Pioneer PRS-D4200F - Premier Amplifier Support and Manuals
Get Help and Manuals for this Pioneer item
View All Support Options Below
Free Pioneer PRS-D4200F manuals!
Problems with Pioneer PRS-D4200F?
Ask a Question
Free Pioneer PRS-D4200F manuals!
Problems with Pioneer PRS-D4200F?
Ask a Question
Popular Pioneer PRS-D4200F Manual Pages
Owner's Manual - Page 2
Contents
Before Using This Product 2
Information to User 2 Inportant 2 After-sales service for Pioneer products .......... 2 CAUTION 3 Visit our website 3 CAUTION 3 WARNING 4
Setting the Unit 5
Power Indicator 5 Top Cover 5 Cut Off ...and Input Wires ...... 12
Installation 14
Example of installation on the floor mat or on the chassis 15
Replacing the top cover 15
Specifications 16
1
Owner's Manual - Page 3
... read all instructions and WARNINGS in this amplifier is written on the enclosed warranty card. Important
The serial number of the unit. For your nearest Pioneer authorized dealer or installation specialist. In case the necessary information is designed to operate the equipment. Keep the card handy for repair without appropriate authorization may invalidate the user's right...
Owner's Manual - Page 4
... (or lower) bridged mode (Diagram B). The use your local authorized Pioneer dealer or call Pioneer customer service.
3 To properly install or use a bridged mode for bridging as loss or theft.
2 Receive updates on file to help you have any questions or concerns, please contact your Pioneer amplifier by wiring speakers rated at the following site:
http://www...
Owner's Manual - Page 5
..., a chemical known to the State of the amplifier. Detect the cause and solve the problem, then replace the fuse with another one of the same size and rating.
• To prevent malfunction of the amplifier and speakers, the protective circuit will cut the power supply to , for installation of California and other governmental entities to...
Owner's Manual - Page 6
BFC (Beat Frequency Control) Switch
BFC switch is on . Top Cover
Before setting up the unit, unfasten the screws with your car stereo, change the BFC switch using a small standard tip screwdriver. 5
If you can select a cut off frequency from 40 Hz to an AM broadcast with a 4 ...
Owner's Manual - Page 7
.... Normally, set the gain controls to the left . Use if you want to the Pioneer amplifier. Gain Control
Adjusting the gain controls A and B will help match the output of the car stereo to cut...max.
For connection instructions, see the "Using the Speaker Input" section.
6 When using a speaker output, slide the switch to use one input plug, set to match the car stereo output level....
Owner's Manual - Page 8
...When outputting sound at increased volume of the head unit, set the gain control of the amplifier to the proper position but still the sound cuts out ...set to NORMAL.
7
Setting the Unit
Setting the Gain properly
• This unit is equipped with a protective function to prevent malfunction of the unit itself and speakers from time to time, contact the nearest authorized PIONEER Service...
Owner's Manual - Page 9
...amplifier is for example where the heater will get hot, for vehicles with a 12-volt battery and negative grounding. Turn the car... to be exceeded, causing overheating.
• Never replace the fuse with cable clamps or adhesive tape. Use...Min. 200 W Max. The current capacity of the vehicle, such as possible from the wire. Before installing it should conform with moving parts of ...
Owner's Manual - Page 10
...Amplifier with speaker output, connections defers from the diagram.
Connecting wire with RCA output jacks
External Output If only one input plug is used, do not connect anything to set the input switch. If the car... the Speakers and Input Wires" section for speaker connection instructions.
Slide the input switch to the left (RCA).
• When you need to RCA input jack B.
Owner's Manual - Page 11
...twisted wires.
• Fasten while making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the car body.
• Recommended wires size (AWG: American Wire Gauge)... could cause the terminal area to tighten and loosen the terminal screw of this amplifier (Power terminal, GND terminal, System remote control terminal). Securely fasten the wire with...
Owner's Manual - Page 12
... Slide the input switch to the right (SP).
• As a result of the amplifier is turned on automatically when the car stereo is turned on. Note: • Connect the system remote control wire when the
power...Terminals
• Use a 10 AWG to be turned on when the car stereo is turned on.
11 Expose the end of the amplifiers with the terminal screws. It is not necessary to 12 mm (1/2 ...
Owner's Manual - Page 14
... (RCA output)
Speaker (Right) Speaker (Left) Speaker (Mono) Speaker (Mono)
13 Connecting wire with RCA plugs (sold separately)
From car stereo (RCA output)
Two-channel (Mono)
Input select switch is on the top of the unit.
RCA input jack A In the case of two-channel ...
Owner's Manual - Page 15
... in a short-circuit.
• Confirm that no parts are used, they may damage internal parts of any parts other than the supplied ones are behind the panel when drilling a hole for installation differs with the car model and installation location. Electrical shock could result from contact with liquids. Also, amplifier and speaker damage, smoke, and overheating could result...
Owner's Manual - Page 16
... at the point marked, and install the amplifier, either on the chassis
1. Replacing the top cover
1. Insert the supplied tapping screws (4 mm × 30 mm) into the screw holes. Align the unit and top cover, and insert the screw.
• The cover can be located.
2. Installation
Example of installation on the floor mat or on...
Owner's Manual - Page 17
...209;OL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
Specifications
Power source ...14.4 V DC (10.8 ...for two channels) 20 A (2 Ω for four channels) Fuse ...30 A × 2 Dimensions ...301 (W) mm × 57 (H) mm × 213 (D) mm [12 (W) in ×...dBA (Reference: 1 W into 4 Ω)
Note: • Specifications and the design are subject to possible modification without notice
due to ...
Pioneer PRS-D4200F Reviews
We have not received any reviews for Pioneer yet.