Cisco NM-1GE - Syst. 1PORT GE NETWORK MODULE Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco NM-1GE manuals!
Problems with Cisco NM-1GE?
Ask a Question
Free Cisco NM-1GE manuals!
Problems with Cisco NM-1GE?
Ask a Question
Popular Cisco NM-1GE Manual Pages
User Guide - Page 2
...modules in Cisco AVVID Architecture, page 40 • Stacking, page 41 • Flow Control, page 41 • Fallback Bridging, page 42
Layer 2 Ethernet Interfaces
Layer 2 Ethernet Switching Ethernet switch network modules support... Service, page 29 • Maximum Number of the packet. New connections can also be added to provide inline power for Cisco 2600 Series, Cisco 3600 Series, and Cisco ...
User Guide - Page 5
...Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
Switch Virtual Interfaces
A switch virtual interface (SVI) represents a VLAN of problems...type specifications, and security violations. The VLAN corresponds to route traffic, and assign it does not support subinterfaces.... Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
5 and 36-Port Ethernet Switch Module for...
User Guide - Page 8
..., some EtherChannel interfaces are otherwise compatibly configured. As LANs extend to hotels, airports, and corporate lobbies, insecure environments could be physically contiguous or on the same module.
• Configure all interfaces in an EtherChannel to avoid configuration problems:
• All Ethernet interfaces on all modules support EtherChannel (maximum of eight interfaces...
User Guide - Page 9
...service is the only supported authentication server; The authentication server validates the identity of the client. RADIUS operates in a client/server model... (client)
Cisco router with ...module
• Client-the device (workstation) that supports the RADIUS client and 802.1x. it is available in the IEEE 802.1x specification... URL: http://support.microsoft.com/support/kb/articles/Q303...
User Guide - Page 11
...the authentication server.
The switch cannot provide authentication services to the client through the interface.
•...attempting to the network.
16- and 36-Port Ethernet Switch Module for a fixed number of the client. The port starts...replaced with another client, the switch changes the port link state to down , or if an EAPOL-logoff frame is supported in the unauthorized state. Cisco...
User Guide - Page 31
...switch network module can use the class information to the edge of an individual device when handling traffic in your network can construct an end-to-end QoS ...supported on the Fast Ethernet ports. Table 6 summarizes the queues, CoS values, and weights for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
Note Layer 3 IPv6 packets are not overloaded.
Cisco...
User Guide - Page 32
Feature Overview
16- Figure 15 Basic QoS Model
Actions at the egress interface include queueing and scheduling:
• Queueing evaluates the CoS value and determines which to place the packet.
• Scheduling services the four egress queues based on their configured WRR weights.
No support exists for classifying packets at egress
Queuing and scheduling
Based...
User Guide - Page 33
... a different name. When you enter this mode, you further classify it ; and 36-Port Ethernet Switch Module for the traffic by using the service-policy interface configuration command. You implement IP ACLs to act on a specific traffic class by using the access-list global configuration command. The class map defines the criteria used...
User Guide - Page 46
...on IP routing, refer to the Cisco IOS IP Configuration Guide, Release 12.2. • Set up the call agents
For more information on setting up call agents used in your ...supported MIBs by platform and Cisco IOS release, and to download MIB modules, go to the documentation that accompanies the call agents, refer to the Cisco MIB website on Cisco.com at the following URL: http://www.cisco.com...
User Guide - Page 81
... type of the list. It also does not support filtering based on the specific keywords relative to the Cisco IP Command Reference for each protocol, refer to each protocol type. and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Configuration Tasks
Supported parameters can be grouped into these categories: •...
User Guide - Page 108
... module can segment phones into separate logical networks, even though the data and voice infrastructure is physically the same. The voice VLAN feature places the phones into their own VLANs without the need for Voice and Data
For network designs with a mix of Service (CoS) marking. Configuring a Single Subnet for end-user intervention.
Setting...
User Guide - Page 166
... command is disabled. Displays ESWILP filter driver debugging messages. Displays ESWILP SPAN debugging messages. Examples
The following platforms: Cisco 2600 series, Cisco 3600 series, and Cisco 3700 series routers. debug eswilp {dot1x | filtermgr | fltdrv | igmp | port-driver | power-supply | span | switch-pm}
no form of Ethernet switch network module features, use the no debug eswilp...
User Guide - Page 176
... switch cannot provide authentication services to the authorized state ... a port that is supported on an active port ...setting, use the dot1x port-control command in an EtherChannel, an error...a trunk port, an error message appears, and 802...platforms: Cisco 2600 series, Cisco 3600 series, and Cisco 3700 ...Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
dot1x port-control
To enable manual...
User Guide - Page 242
..., Cisco 3600 Series, and Cisco 3700 Series
Glossary
802.1d-IEEE standard for MAC bridges.
802.1p-IEEE standard for queuing and multicast support.
802.1q-IEEE standard for VLAN frame tagging.
802.1x-IEEE standard for user-defined traffic classes. Used for cell relay in fixed-length (53-byte) cells.
DSCP-differentiated services code...
User Guide - Page 244
... voice packets are based on ) of performance for management purposes. A service used for connections in compliance with ITU-T specification H.323. Protocol developed by shutting down selected bridge interfaces. Regarding an Ethernet switch network module, stacking means connecting two Ethernet switch network modules inside a chassis so that they were attached to detect loops and...
Cisco NM-1GE Reviews
We have not received any reviews for Cisco yet.