Harman Kardon HK6500 Support and Manuals
Get Help and Manuals for this Harman Kardon item
View All Support Options Below
Free Harman Kardon HK6500 manuals!
Problems with Harman Kardon HK6500?
Ask a Question
Free Harman Kardon HK6500 manuals!
Problems with Harman Kardon HK6500?
Ask a Question
Popular Harman Kardon HK6500 Manual Pages
Owners Manual - Page 2
... an equilateral triangle is intended to alert the user to the terminal which is coloured blue must be connected to the presence of the Harman Kardon HK6500/HK6300 Integrated Amplifier. Keep it in accordance with the following item should be taken into consideration.
The lightning flash with its instructions.
In order to appreciate the full performance of...
Owners Manual - Page 3
... and consult an authorized Harman Kardon service station. Not only may break
the wire.
• If your unit. Place of Installation
Place your unit under this high level of the unit. Avoid installing your unit on sound quality.
■ Phase Correct Loudness
Phase correct loudness is not set to the local voltage, set the selector to the...
Owners Manual - Page 4
...Convenience Receptacles
This unit is provided with the power cord. Check the component's owner's manual to find its lugs. Connecting Other Components
Carefully connect the plugs to the left and ...less than 8 or 4 Ohms depending on the position of your speakers are nominally 4 Ohms, set this switch to the 411 position. SWITCHED: The power to this receptacle is independent of 180 ...
Owners Manual - Page 6
POWER INDICATOR (POWER) When the POWER switch is set at the center.
BASS CONTROL KNOB (BASS) This knob controls the ...or right to this position to actuate simultaneously the two
speaker systems connected to select the desired speaker system(s).
0 0 00
hartan/kardon HK6500
POWER
63- Press
Ex real Pro, ssor
_ Mono El _ Mos
VOLUME
TREBLE
07
BALANCE
TAPE MONITOR
Tape I 5
Tape ...
Owners Manual - Page 7
... CARTRIDGE SELECTOR (Cartridge) This switch selects the gain and input impedance of the amplifier, into a signal processor and back into the amplifier. TAPE MONITOR SELECTOR (TAPE MONITOR)
This selector is used . Video : Select...PHONO input jacks (MM for moving coil type cartridges), and to the VIDEO jack. Set this knob at a minimum level before turning the power on or changing the sound ...
Owners Manual - Page 8
...created without the ground connection. Turn the VOLUMEcontrol knob to the Tuner position. 4. Set the Cartrige selector to the MM position when a
turntable with a MC (moving ... Source position. 5.
Activate the BALANCE control knob or Phase Correct Loudness switch if necessary. 9. Set the TAPE MONITOR selector to broadcast frequency. 6. Turn the VOLUMEcontrol knob to the Source position. ...
Owners Manual - Page 9
...speaker system(s).
3. NOTE: You can be played.
4. The POWER indicator lights up .
2. Set the SPEAKERS selector for other than personal use the headphones connected to the phones jack of copyrighted ...to the TAPE 1 jacks onto the tape in the playback mode.
5.
OPERATIONS
Tape Playback
1. Set the TAPE MONITOR selector to the Tape 1 or Tape 2 position corresponding to the tape deck to...
Owners Manual - Page 10
TROUBLESHOOTING CHECKLIST...connect them correctly. Problem
Cause
Remedy
The POWER indicator does not light up when the POWER switch is pressed.
• The power cord is not set up , but ... wires connected to incorrect operation. Sound quality is poor.
• Input components have with this amplifier.
When playing a turntable, a low-pitched noise ("hum" or "buzz") is heard.
&#...
Owners Manual - Page 11
SPECIFICATIONS
HK6300
Continuous Average Power (FTC) 20-20,000Hz, both channels driven 8 Ohms 4 Ohms
: 60 Watts @ 0.09% THD : 60 Watts @ 0.3% THD
HCC (High-instantaneous Current Capability) : ±38 Amps
Power Bandwidth, at half rated output, :
Harman Kardon HK6500 Reviews
We have not received any reviews for Harman Kardon yet.