Maytag MGD8630HW Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MGD8630HW manuals!
Problems with Maytag MGD8630HW?
Ask a Question
Free Maytag MGD8630HW manuals!
Problems with Maytag MGD8630HW?
Ask a Question
Maytag MGD8630HW Videos
Maytag MGD8630HW Dryer
Duration: :43
Total Views: 28
Duration: :43
Total Views: 28
Maytag MGD8630HW Sécheuse
Duration: :43
Total Views: 8
Duration: :43
Total Views: 8
Popular Maytag MGD8630HW Manual Pages
Owners Manual - Page 4
...www.maytag.ca
4
15" Pedestal Color-matched pedestal raises the dryer to be installed on top of the washer. In Canada, call us at a premium, the stack kit allows the dryer to a more information. Time tested engineering that meets our strict quality specifications.
The large drawer provides convenient storage. ACCESSORIES
INSTALLATION & MAINTENANCE ACCESSORIES
FACTORY CERTIFIED PARTS...
Owners Manual - Page 5
n Using the shortest length of the dryer. Proper venting will be sure to follow the Installation Instructions supplied with cycles that have been starched. See Installation Instructions.
Service calls caused by improper venting are not covered by the warranty and will reduce your drying times and improve your lint screen before each load. n ...
Owners Manual - Page 8
...GUIDE - Uses Medium High heat to dry large loads of heavyweight fabrics.
Uses Low heat to increase energy savings versus Regular cycle by using a slightly lower heat level. Use for optimal energy savings, use Regular. Uses High heat to about 3/4 full.
Large load: Fill the dryer... drying temperature settings.
*On steam models only. Small load: Fill the dryer drum with High...
Owners Manual - Page 9
... the type of fabrics in bold are default settings for drying heavyweight items such as the Government Energy Certification Settings except the Default Temperature Setting of the temperature to reduce light wrinkles from loads left in 5-minute increments. Do not add dryer sheets. Do not overload. CYCLE GUIDE - AirDry
High
Less More Off +Steam
Sensing...
Owners Manual - Page 12
...the Air Only setting or AirDry cycle, depending on the dryer back ledge.
3.
Open dryer door. This includes...be done by a qualified appliance servicer.
Dry unstable dye items inside the dryer cabinet Lint should be sure ...dryer interior.
To use . DRYER CARE
CLEANING THE DRYER LOCATION
Keep dryer area clear and free from items dried on dryer usage.
12 Rest the rear support on model...
Owners Manual - Page 15
...dryer power for service....dryer may take up , or the dryer has not been registered instructions.
CONNECTIVITY
Connection Status
Control Panel Indicator Lights
Dryer is not connected
• Smart Grid (Connected) status indicator is OFF
Dryer... for account setup and dryer registration
up to...Dryer is connected to connect. Dryer is
be unavailable. in standby mode. TROUBLESHOOTING...
Owners Manual - Page 16
... or replace exhaust vent with the floor.
This is minimal, clean exhaust system of the drum for 5-10 minutes.
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/owners (in Canada, www.maytag.ca/owners) for assistance and to vibrate. There may vibrate if not properly installed. Electric dryers use...
Owners Manual - Page 17
... being dried. Long venting will change the amount of dryer cycles requires temperatures above 45ºF (7ºC). See the Installation Instructions. Check that it only once. Use 4" (102 mm) diameter vent material. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/owners (in clothing (usually blue jeans).
Loose dyes...
Owners Manual - Page 18
Allow the dryer to the Installation Instructions for service. Using Timed Dry cycle with the dryer. Select a Sensor cycle with a lower heat setting to the dryer. "L" or "L2" Diagnostic Code There may be a problem with an "F" appears in the dryer too long. Electric dryers use two household fuses or breakers. Refer to complete the cooldown portion of the cycle before cooldown ...
Owners Manual - Page 21
... pay for service or repair of this limitation may have the following components to use inconsistent with electrical or plumbing codes, or correction of https://www.maytag.com/owners.html.
2. Conversion of your retailer about the quality, durability, or need for factory specified parts and repair labor to review the Troubleshooting section of the Use and Care Guide or visit...
Installation Instructions - Page 5
...install Extended Dryer Feet Kit, Part Number 279810. If using a pedestal, you will need 18" (460 mm) to water, weather, or at least 4 ft. (1.22 m) long. LOCATION REQUIREMENTS
Check code requirements. DRYER DIMENSIONS Front view:
Side view: Whirlpool® Models...Optional Equipment (not supplied with dryer): Refer to the dryer must support dryer weight of dryer. If using power supply ...
Installation Instructions - Page 6
... Care Guide.
6 Mobile home installations require: ■■ Metal exhaust system hardware, available for exhaust vent with elbow. For further information, see "Assistance or Service" in mobile homes to order. measurement
NOTE: Most installations require a minimum of the dryer in the top and bottom of gas dryers:
■■ Mobile Home Installation Hold-down Kit Part Number 346764...
Installation Instructions - Page 9
... with the National Fuel Gas Code, ANSI Z223.1. The location should be installed in death, explosion, or fire. Propane Gas Conversion: IMPORTANT: Conversion must be installed within six (6) ft. ... NOTE: Pipe-joint compounds that an individual manual shut-off valve must be easy to the dryer. In the U.S.A.: An individual manual shut-off valve be installed within six (6) ft. (1.8 m) of ...
Installation Instructions - Page 10
... comes out through the rear of the burner Btu rating shown on the pedestal model. Stand the dryer up. Leave enough room to avoid kinking.
■■ Use only ...The dryer must be disconnected from dryer packaging under entire back edge of dryer.
Slide the dryer on cardboard.
2. INSTALL LEVELING LEGS
1.
Screw legs into leg holes by hand - For a garage installation, the...
Installation Instructions - Page 21
...remove hose,
and replace rubber washer
Using pliers, tighten the couplings with new rubber washer.
2. Attach 2 ft. (0.6 m) inlet hose to "Connect Vent." CONNECT INLET HOSE (STEAM MODEL ONLY)
For non-steam models, skip to cold ...by hand until it is seated on the hoses for future reference. The dryer must be connected to reduce the risk of the 2 ft. (0.6 m) inlet hose. Remove old rubber ...
Maytag MGD8630HW Reviews
We have not received any reviews for Maytag yet.