Maytag MVWC465HW Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MVWC465HW manuals!
Problems with Maytag MVWC465HW?
Ask a Question
Free Maytag MVWC465HW manuals!
Problems with Maytag MVWC465HW?
Ask a Question
Most Recent Maytag MVWC465HW Questions
Why Doesn't It Fill With Water?
Tried the sensor and deep water wash and the clothes never get fully submerged
Tried the sensor and deep water wash and the clothes never get fully submerged
(Posted by philcreswell 2 years ago)
Maytag MVWC465HW Videos
Maytag MVWC465HW Top Load Washer
Duration: :51
Total Views: 2,171
Duration: :51
Total Views: 2,171
Maytag MVWC465HW Laveuses à chargement vertical
Duration: :49
Total Views: 228
Duration: :49
Total Views: 228
Popular Maytag MVWC465HW Manual Pages
Installation Instructions - Page 2
... toll-free phone numbers on back page of your Use and Care Guide. INSTALLATION REQUIREMENTS
Tools and Parts Gather required tools and parts before starting installation. Drain hose with clamp, U-form, and cable tie
Inlet hoses with washer)
Your installation may require additional parts.
If you have:
You will need:
Overhead sewer
Standard 20 gal. (76 L) 39" (990...
Installation Instructions - Page 3
... set to reduce noise transfer. Water remaining in washer after use may cause damage in a manner that may be purchased separately. It is installed, top and bottom air openings in your Use and Care Guide for walls, doors, and floor moldings. n A level floor with water and load) of or leaking from bottom of installation and servicing...
Installation Instructions - Page 4
... remove all shipping materials for proper operation. n Check with local codes and ordinances. n Do not have the properly grounded outlet installed by a qualified electrician. Remove shipping base
To avoid damaging floor, place cardboard supports from washer.
1.
NOTE: To avoid floor damage, set washer onto cardboard before moving it is recommended that a qualified electrician determine...
Installation Instructions - Page 5
...washer later.
4. Squeeze clamp with pliers and slide black elbow end of laundry tub.
See "Tools and Parts".
6. You may need to remove all parts from tray. NOTE: Keep tray in case you need additional parts...of laundry tub. Remove packing tray from tub. IMPORTANT: 4.5" (114 mm) of the washer. For a floor drain, remove the preinstalled drain hose form as shown. Place drain ...
Installation Instructions - Page 6
... to hot water inlet valve marked with flat washers (not provided). Screw coupling by hand until it is snug. 7. NOTE: Both hoses must use old hoses. Record hose installation or replacement dates for cold water faucet. Repeat with separate directions. See "Tools and Parts". n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or...
Installation Instructions - Page 7
Check levelness of front using lid, as a guide to raise the washer. or
Models with plastic feet
If washer is level, skip to make solid contact with a wood block or similar object that will support weight of washer and repeat as needed. HELPFUL TIP: You may want to reduce excess noise and vibration.
13.
On all four...
Installation Instructions - Page 8
... packaging materials.
q Read "Washer Care" in your washer, measure 1/2 of normal
recommended amount of /recycle all parts are on washer. q Check that shipping materials were completely
removed from console and any cycle.
Plug into a grounded 3 prong outlet. q Check that water faucets are now installed. q To test and clean your Use and Care Guide. Select any tape...
Owners Manual - Page 2
...the Installation Instructions for 2 weeks or more. WARNING
You can be killed or seriously injured if you don't immediately follow instructions. This will release any servicing unless specifically recommended in the usermaintenance instructions or in published user-repair instructions that you don't follow instructions. As the gas is flammable, do not smoke or use replacement parts that...
Owners Manual - Page 3
... mold or mildew. Low-water washing creates excessive sudsing with affresh® cycle operation:
1. Using non-HE detergent will be marked "HE" or "High Efficiency." Do not go over time, buildup of using your model does not have a "Clean Washer" cycle that the old washers are found. See the Installation Instructions for cleaning the inside of...
Owners Manual - Page 4
...Guide for a period of the part code mentioned herein will be moved during freezing weather, winterize your washer for information about 30 seconds to wipe away any remaining water into washer...not use washer again: 1.
Failure to clean washer and remove antifreeze, if used. Refer to Installation Instructions to remove the drawer and clean it will be automatically replaced by the...
Owners Manual - Page 5
... be exposed to 1 3/4″ (45 mm)
Flashlight
Bucket
Parts Supplied:
NOTE: All parts supplied for your responsibility. See "Washer Maintenance and Care" for
ordering information.
check
your Quick Start Guide. Install your washer in your Quick Start Guide for winterizing information. You will be automatically replaced by the number "4000" (e.g. Tools Needed:
Adjustable or...
Owners Manual - Page 6
... of washer.
If a mating outlet is not available, it is recommended that a qualified electrician determine that may be automatically replaced by a qualified electrician.
� If codes permit and a separate ground wire is used, it is adequate.
� Do not ground to your model, refer to a gas pipe. � Check with spacing of installation and servicing, and...
Owners Manual - Page 7
... the letter "W" of the part code mentioned herein will reduce the risk of electric shock by providing a path of a malfunction or breakdown, grounding will be in doubt as to install it must be automatically replaced by a qualified electrician. NOTE: Keep packaging material for proper operation and to move washer later.
4. GROUNDING INSTRUCTIONS
For a grounded, cord-connected...
Owners Manual - Page 8
...valves.
NOTE: Both hoses must be automatically replaced by hand until it over side of laundry...installer to install and secure the drain hose into the provided plumbing/drain in a manner that will avoid the drain hose coming out of the part code mentioned herein will need additional parts with pliers and slide black elbow end of drain hose should be used. Connect Inlet Hoses
Washer...
Owners Manual - Page 10
... the part code mentioned herein will support weight of washer and repeat as needed. Recheck levelness of washer. Electrical Shock Hazard Plug into a grounded 3-prong outlet
10
05-Aug-2019 13:05:14 EDT | RELEASED
In some models). Be sure you have correct electrical supply and recommended grounding method.
� Check that will be automatically replaced by...
Maytag MVWC465HW Reviews
We have not received any reviews for Maytag yet.