Dewalt D55154 Support Question
Dewalt D55154 Support Question
Find answers below for this question about Dewalt D55154.Need a Dewalt D55154 manual? We have 2 online manuals for this item!
Question posted by stevenjardine5 on February 26th, 2021
D55154 Air Compressor
My compressor runs, tank pressure gauge says 130, compressor won't cut out and tank has no air
Current Answers
Answer #1: Posted by waelsaidani1 on February 26th, 2021 9:11 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,787
Member since:
May 12th, 2013 Points: 19,501,787
Hello here is a video guide on how to diagnose the problem of this machinehttps://www.youtube.com/watch?v=IbW54oU75KA
Related Dewalt D55154 Manual Pages
Instruction Manual - Page 2
...
J. Pump Oil Dipstick
L. Pressure Switch
K. Motor Reset
N. Handle Locking Knobs
Q. Air Tank Pressure Gauge
o
C. Check Valve
G. Pump Oil Drain Plug
M. Air Intake Filter
O. Top Panel for Cargo
IMPORTANT: Always pull handle
up and lock in place before using
as a dolly. Handle
P. Quick Connects
F. English
Air Compressor
Fig. 1
A. Pressure Regulator
E. On/Off...
Instruction Manual - Page 3
CUT-OUT pressure scfm @ 100 psi (689.5 kPa) MOTOR
Volts/Amps/Hertz RPM Minumum Branch Circuit Requirement PUMP OIL CAPACITY
D55154 80 lbs. (36.3 kg) 20.0" (508.0 mm) 18.5" (469.9 mm) 23.0" (584.2 mm) 4.0 (15.1 liters) 95 PSI (.... 2
pump cylnder and head
Outlet Tube
CHECK VALVE
English Specifications
MODEL WEIGHT HEIGHT WIDTH Length Air Tank Capacity (Gallons) APPROX CUT-IN PRESSUre Approx.
Instruction Manual - Page 4
... is normal for electrical contacts within the motor and pressure switch to reduce the risk of of personal injury....severity for safety, operation and maintenance instructions. When using air tools, basic safety precautions should always be required.
•... explosion.
How to prevent it
• Always operate the compressor in a secure location away from these exposures varies, depending on ...
Instruction Manual - Page 5
... a clean, dry well ventilated area. Read and follow the safety instructions provided on top of compressor pump.
• Operate compressor in an open area at least 12" (30.5 cm) away from the air tank. The air stream may contain harmful vapors and poisons.
DANGER: RISK TO BREATHING (Asphyxiation)
What can cause serious injury or death...
Instruction Manual - Page 6
.... Never attempt to explode or fly apart, and could result in serious injury. Attachments & accessories: • Exceeding the pressure
rating of air tools, spray guns, air operated accessories, tires, and other components which control air tank pressure. If air tank develops a leak, replace it
• Oil can leak or spill and could result in fire or breathing hazard;
To...
Instruction Manual - Page 7
... on this product could result in serious injury and property damage.
• Use a tire pressure gauge to check the tires pressure before each use the tire gauge to prevent over inflation.
• Repairs attempted by electricity. NOTE: Air tanks, compressors and similar equipment used properly it
• Always wear certified safety equipment: ANSI Z87.1 eye protection (CAN...
Instruction Manual - Page 8
... in serious injury.
• Any repairs required on compressor during or immediately after operation.
• Do not reach around protective shrouds or attempt maintenance until unit has been allowed to cool. WARNING: Risk from the air hose and air tank before attempting maintenance, attaching tools or accessories. Compressor will remain hot for several minutes after operation.
Instruction Manual - Page 9
... roof or other elevated position. English
WARNING: Risk of Unsafe Operation
What can fall from the air compressor at all times.
• Never defeat the safety fea tures of this manual. WARNING...not operate machine with the
operation and controls of the
air compressor.
• Keep operating area clear of all persons, pets, and obstacles.
• Keep chil&#...
Instruction Manual - Page 10
...side of two tools at its factory set cut -out setting).
This pressure is controlled by popping out at the same time.
10 SAVE THESE INSTRUCTIONS FOR FUTURE USE
Features (Fig. 1)
On/Off Switch
Place this product may contribute to -connect operation makes connections simple and easy.
Tank Pressure Gauge
The tank pressure gauge (B) indicates the reserve air pressure in
pressure.
Instruction Manual - Page 11
...
4.
Ensure regulated pressure gauge reads 0 PSI (0 kPa). 2. Air Compressor Pump
The pump compresses air into the quick connect body (E). Ensure the On/Off switch (A) is in large amounts. AIR INTAKE FILTER The filter... until the compressor has raised the air tank pressure above that required at the base
of the air tank and is used to prevent hose whip. 1. Working air is not ...
Instruction Manual - Page 12
... only.
1. The portable air compressor is properly grounded,
have the installation checked by a qualified
electrician.
12 This plug
R
MUST be properly
grounded. Inspect the plug and cord before each use if there
are not completely understood, or
if in doubt as the
grounded plug. Do not use . Ensure regulated pressure gauge reads 0 PSI (0 kPa...
Instruction Manual - Page 13
...Air tools and accessories that will accept the plug on the product
• in compressed air is not worn
• no longer than 50 feet (15,2 m)
• 12 gauge (AWG) or larger. (Wire size increases as needed. Location
Place the air compressor... on the rubber feet. If any other containers on the compressor are run off the compressor must be necessary to supply any of the power, it is...
Instruction Manual - Page 14
... operation.
Secure cargo to lock handle in place before using unit. Ensure proper footing and use caution when rolling compressor so that the air tank is drained and the unit is reached slowly lower compressor to ground. English
Electrical
Refer to all safety instructions before using as a dolly.
2. Observe extension cord safety instructions if...
Instruction Manual - Page 15
... ON position. Too much air pressure causes a
7.
Move the On/Off switch to desired setting. pressure must never exceed the maximum pressure rating.
Motor will stop when tank pressure reaches
Initial Set-up (Fig. 1)
hazardous risk of bursting. This procedure is required before the air compressor is not responsible for the air tool or device.
3. Some air oper...
Instruction Manual - Page 16
... or humid conditions
Checking Safety Valve (Fig. 1)
Warning: Hot surfaces.
Remove air compressor plug from outlet.
3.
While compressor is performed on the air compressor. Ensure regulated pressure gauge reads 0 PSI (0 kPa).
3. Ensure air tank pressure gauge reads 0 PSI (0 kPa). Drain air tank.
4. These used parts may contain substances that are periodically replaced. Thereafter...
Instruction Manual - Page 17
... drain. Warning: Risk of unsafe operation. Drain air tank daily. Drain water from air tank may contain oil and rust, which may occur, causing air tank rupture or an explosion. When air tank pressure gauge reads 10 PSI (68,9 kPa), rotate valve to filter base. 9. Compressor Pump Oil (Fig. 1)
checking oil Warning: Hot surfaces. Allow compressor to cool prior to servicing.
1. English...
Instruction Manual - Page 18
...Date and Place of the air compressor. Install the oil drain plug. 10. Accessories
Recommended accessories for your tool, please contact DeWALT Industrial Tool Co., 701 East Joppa... air tank.
5.
K
5.
Remove the dipstick (K) from outlet.
4. English
4.
Always use with your local dealer or authorized service center. L
CAUTION: Risk of burn. Remove air compressor plug...
Instruction Manual - Page 19
...LABEL REPLACEMENT: If your air compressor, it is , the air compressor pump should not run , air pressure in any defects due to a certain low level the motor will repair, without charge, any given hour. When the tank pressure drops to faulty materials or workmanship. For warranty repair information, call 1-800-4-DeWALT. Cut-Out Pressure: When an air compressor is capable of your warning...
Instruction Manual - Page 20
... dealer. Problem
Code
Excessive air tank pressure-safety valve pops off 1,2
Air leaks ...3
Air leaks in air tank or at air tank welds 4
Air leaks between head and valve plate 5
Air leaks from safety valve...6
Knocking Noise...6,16,17
Pressure reading on the regulated pressure gauge drops when an accessory is used 7
Compressor is not supplying enough air to operate accessories 8,9,10...
Instruction Manual - Page 22
... Oil under Maintenance. Drain oil and refill pump with DeWALT synthetic compressor oil. Contact a DeWALT factory service center or a DeWALT authorized service center. If it is higher than the CFM or pressure supplied by your air compressor, a larger compressor is wrong length or gauge
21
Loose electrical connections
22
Possible defective motor or starting capacitor
POSSIBLE...
Similar Questions
Piston Rings Keep Blowing Out.
I have a Dewalt D55146 air compressor and it wouldnt build pressure. First i replced the inlet check...
I have a Dewalt D55146 air compressor and it wouldnt build pressure. First i replced the inlet check...
(Posted by flowersjason537 9 months ago)
Dewalt D55168 Air Compressor Not Turning On.
I have a DeWalt D55168 air compressor that is not turning on. The circuit was not tripped. The outle...
I have a DeWalt D55168 air compressor that is not turning on. The circuit was not tripped. The outle...
(Posted by rjmsteen 2 years ago)
Air Regulator
I am wondering how do I increase the actual reg pressure going to the adjustment knobm
I am wondering how do I increase the actual reg pressure going to the adjustment knobm
(Posted by joeschmidt1019 9 years ago)
Dewalt Air Compressor D55146 Manual
Brand new dewalt air compressor model d55146 no air at hose connections, but air pressure on guages?...
Brand new dewalt air compressor model d55146 no air at hose connections, but air pressure on guages?...
(Posted by murphyrt 10 years ago)