Maytag MGD5630HC Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MGD5630HC manuals!
Problems with Maytag MGD5630HC?
Ask a Question
Free Maytag MGD5630HC manuals!
Problems with Maytag MGD5630HC?
Ask a Question
Popular Maytag MGD5630HC Manual Pages
Installation Instructions - Page 3
... contractor, plumber, or gas fitter qualified or licensed by a qualified installer, service agency, or the gas supplier.
I Installations and repairs must be electrically grounded in accordance with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call your...
Installation Instructions - Page 4
... connections)
1/4" (6 mm) and 5/16" (8 mm) nut driver (recommended)
Level
Pipe-joint compound resistant to 1" (25 mm) or hex-head socket wrench
Wire stripper (direct wire installations)
4
Rubber washer
5' (1.52 m) inlet hose
Parts package is located in dryer drum.
NOTE: Do not use leveling legs supplied with dryer if installing with dryer): ■■ Vent clamps ■■...
Installation Instructions - Page 5
.... Some codes limit, or do not permit, installing dryer in "Parts needed."
■■ Level floor with maximum slope of automatic sensor cycles, resulting in ring terminals or spade terminals with upturned ends.
■■ A UL Listed strain relief. If slope is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. Maytag® Models
IMPORTANT: Do...
Installation Instructions - Page 6
... openings in door are required. Check code requirements. Contact your dealer. Additional installation requirements: This dryer is allowed for mobile home installations.
measurement
NOTE: Most installations require a minimum of installation and servicing.
■■ Additional clearances might be made in your Use and Care Guide. ■■ Special provisions must not...
Installation Instructions - Page 8
...-30R wall receptacle. GROUNDING INSTRUCTIONS
For a grounded, cord-connected dryer: This dryer must be plugged into an appropriate outlet that is properly installed and grounded in a risk of the equipment- epresentative
or personnel if you use Power Supply Cord Replacement Part Number 8529008.
4-wire receptacle (14-30R)
For further information, please reference service numbers located in...
Installation Instructions - Page 9
...dryer is located on the model/serial rating plate for
lengths under 20 ft. (6.1 m) if local codes and gas supplier permit.
■■ If you are using natural gas, do so can be installed in the "Assistance or Service" section of gas in death, explosion, or fire. In the U.S.A.: An individual manual...■■ If your Use and Care Guide. No attempt shall be easy to convert the...
Installation Instructions - Page 10
... a
listed flexible gas connector that comes out through the rear of dryer. Screw in elevation. BURNER INPUT REQUIREMENTS Elevations above 2,000 ft. (610 m):
■■ When installed above 2,000 ft. (610 m) a 4% reduction of cardboard from the floor, depending on the pedestal model. Leave enough room to avoid kinking.
■■ Use only pipe...
Installation Instructions - Page 16
... panel. Connect external ground wire
1. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Now go to connect neutral ground wire and neutral wire
Install the correct strain relief for 3-Wire Connection (Power Supply Cord Shown)
IMPORTANT: You must verify with a qualified electrician that this grounding method is...
Installation Instructions - Page 17
... leak-detection solution.
Correct any leak found.
17 MAKE GAS CONNECTION
(Gas models only)
WARNING
2. Securely tighten all connections by brushing on threads of pipe ...dryer to action of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Closed valve B.
Your connection may be sure there are no kinks. Install...
Installation Instructions - Page 18
.... ■■ Do not install in enclosed walls, ceilings, or...system to seal all governing codes and ordinances. Dryer exhaust must not be used....supported in final dryer location. ■■ Remove excess to keep rodents and
insects from entering the home. ■■ Must be used for best drying performance and to follow these instructions can result in death or fire. Replace...
Installation Instructions - Page 19
... models except long vent), or through the bottom. Bottom exhaust installation
...installation B. Determine vent length and elbows needed for mobile homes:
Exhaust vent must be converted to follow these instructions...Dryer B. The "Vent System Charts" provide venting requirements that will :
■■ Shorten life of
vent material and hood combinations acceptable to determine type of dryer...
Installation Instructions - Page 20
A gas model would be DJAV - XXXXXXXXXX. Install exhaust hood
Install exhaust hood and use of box/louvered hoods will improve venting regardless of length.
2.
Run vent to exhaust hood
Vent must fit over the exhaust hood. Connect vent to dryer location using straightest path possible. Secure vent to seal all joints. Avoid 90° turns...
Installation Instructions - Page 21
...to the coupling can result.
4. Record hose installation or replacement dates on connector.
21 NOTE: Do not... overtighten. Attach washer cold inlet hose to cold water faucet. NOTE: Do not overtighten.
CONNECT INLET HOSE (STEAM MODEL ONLY)
For non-steam models, skip to the cold water faucet using the new inlet hoses (not supplied). The dryer...
Installation Instructions - Page 23
... button has been pressed firmly.
• Dryer is level, make sure all parts are on. ‰‰Check for certain part replacement or repair. The odor will reduce product performance. Be sure vent is not crushed or
kinked.
‰‰Check that the flexible gas line is closed.
Electric Models: ‰‰Plug into an outlet...
Installation Instructions - Page 24
..., and T25 are for models with the two screws removed earlier, as shown.
Replace all parts and panels before servicing. Disconnect wiring from the dryer door before proceeding. Disconnect ...opposite side of dryer door frame with round and square-shaped doors. DOOR REVERSAL (OPTIONAL)
The following instructions are registered trademarks of the dryer. Remove door from dryer
Min. 8" ...
Maytag MGD5630HC Reviews
We have not received any reviews for Maytag yet.