIDE
MODEL
LIMITED 10-YEAR
10-YEAR CONDITIONAL
PARTS
PARTS
WARRANTY1 WARRANTY5
LIMITED 5-YEAR PARTS WARRANTY6
10-YEAR CONDITIONAL UNIT
REPLACEMENT...
Warranty Guide - Page 9
... f) Covered Equipment which vary from whom the Covered Equipment was purchased will repair or replace, at its option, ANY PART of Covered Equipment installed in residential* (not commercial) applications which do not allow limitations on the reverse side in accordance with the Manufacturer's instructions; i) Covered Equipment when operated with system components (indoor unit, outdoor unit...
Warranty Guide - Page 11
... on how long an implied warranty lasts, or for removing or reinstalling parts. RHEEM SALES COMPANY, INC. (Manufacturer of a properly matched system as specified by the Air Conditioning, Heating & Refrigeration Institute (AHRI). The replacement will repair or replace, at its option, ANY PART of Covered Equipment installed in residential* (not commercial) applications which do not allow...
Rheem RARL-JEC Reviews
We have not received any reviews for Rheem yet.