Dewalt D55154 Support and Manuals
Get Help and Manuals for this Dewalt item
View All Support Options Below
Free Dewalt D55154 manuals!
Problems with Dewalt D55154?
Ask a Question
Free Dewalt D55154 manuals!
Problems with Dewalt D55154?
Ask a Question
Most Recent Dewalt D55154 Questions
Piston Rings Keep Blowing Out.
I have a Dewalt D55146 air compressor and it wouldnt build pressure. First i replced the inlet check...
I have a Dewalt D55146 air compressor and it wouldnt build pressure. First i replced the inlet check...
(Posted by flowersjason537 9 months ago)
How To Change The Oil For D5514 Compressor
(Posted by jatimreg 2 years ago)
D55154 Air Compressor
My compressor runs, tank pressure gauge says 130, compressor won't cut out and tank has no air
My compressor runs, tank pressure gauge says 130, compressor won't cut out and tank has no air
(Posted by stevenjardine5 3 years ago)
Air Regulator
I am wondering how do I increase the actual reg pressure going to the adjustment knobm
I am wondering how do I increase the actual reg pressure going to the adjustment knobm
(Posted by joeschmidt1019 9 years ago)
Dewalt D55154 Videos
DEWALT D55154 1.1 HP Continuous 4 Gal Electric Wheeled Dolly-Style Air Compressor with Panel
Duration: 3:40
Total Views: 409
Duration: 3:40
Total Views: 409
Popular Dewalt D55154 Manual Pages
Instruction Manual - Page 6
... or call 1-800-4-DeWALT for units with a new air tank.
• The air tank is designed to withstand specific operating pressures. How to prevent it
• Drain air tank daily or after each use compressor to inflate small low pressure objects such as children's toys, footballs, basketballs, etc.
Never attempt to alter the factory set operating pressures.
•...
Instruction Manual - Page 7
...people or animals.
WARNING: Risk from electrocution. See Grounding Instructions under Installation.
• Any electrical wiring or repairs required on air supply to inflate tires can happen
• Your air compressor is connected provides proper electrical grounding, correct voltage and adequate fuse protection.
Like any part of the tire pressure.
How to prevent it
•...
Instruction Manual - Page 8
... Never touch any exposed metal parts on this product should be performed by a DeWALT factory service center or a DeWALT authorized service center.
WARNING: RISK OF Hot surfaces
What can happen
How to prevent it
• Moving parts such as well.
• Attempting to operate compressor with damaged or missing parts or attempting to repair compressor with protective shrouds removed...
Instruction Manual - Page 9
... rized parts.
• Never stand on a roof or other elevated position. Obtain assistance from attempting to prevent accidental movement of the unit.
How to prevent it
• Unsafe operation of your air • Review and understand all
compressor could lead to seri instructions and warnings in...
Instruction Manual - Page 10
... the outlet side of quick connect plugs: Industrial, automotive, and ARO.
lator.
G
Check Valve
When the air compressor is operating, the check
valve (F) is always less
than the pressure switch cut -out pressure setting, the
safety valve (G) will protect against high pressure
by popping out at the same time.
10 Tank Pressure Gauge...
Instruction Manual - Page 11
... pump oil daily,
see Compressor Pump Oil under Maintenance.
If not using as a dolly.
5. Air Compressor Pump
The pump compresses air into place.
3. English
Drain Valve
The drain valve (H) is located at the base
of oil in hand
when installing or disconnecting to prevent hose whip. 1. Motor Overload Protector
This motor has a manual thermal overload protector.
Instruction Manual - Page 12
... and Oil
CAUTION: The compressor was shipped without first adding oil to the crankcase.
Use DeWalt synthetic oil only.
1. NOTE: See Specifications for the electric current.
If these grounding instructions are signs of damage.
4.
Serious damage can result from even limited operation unless filled with all local codes and ordinances.
2. Closely follow Initial Set-up under...
Instruction Manual - Page 13
... the wall or other containers on the compressor are run off the compressor must comply with the National Electrical Code.
• Circuit is equipped with petroleum products, an air line filter for information regarding acceptable noise levels in power loss to the Voltage and Minimum Branch Circuit Requirements under Specifications. These impurities may be met, or if...
Instruction Manual - Page 15
... and when the check valve or a compressor
pump/motor has been replaced.
15 start.
8. Follow Pre-Start Checklist under Installation. Break-in the air tank during
is put into the correct branch circuit receptacle. Maintenance. Ensure safety valve (G) is closed . Check pump oil level, see Checking connect. DeWALT
escape and prevent air pressure build up in Procedure CAUTION: Risk...
Instruction Manual - Page 16
... laws and regulations. Allow air compressor to
servicing. 16 These used parts may contain substances that are periodically replaced. Ensure regulated pressure gauge reads 0 PSI (0 kPa).
3. Water will corrode and weaken the air tank causing a risk of air tank rupture. If not drained, water will condense in Fig. 2). Check pump oil level
X
6. Change pump oil**+
X
Maintenance...
Instruction Manual - Page 18
... the oil drain plug (L).
8.
Always use with DeWALT synthetic compressor oil. 11.
Use only accessories rated equal to or higher than the rating of in draining.)
9. Replace dipstick. Allow ample time for all service calls: Model Number Serial Number Date and Place of any accessory for use identical replacement parts.
18 Ensure On/Off switch is
below lower...
Instruction Manual - Page 19
...certain low level the motor will repair, without...specific warranty information contained either in pressure.
For warranty repair information, call the local company or see website for warranty information.
Duty Cycle: This air compressor pump is capable of purchase. English
Full One Year Warranty
DeWalt heavy duty industrial tools are missing, call 1-800-4-DeWALT for a free replacement...
Instruction Manual - Page 20
Problem
Code
Excessive air tank pressure-safety valve pops off 1,2
Air leaks ...3
Air leaks in air tank or at air tank welds 4
Air leaks between head and valve plate 5
Air leaks from safety valve...6
Knocking Noise...6,16,17
Pressure reading on the regulated pressure gauge drops when an accessory is used 7
Compressor is not supplying enough air to operate accessories 8,9,10,11,12,...
Instruction Manual - Page 22
... by your air compressor, a larger compressor is needed to pump. Replace air hose. Move unit to a dry well ventilated area Clean or replace air intake filter Add DeWALT synthetic compressor oil to operate accessory. See Extension Cords under Maintenance. Contact a DeWALT factory service center or a DeWALT authorized service center. See Compressor Pump Oil under Installation.
Remove...
Instruction Manual - Page 76
... (MAY06) Form No. the array of pyramids on the surface of lozenge-shaped humps on the handgrip; and the array of the tool. the "D" shaped air intake grill; A18226 D55154 Copyright ©2006 DeWALT
The following are trademarks for one or more DeWALT power tools: the yellow and black color scheme;
Dewalt D55154 Reviews
We have not received any reviews for Dewalt yet.