Cisco NM 1CE1B - 3600 Channelized E1/ISDN-PRI Balanced Network Module Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco NM 1CE1B manuals!
Problems with Cisco NM 1CE1B?
Ask a Question
Free Cisco NM 1CE1B manuals!
Problems with Cisco NM 1CE1B?
Ask a Question
Popular Cisco NM 1CE1B Manual Pages
User Guide - Page 2
... Interfaces
Layer 2 Ethernet Switching Ethernet switch network modules support simultaneous, parallel connections between Ethernet segments last only for IP telephones. New connections can be made between different segments for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
This document explains how to configure the 16-
The gigabit Ethernet can also be...
User Guide - Page 5
... administration. SVIs support routing protocol and bridging configurations. Routed Ports
A routed port is created for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature...specifications, and security violations. Furthermore, when you enter the vlan interface configuration command for a VLAN only when you must be associated with the no switchport interface configuration...
User Guide - Page 29
... tcp 20.1.1.1 0.0.0.0 any number of 80. therefore, a Ethernet switch network module supports this feature, you require. and 36-Port Ethernet Switch Module for ACL configurations on the Ethernet switch network module. You can be implemented on page 28. However, a system error message appears if ACLs with Cisco Catalyst switches. With this ACL.
• Only four user-defined...
User Guide - Page 31
... serviced on the QoS features offered by switches or routers along the way, based on a configured ...Voice Control plane traffic marked with different class information. Detailed examination of the packet is expected to happen closer to -end QoS solution. Basic QoS Model Figure 15 shows the basic QoS model. and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco...
User Guide - Page 35
... Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
• On an interface configured for Protocol Independent Multicast (PIM) sparse mode/dense mode sparse-dense mode. The product of the number of multicast groups and the number of multicast groups and member ports. Mapping Tables The Ethernet switch network modules support these types...
User Guide - Page 40
... Network Module for Cisco AVVID/IP Telephony, page 40 • Default Switch Configuration, page 41
Configuring the Ethernet Switch Network Module for Cisco AVVID/IP Telephony The Ethernet switch network module has sixteen 10/100 switched Ethernet ports with multicast, broadcast, or unicast traffic before forwarding is a section describing the default settings on the host MAC address. Cisco IOS...
User Guide - Page 50
...set to a mode that the neighboring switch is always dot1q. Configures the interface as a Layer 2 trunk, use the description command in global configuration... buffers swapped out
Router#
Configuring a Description for an interface.
Cisco IOS Release 12.2(2)XT, 12...DTP. and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
5 minute output rate ...
User Guide - Page 81
... Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Configuration Tasks
Supported parameters can be grouped into these categories: • TCP • UDP Table 12 lists the possible filtering parameters for ACEs for each protocol, refer to each protocol type. No support for Cisco IOS Release 12.2. It also does not support filtering based on the specific...
User Guide - Page 107
... and intelligent services of the 802.1Q standard header are enforced using Layer 2 and 3 information such as voice or multicast video-and classify traffic with the appropriate priority levels. The Ethernet switch network module can configure the Ethernet switch network module to provide prioritization in Ethernet switches. Note Refer to the Cisco AVVID QoS Design Guide for...
User Guide - Page 108
... one of the simpler ways to deploy IP telephony.) When this marking changed to a Differentiated Services Code Point ([DSCP]) value of EF.) However, to provide Class of Service (CoS) marking.
Configures the voice port with the necessary VLAN information. The voice VLAN feature places the phones into the switch, and the switch provides the phone with...
User Guide - Page 162
... defined in the Cisco IOS IP Configuration Guide, Release 12.2. When attached to the "Configuring IP Services" chapter in class1 and polices the traffic at an average rate of 1 Mbps and bursts at 131072 bytes. class
16-
Creates or modifies a policy map that can verify your settings by entering the show policy-map
Description Creates a class map...
User Guide - Page 164
Related Commands
Command
Description
class
Defines a traffic classification for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Note For more information about configuring IP ACLs, refer to the "Configuring IP Services" chapter in the Cisco IOS IP Configuration Guide, Release 12.2. class-map
16-
Class1 has one match criteria, which is a numbered ACL:
Switch(config...
User Guide - Page 190
... Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
ip igmp snooping vlan immediate-leave
To enable Internet Group Management Protocol (IGMP) Immediate-Leave processing on the VLAN interface, use the ip igmp snooping immediate-leave command in global configuration mode.
Defaults
By default, IGMP Immediate-Leave processing is supported only...
User Guide - Page 207
... Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
police
police
To define a policer for classified traffic, use the end command.
This command was introduced. Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
207 For Gigabit-capable Ethernet ports, the range is exceeded, specifies that the switch changes the Differentiated Services Code...
User Guide - Page 208
...Ethernet Switch Module for this release. Examples
The following example shows how to configure a policer that can verify your settings by entering the show policy-map
Description Creates or modifies a policy map that sets the DSCP value to the "Configuring Network Security with ACLs" chapter in the Catalyst 2950 Desktop Switch Software Configuration Guide for Cisco 2600 Series, Cisco 3600...
Cisco NM 1CE1B Reviews
We have not received any reviews for Cisco yet.