GE P2S975SEPSS - 30" Slide-In Dual-Fuel Range Support and Manuals
Get Help and Manuals for this General Electric item
View All Support Options Below
Free GE P2S975SEPSS manuals!
Problems with GE P2S975SEPSS?
Ask a Question
Free GE P2S975SEPSS manuals!
Problems with GE P2S975SEPSS?
Ask a Question
Most Recent GE P2S975SEPSS Questions
Spark Module
Where is the spark module located? How do you remove it?
Where is the spark module located? How do you remove it?
(Posted by feweisensale 9 years ago)
Ge Range Control Panel Not Responding
GE P2S975SEM1ss control panel beeps and says "error turn surface burners off". Problem: I had turned...
GE P2S975SEM1ss control panel beeps and says "error turn surface burners off". Problem: I had turned...
(Posted by Ewassel 10 years ago)
Popular GE P2S975SEPSS Manual Pages
Quick Specs - Page 1
...; Min. For answers to avoid interference with product for current dimensional data.
30" Slide-in Elec.
P2S975SEP
GE Profile™ 30" Dual Fuel Slide-In Gas Range
Dimensions and Installation Information (in inches)
Rear filler strip or backguard are available for these ranges
Note: Door handle protrudes 3" from nearest combustible
surface.
31-1/2
15″23903--11″...
Quick Specs - Page 2
...8 9 9
7 8 4 6 8
P2S975SEP
GE Profile™ 30" Dual Fuel Slide-In Gas Range
Features and Benefits • Dual-fuel Range - Deep recessed cooktop keeps spills, and everything else..., yeast breads, pies and pizzas with a consistent
electric oven to the kitchen
• Model P2S975SEPSS - Self-clean allows you to spare yourself from the trouble and effort it takes to turn the pan
•...
Installation Instructions - Page 1
... under warranty.
WARNING - When the service disconnecting means cannot be the T-handle type.
• A flexible gas connector, when used, must be properly grounded. • Proper installation is NOT covered under the Warranty. Installation Self-Cleaning Dual Fuel Instructions Slide-In Range P2S975
Questions? Observe all
governing codes and ordinances. • Note to improper...
Installation Instructions - Page 2
... cooktop should be reduced by a qualified installer, service agency or the gas supplier. Installation Instructions IMPORTANT SAFETY INSTRUCTIONS
FOR YOUR SAFETY:
WARNING - If the information
in your appliance is installed properly by a qualified electrician. Do not store or use of local codes with the proper voltage and frequency and connected to the range can be avoided.
• Do...
Installation Instructions - Page 3
... through the neutral conductor, follow the instructions in your range must be level and flat (lie on NEW CONSTRUCTION AND FOURCONDUCTOR BRANCH CIRCUIT CONNECTION.
D Island Installation: To provide an optimum installation, the top surface of the Canadian Electrical Code. You can get a copy by a cabinet: Bodyside (Kit JXS77XX). Call GE Answer Center (See page 1) c. Proper adjustments...
Installation Instructions - Page 4
...lifting the oven door off the hinges. This may require a flat blade screwdriver. Rail Guide
Stop
Stop
C Pull forward and remove the drawer.
4 To remove the door:
...drawer until it stops. Installation Instructions PRE-INSTALLATION CHECKLIST (CONT.)
4 CAREFULLY, TILT RANGE TO ACCESS RANGE LEVELING LEGS
Use an adjustable wrench to screw leveling legs out so that support flanges clear top of ...
Installation Instructions - Page 6
Installation Instructions GAS CONNECTIONS
10 MAKING THE CONNECTIONS
3″ 15″
7″
31⁄2″ 12″
A Install a manual shut-off valve in the gas supply line in the system.
Leave it off gas supply before you are finished making connections, be sure that all male threads.
WARNING: Do not use of new range is compatible...
Installation Instructions - Page 9
... terminal
Ground plate (grounding to range)
Ground screw
E Skip to Step...codes. Be certain that the center wire (white/ neutral) is firmly secured (35 to this Step 16 or Step 17 depending on number of wires.
On certain models, the wire will need to be connected to the lower left and the lower right terminal block openings. Installation Instructions
15 4-WIRE POWER CORD INSTALLATION...
Installation Instructions - Page 10
...either closed loop terminals or open-end spade lugs.
• On some models, a filter capacitor may be secured by the anti-tip bracket. To ...range is pulled from the terminal block. The bracket should stop the range within 4 inches. If the range is properly secured by a properly installed anti-tip bracket. Installation Instructions ELECTRICAL CONNECTIONS (CONT.)
17 4-WIRE CONDUIT INSTALLATION...
Installation Instructions - Page 11
... cover the cutout opening until the countertop fully engages the control panel. Installation Instructions INSTALL THE RANGE
20 SLIDE RANGE INTO OPENING
A Position the range in front of the cabinet opening , until the range is within 2″ of engaging the anti-tip bracket.
C Push while lifting the range into the receptacle.
Countertop
Make sure the edge of the countertop...
Installation Instructions - Page 12
Installation Instructions INSTALL THE RANGE (CONT.)
22 REPLACE THE OVEN DOOR
NOTE: The oven door is
resting on each side. C Lift the front of the oven cavity, to the locked position.
D Push the hinge locks up against the front
frame of the drawer and push in until the stops clear the guides. Stop
SPECIAL INSTRUCTIONS IF YOU ARE...
Installation Instructions - Page 13
... seated on .
Electrical shock might result. Make sure to four pins. The burner heads are not interchangeable. Front right burner
Make sure the hole in the burner head assembly is positioned over the burner base and the electrode. Installation Instructions
24 COOKTOP BURNERS
A ASSEMBLE THE BURNERS
CAUTION: The electrode of range Extra large head...
Installation Instructions - Page 14
...the cooktop knob to LITE, the spark igniter makes a series of the electric igniters should be checked after the cooktop and....
Do not use an open flame to check the regulator setting is 14″ W.C. for the burner you are stopped ...gas supply piping system by following the steps below.
a. a. Installation Instructions INSTALL THE RANGE (CONT.)
B CHECK FOR LEAKS Turn the gas supply on ...
Installation Instructions - Page 15
... or between filler kit and the wall. Cooktop
Range Maintop filler (2) #8 screws
B FOR NON-BUILT-IN INSTALLATION (END OF CABINET LOCATION)
When installing the range at the outside rear of the maintop to prevent pots, pans and skillets from damaging the painted parts. Follow the instructions included with the range) or Backguard Kit (JXS32XX or JXS37XX) to...
Installation Instructions - Page 16
...to make sure everything in this guide has been completed. Please see L.P. Installation Instructions INSTALL THE RANGE (CONT.)
26 OPERATION CHECKLIST
...fuel and pressure the cooktop was adjusted for when it left in this range when L.P.
NOTE: Instructions are left the factory.
• When ordering parts, always include the serial number and model number to ensure proper replacement parts...
GE P2S975SEPSS Reviews
We have not received any reviews for GE yet.