Technical Reference
Page 108
...19 to 25cpl) 6.1.1.3 Cutting position from print start position as the TM-U210 without adjusting any original control sources. Therefore the top margin is the same as the TM-U210. D 6.1.1.2 Characters TM-U220 has almost the same character spec as the previous one point left uncut position at right position. (...Type A, B only) 6-2 Notices for Font A, B can print the same contents as the TM-U210. The cpl for the ...
...19 to 25cpl) 6.1.1.3 Cutting position from print start position as the TM-U210 without adjusting any original control sources. Therefore the top margin is the same as the TM-U210. D 6.1.1.2 Characters TM-U220 has almost the same character spec as the previous one point left uncut position at right position. (...Type A, B only) 6-2 Notices for Font A, B can print the same contents as the TM-U210. The cpl for the ...
Technical Reference
Page 115
Character spec TM-U300 (Type A,B, C, D) TM-U220 (Type A,B, D) Character par line (CPI) Font A (9 x 9) 33 cpl ... x 3.1 Kanji (16 x 16) 2.7 x 2.7 2.7 x 2.7 Character configuration Code page 0 to 5 Code page 0 to 8, and 19 to 25cpl) Rev. Therefore, the TM-U220 can be changed by ESC/POS command. (default:22cpl to 26 and code page 16, 17, 18 Note: The character per line for Replacement...mm 5.8 mm TM-U300 TM-U220 (When using 76mm roll paper) These values are reference values Printing area and margins 6.2.1.2 Characters The TM-U220 has almost the same character spec as shown in...
Character spec TM-U300 (Type A,B, C, D) TM-U220 (Type A,B, D) Character par line (CPI) Font A (9 x 9) 33 cpl ... x 3.1 Kanji (16 x 16) 2.7 x 2.7 2.7 x 2.7 Character configuration Code page 0 to 5 Code page 0 to 8, and 19 to 25cpl) Rev. Therefore, the TM-U220 can be changed by ESC/POS command. (default:22cpl to 26 and code page 16, 17, 18 Note: The character per line for Replacement...mm 5.8 mm TM-U300 TM-U220 (When using 76mm roll paper) These values are reference values Printing area and margins 6.2.1.2 Characters The TM-U220 has almost the same character spec as shown in...