Poulan 810EPT Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan 810EPT manuals!
Problems with Poulan 810EPT?
Ask a Question
Free Poulan 810EPT manuals!
Problems with Poulan 810EPT?
Ask a Question
Most Recent Poulan 810EPT Questions
Poulan Ept810 Fan Blade Removal
How do you remove the fan blade from the motor shaft?
How do you remove the fan blade from the motor shaft?
(Posted by gregrhanson 8 years ago)
Popular Poulan 810EPT Manual Pages
User Manual - Page 2
... until you com- Do not allow children to provide reasonable safety and efficiency in this manual must be followed to be
dangerous! Use only accessories and replacement parts as non-fogging, vented goggles or face screen;
heavy, long pants, and long sleeves; Secure or remove
loose clothing and jewelry or clothing with non-slip soles;
Wear...
User Manual - Page 3
...attachments)
WARNING:
Avoid a dangerous environment. S Avoid dangerous environments. Do not use and replace if damaged. let. Inspect extension
cord before operating this manual... ELECTRICAL SAFETY (applies to install the proper wall out-...extension cords specifically marked as suitable for repair. Do not... controls before servicing, and when changing accessories and/or attach- Do not...
User Manual - Page 4
...-in the OPERATION section. Always replace bar and chain immediately if it was intended.
S Do not use .
A double insulated appliance is a light- The symbol (square within a square)
may be marked on the switch. Seri- S Never stand under the limb you to dig into any damage repaired by qualified service personnel can also result in...
User Manual - Page 6
..., rope, string, etc. S Store the unit so the line limiter blade (on
left . leased. S Keep oil cap, screws, and fasteners securely tightened. S Follow instructions for lubricating and changing accessories and for damaged parts. S Check for changing trimmer
line. S Use only recommended attachments and replacement parts to be properly repaired or replaced by an authorized service dealer...
User Manual - Page 7
...injury to be installed. Make sure powerhead is in manual and on any surface except a clean, hard area.
S Inspect unit before each optional attach- S Do not set unit on attachment. The force of...ment used, read entire instruction manual before cleaning the tines with your body away from people, animals, glass, and solid objects such as
rocks, vines, branches, rope, string, etc. NOTE: ...
User Manual - Page 8
... the terrain, large roots, etc.
SAVE THESE INSTRUCTIONS
WARNING: Use of injury to be thrown, or otherwise cause injury or damage during operation.
WARNING: A coasting blade can seriously cut . Remove objects (rocks, broken glass, nails, wire, etc.) which can wrap around the shaft. Replace parts that can be
edged before using your body...
User Manual - Page 9
... Know how to stop before attaching the snowthrower to use the ...HEDGE TRIMMER SAFETY
DANGER: RISK OF CUT; Blades move momentarily
after the trigger is released. Have worn or damaged parts replaced... near win-
Remove all parts of your pruner attachment. S Make sure the...the blade has stopped moving parts do not freeze. S...of the instruction manual supplied with the motor...
User Manual - Page 11
... 14 Gauge
Extension cords are available for future reference. For proper orientation of shield, see KNOW YOUR TRIMMER ATTACHMENT illustration in bracket. 4. See CHAIN TENSION in the SERVICE AND ADJUSTMENTS section. erly installed.
OPERATING INSTRUCTIONS
Use only a voltage supply as shown. 3. Save this manual for this unit.
11 TRIGGER SWITCH
The TRIGGER SWITCH is equipped with your...
User Manual - Page 12
... housing and upper shaft, pull the attachment straight out of attach- Remove the shaft cap from the chain and/or discoloration of this manual before removing the oil
cap. Always fill the bar oil tank before removing or installing attachments. Coupler Lower Attachment
Upper Shaft
3. ment (if present) and discard. 2. oz.). Poulan oil resists high temperature thinning.
Seek...
User Manual - Page 15
... Contact an authorized service dealer for
loose or damaged parts. Chain tension is operated with a loose chain, the chain could jump off unit with lower end supported. Lift up .
Mowing
the surfaces being swept and move the tool from
power source before performing maintenance. Chain Adjustment Tool
Guide Bar
2. Turn adjusting screw clockwise until sag does...
User Manual - Page 17
... minutes of operation. Hold chain with the drive links as required. Replace the old chain when it is positioned in the lower hole in guide bar groove. Place chain over sprocket, fitting the drive links in the nose of kickback which can cut you require further assistance or are in the repair parts list. Improper hook
angle...
User Manual - Page 18
... SERVICE PARTS
REPLACEMENT PART Assist handle Bolt carriage, 1/4-20 Wing nut Bar Chain Hex nut Oil cap Bar adjusting screw/pin kit Spool with 0.080″ trimmer line Shield assembly
PART NUMBER
530057546 530015786 530016152 530044908 952051549 530015917 530053072 530069110 952711616 530071964--01
STORAGE
WARNING: Perform the following
steps after each use wire, rope,
string, etc., which...
User Manual - Page 19
..." in
Service and Adjustments section.
5. for bar and
2.
Trimmer head stops under a load or does
not turn when switch is engaged.
1. Replace guide bar. 1. Remove debris. Repair or replace. 3. Fill oil tank. 2. Line does not advance or breaks while cutting.
1. line. 4. Cutters dull, improperly
sharpened, or depth gauges too high. 5. Resharpen or replace chain. 4. Oil...
User Manual - Page 20
... pre--delivery setup or normal adjustments explained in head.
2. The policy of 1975. LIMITED WARRANTY
Poulan, a division of Husqvarna Consumer Outdoor Products N.A., Inc., warrants to the original consumer purchaser that will wear and require replacement with reasonable use of accessories and/or attachments not specifically recommended by Poulan for repair or replacement at any time...
Parts List - Page 1
.... Hanger Decal - Pole Saw Warning
= New Part Number For This IPL
= Refer to design changes.
4
5
6
7 8
10
11 12
13
9
MODEL 810 EP Page: ...Manual - Model Warning Decal -
Ref. Shaft Warning Decal - Operator Wrench -
Hex (5/32") Attachment - WARNING
All repairs, adjustments and
20
maintenance not described in
the Operator's Manual must be
performed by Qualified Service...
Poulan 810EPT Reviews
We have not received any reviews for Poulan yet.