Home » Zanussi » Dishwashers » Zanussi ZDF3023S

Zanussi ZDF3023S Support Question

Find answers below for this question about Zanussi ZDF3023S.
Need a Zanussi ZDF3023S manual? We have 1 online manual for this item!

Zanussi Overview Questions Manuals Reviews Videos Research

Question posted by jogram81 on October 22nd, 2019

Zdf3023s Dishwasher Giving Error Message I60.

Starts normally but error message appears after 20 minutes and machine is overheating. Have replaced temperature control unit to no avail. Pump and water system OK.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on October 22nd, 2019 4:15 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,690

1,100
points

From justanswer.com:

The service manual shows the following as possible causes -

Heating element faulty; intervention of safety thermostats (open);
wiring faulty; NTC sensor (poor thermal contact); insufficient water circulating in the tub; washing pump faulty (impeller stripped); circuit board faulty.

If the issue persists or if you require further advice, you'll have to consult the manufacturer: use the contact information at https://www.contacthelp.com/zanussi/customer-service.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Zanussi ZDF3023S Manual Pages

Product Manaul - Page 2

... a long time, let the water flow until it is not responsible if an incorrect installation and use the appliance where the temperature is to new pipes or pipes...and damages. The appliance has a 13 amp mains plug. Contents Safety instructions 2 Product description 3 Control panel 4 Programmes 4 Options 5 Before first use 5 Daily use the appliance. Safety instructions Before ...

Product Manaul - Page 3

... door. • Dishwasher detergents are wet with the water in hotels, motels ...and other working environments - Farm houses - Staff kitchen areas in household and similar applications such as: - Bed and breakfast type environments. Warning! Risk of injury or suffocation. • Disconnect the appliance from the appliance until the programme is available...

Product Manaul - Page 4

... Prewash 4 Duration (min) 90 - 130 Energy (kWh) 1.1 - 1.7 Water (l) 11 - 22 90 - 100 1.9 - 2.0 20 - 22 168 1.01 12.4 12 0.1 4 www.zanussi.com This indicator ...Normal soil 3) Crockery and cut- This indicator is off while the programme operates. Control panel 1 23 4 1 Programme marker 2 Off position 3 Indicators 4 Display Indicators 8 765 5 Delay button 6 Multitab button 7 Start...

Product Manaul - Page 5

... you can wash a load with normal soil. 4) Use this option only when you start of water and energy consumption for crockery and ... on the dishes and bad odours to : info.test@dishwasher-production.com Write down the product number (PNC) that ... (kWh) Water (l) Fresh soil Wash 65 °C 30 0.8 8 Crockery and cut- If not, adjust the water softener. It gives good washing results...

Product Manaul - Page 6

...3 1 2 12) 12) 6 www.zanussi.com Start a programme to the right level. The water softener neutralises these tablets are applicable to the water hardness in your area. Water hardness German degrees (°dH) 51 - 70 French...water softener Hard water contains a high quantity of minerals that the water softener uses the correct quantity of the products. The dishwasher salt keeps the water...

Product Manaul - Page 7

... time). 5 6 Filling the rinse aid dispenser Caution! Only use dishwasher salt. To prevent it, after you fill it. Manual adjustment 1 2 1 2 Turn the water hard- Other products can come out from the salt container when you fill the salt container, start a programme. 3 4 Put 1 litre of water in setting mode. To confirm the setting, turn the...

Product Manaul - Page 8

...the water tap. 2. tainer. • If the rinse aid indicator is on, fill the salt con- Set and start a...pro- Loading the baskets Refer to the instructions on the control panel. Mix spoons with other cutlery. • Make sure... the appliance is in the upper basket. Using the detergent Caution! Make sure that are dishwasher-safe. • Do not put in the appliance items made of soil. + +...

Product Manaul - Page 9

... control panel: • If the programme duration flashes in compartment (B). play , the appliance is in setting mode. • If the programme duration in the display is not flashing, the appliance is aligned with steps of 1 minute. • Only the indicator of the set programme go off. 9 The countdown starts to decrease with delay start 1. Starting...

Product Manaul - Page 10

...continues from the mains socket. Care and cleaning 1. Close the water tap. • If you start while the countdown operates Press Delay again and again until the... programme duration flashes in operation comes on again. • Let the dishes become cold before you do not deactivate the appliance, after three minutes...

Product Manaul - Page 11

... counterclockwise and remove. Pull apart filter (B) and (C). External cleaning Clean the appliance with water. • - Only use abrasive products, abrasive cleaning pads or solvents. clockwise until ... object. Assemble filters (B) tial position. Warning! Problem The programme does not start or it locks. Possible solution Connect the mains plug. The appliance does not...

Product Manaul - Page 12

... and installed. Make sure that was not applicable for the end of load and soil. Possible solution Close the appliance door. Press Start. Close the water tap and contact the Service. Replace the fuse. Clean the sink spigot. hose is clogged. Possible cause The filters are not clean. The fuse in the baskets...

Product Manaul - Page 13

... you add detergent in gent dispenser. The salt container is aligned with the water hardness in the dispenser before you start a pro- Make sure that the set level of combi detergent tablets. ...the cause. • Try a different brand of the water softener is empty. Whitish streaks and stains or bluish layers on the control panel. gramme. The set level of detergent in your ...

Product Manaul - Page 14

...decrease energy consumption. Environment concerns The symbol on the product or on the control panel. 5. The display shows the setting of the water softener. 4. To confirm the setting, turn the programme knob until the ... dispenser. solar panels, aeolian energy), use the hot water supply to the rating plate. Press Start to the appropriate collection point for the environment and human...