Cisco WS-C3750G-48TS-E Support and Manuals
Get Help and Manuals for this Cisco item
This item is in your list!
View All Support Options Below
Free Cisco WS-C3750G-48TS-E manuals!
Problems with Cisco WS-C3750G-48TS-E?
Ask a Question
Free Cisco WS-C3750G-48TS-E manuals!
Problems with Cisco WS-C3750G-48TS-E?
Ask a Question
Cisco WS-C3750G-48TS-E Videos
Popular Cisco WS-C3750G-48TS-E Manual Pages
Hardware Installation Guide - Page 11
...Support C-6 Supported Java Plug-Ins C-7 Java Plug-In Notes C-8 Where to Go Next C-8
Quick Setup By Using the CLI-Based Setup Program D-1 Methods for Accessing the CLI D-2 Accessing the CLI Through Express Setup...to a Power Source D-9 Entering the Initial Configuration Information D-10 IP Settings D-10 Completing the Setup Program D-11
78-15136-02
Catalyst 3750 Switch Hardware Installation Guide
ix
Hardware Installation Guide - Page 14
... contact the Cisco service and support website for assistance: http://www.cisco.com/public/Support_root.shtml. c. d.
Cisco Limited Lifetime Hardware Warranty Terms
3.
Catalyst 3750 Switch Hardware Installation Guide
xii
78-15136-02 Select the language in Adobe Portable Document Format (PDF). Cisco reserves the right to refund the purchase price as the original end user continues...
Hardware Installation Guide - Page 29
..., page 1-2 • Powering On the Switch, page 1-3 • Starting Express Setup, page 1-4 • Configuring the Switch Settings, page 1-9 • Where to Appendix D, "Quick Setup By Using the CLI-Based Setup Program." For quick setup instructions for a standalone switch or a switch stack. Note Express Setup is supported on the rear panel of the switch to the Cisco IOS release label on...
Hardware Installation Guide - Page 32
.... Catalyst 3750 Switch Hardware Installation Guide
1-4
78-15136-02 POST lasts approximately 1 minute. You assign the IP information so that the SYST and STAT LEDs are any devices connected to set up and configure the switch. Caution
Do not start Express Setup until POST has completed. Starting Express Setup
Express Setup is started should receive a DHCP...
Hardware Installation Guide - Page 37
...Setup
Configuring the Switch Settings
Configuring the Switch Settings
The Management Interface field displays VLAN1-Default. Follow these steps to configure your switch.
The host name is limited to which you can start with a number, is configured with Express Setup...15136-02
Catalyst 3750 Switch Hardware Installation Guide
1-9
Enter your password in the System Contact field....
Hardware Installation Guide - Page 38
... switch exits Express Setup mode.
Enter the IP address of your settings.
Enter the Telnet password again in SNMP community strings. Embedded spaces are going to use Telnet to configure Simple Network Management Protocol (SNMP). If you enable SNMP, you have installed the switch in Figure 1-8.
1-10
Catalyst 3750 Switch Hardware Installation Guide
78-15136-02...
Hardware Installation Guide - Page 56
...switches. Internal Power Supply Connector
The internal power supply is powered through the internal power supply.
Cisco RPS Connector
Specific Cisco RPS modes support specific Catalyst 3750 switches: • Cisco RPS 300 (model PWR300-AC-RPS-N1) supports the
Catalyst 3750-24TS, 3750G-24T, 3750G-12S, and 3750-48TS switches. • Cisco RPS 675 (model PWR675-AC-RPS-N1=) supports the Catalyst...
Hardware Installation Guide - Page 57
... pinout information, see the "Connector and Cable Specifications" section on the Cisco RPS 300, refer to -DB-9 female cable. Use the supplied RPS connector cable to connect the RPS to the Cisco RPS 675 Redundant Power System Hardware Installation Guide. You can order a kit (part number ACS-DSBUASYN=) containing that can support six external network devices and provides...
Hardware Installation Guide - Page 71
... a switch fails POST, the System LED turns amber.
Other LEDs are installing the Catalyst 3750-24TS, 3750G-24T, 3750G-24T, 3750G-12S, or 3750-48TS switches, you are green. Warning Attach only the Cisco RPS 300 (model PWR300-AC-RPS-N1) to an AC power outlet.
The MASTR LED is a failure associated with a particular port...
Hardware Installation Guide - Page 104
... manually set the speed and duplex parameters.
If the attached ports do not autonegotiate or that do not support autonegotiation, you can explicitly set ...Set the port speed and duplex parameters on both ends of attached devices. Place the removed SFP module in no linkage. Connecting to operate at the speed of the connection.
3-44
Catalyst 3750 Switch Hardware Installation Guide...
Hardware Installation Guide - Page 111
This chapter describes these topics for troubleshooting problems: • Understanding POST Results, page 4-1 • Clearing the Switch IP Address and Configuration, page 4-2 • Replacing a Failed Stack Member, page 4-7
Understanding POST Results
As the switch powers on, it begins POST, a series of the switch LEDs, see the "LEDs" section on Cisco.com, or the documentation that came...
Hardware Installation Guide - Page 122
... 60 Hz
DC input voltages for RPS 675
+12V @17A
Power consumption
190W, 650 BTUs per hour
Power rating
0.190 kVA
Physical Dimensions
Weight
12.5 lb (5.68 kg)
Dimensions (H x D x W) 2.59 x 11.60 x 17.5 in. (6.59 x 29.46 x 44.45 cm)
Table A-5 Specifications for the Catalyst 3750-48TS Switch
Environmental Ranges Operating temperature Storage temperature Relative humidity Operating altitude...
Hardware Installation Guide - Page 123
...A Technical Specifications
Table A-5 Specifications for the Catalyst 3750-48TS Switch (continued)
Environmental Ranges
DC input voltages for RPS 300
[email protected]
DC input voltages for RPS 675
+12V @8.5A
Power consumption
75W, 256 BTUs per hour
Power rating
0.075 kVA
Physical Dimensions
Weight
9.1 lb (4.1 kg)
Dimensions (H x...-15136-02
Catalyst 3750 Switch Hardware Installation Guide
A-5
Hardware Installation Guide - Page 143
... Java plug-ins are supported both in .
78-15136-02
Catalyst 3750 Switch Hardware Installation Guide
C-7
On Solaris platforms, follow the instructions in the README_FIRST.txt file to install the Java plug-in Windows environments and on Solaris platforms. You can download the plug-ins and installation instructions from this URL: http://www.cisco.com/pcgi-bin/tablebuild...
Hardware Installation Guide - Page 192
... xvi chassis warning, rack-mounting and
servicing E-19 Cisco IP Phones, connecting to 3-45 Cisco RPS
See RPS CiscoView 2-18 CLI 2-18
accessing by using Express Setup D-2 accessing through console port D-3
Cluster Management Suite See CMS
CMS 2-18 accessing your switch C-1 operating systems and supported browsers C-6 requirements C-5 to C-7 supported Java plug-ins C-7
command-line interface...
Cisco WS-C3750G-48TS-E Reviews
Do you have an experience with the Cisco WS-C3750G-48TS-E that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Cisco yet.
Earn 750 points for your review!