Zanussi ZDC68560W Support Question
Zanussi ZDC68560W Support Question
Find answers below for this question about Zanussi ZDC68560W.Need a Zanussi ZDC68560W manual? We have 1 online manual for this item!
Question posted by alextheofilidis on November 24th, 2013
Error Code 70
What is the problem related to Error 70 for Zanussi tumble dryer ZDC68560W
Current Answers
Answer #1: Posted by Odin on November 28th, 2013 6:47 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Faulty NTC sensor. Details at http://howtomendit.com/answers.php?id=366031.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Zanussi ZDC68560W Manual Pages
Product Manaul - Page 2
... safety information
Sorting and preparing laundry 9 Daily use appliance to dry the following items: Cushions, quilts etc. (these instructions and make sure that have been in the tumble dryer.
• If you have...
or pillows fitted with foam rubber pads should you must not be dried in the tumble dryer.
• Always unplug the appliance after use, cleaning and maintenance.
• Under...
Product Manaul - Page 3
...that it is not pressing or standing on its electrical supply cable.
• If the tumble dryer is placed on a carpeted floor, please adjust the feet in doubt, do not recognise...
• This appliance is designed for which are designed to . Warning! • Risk of the tumble dryer is accessible.
• Fabric softeners, or similar products should be used as specified by the fabric softener...
Product Manaul - Page 4
Environment
The symbol on the product or on its packaging indicates that this product, please contact your local council, your household waste disposal service or the shop where you have no further use for the environment and human health, which could otherwise be caused by
Installation
markings, e.g. >PEPS
Packaging material
The packaging materials are identified by inappropriate waste ...
Product Manaul - Page 5
... 4 Green and Yellow - Ensure that the cut off plug is supplied with the following code:
1 Blue - The plug must be secure over the outer sheath. Removing transport safety ...stray strands of safely. peratures of the appliance in accordance with the letter «E» or by the tumble dryer can reach tem-
Neutral 2 cord clamp 3 Brown - Upon completion there must be taken from the ...
Product Manaul - Page 6
...) as a space-saving washer/dryer stack. The engineer will carry out the door reversal at the top. Please contact your specialist dealer
Installation kit for the required load in the machine. The condensate tank then no longer has to be used to load or unload the laundry, the door can be drained...
Product Manaul - Page 8
...kg all except 8 kg all except
Cottons
Thorough drying of start delay) Child lock
Anticrease guard phase
Error, wrong selection
Before first use
In order to remove any residues which are still to be ironed,... e.g. For thin fabrics which may have been produced during production, wipe the dryer drum with a
Programme chart
damp cloth or carry out a brief drying cycle (ca. 30 min...
Product Manaul - Page 9
..., e.g.
once dried, immediately remove fabrics and place on the type of laundry.
Sorting and preparing laundry
Sorting laundry • Sort by fabric type:
-
easy care shirts, table linen,...in COTTONS programme group.
9 Baby cycle is a special programme for programmes in the dryer straight after spinning; For drying woollen fabrics after drying, as jeans, sweat-shirts,...
Product Manaul - Page 10
... SYNTHETICS programme group.
• Sort by care label: The care labels mean:
Drying in the tumble dryer possible in principle
Drying at normal temperature
Drying at reduced temperature (press DELICATE button!)
Drying in the appliance any wet laundry which is not specified on
Turn the programme selector to any programme.
These fabrics will...
Product Manaul - Page 11
...
Caution!
DELAY START
allows to delay the start and end • cycle interruption • error
TIME
after a standard drying programme, you want to set to 90 mins in between the loading... progress is still damp after setting the Time programme. Door opening and laundry loading
1. Open the door.
2. Load your laundry (do not force it by elapsing dry time on care label with ...
Product Manaul - Page 12
...from forming.)
1. It is situated at intervals during the anti-crease phase. (The laundry should be cleaned after every drying cycle. Caution!
The drying cycles (except from the ...best to detergent residue on laundry forms on
the display. Remove laundry. 4. ture. After each use a damp hand for about one minute.
Never operate the dryer without the lint filter ...
Product Manaul - Page 13
... of the condenser insertion.
2. In this case it is damper than expected when removed from the laundry condenses inside of the small door with a brush and rinse it at the end, it must be...water or cleaning agents may be re-inserted correctly.
Re-fit the reservoir
Important! The laundry is normal for water to ensure efficient
1. The reservoir must be emptied after each ...
Product Manaul - Page 14
... pressed. Press the START PAUSE button.
Turn it to DRUM LIGHT (if available) or to Small laundry volume./Too dry laundry for se- no machine fault. inform local service and quote the error code.
2) follow program recommendation - Dryer not connected to do if ...
Clean the drum inside the drum. Install fine filter and/or snap...
Product Manaul - Page 15
5) only dryers with reference to EN 61121
Machine settings
Setting BUZZER permanent off .
15 The buzzer is by default always off
Implementation
1. Technical data
height x width x depth
...
Product Manaul - Page 16
...The current setting is on conductivity
values of
and hold down for approx. 5 seconds. Your dryer allows you set desired level. Turn the programme selector to those prefixed by the factory could slightly.... To memorize setting press simultaneously the the ANTI-CREASE and
midity of the laundry at the end of the water compared to any programme.
Water contains, a variable quantity 2.
Similar Questions
My Zanussi Tumble Dryer Heater Does Not Work, I Believe It's The Thermostat
Where is the thermostat fixed to be replaced on the drye
Where is the thermostat fixed to be replaced on the drye
(Posted by phillipharmer 2 years ago)
Location Of The Ntc On The Dryer Zdc68560w
hican you please guide me to locate the ntc on this dryermany thanks
hican you please guide me to locate the ntc on this dryermany thanks
(Posted by abbesoumamar 2 years ago)
What Might Be The Problem With My Dryer.
My dryer when put in service mode flashes the LED (red)14 times then (yellow)11 times?it will not do...
My dryer when put in service mode flashes the LED (red)14 times then (yellow)11 times?it will not do...
(Posted by ottoiscool 2 years ago)
Is There A Reset Button On A Zanussi Zdc68560w Dryer
my zanussi condenser tumble dryer dose not heat up
my zanussi condenser tumble dryer dose not heat up
(Posted by linsayhaugen 8 years ago)
Error Code On Zanussi Zdc68560w
Got error code EHO What does this mean? Filter/condenser all clean.
Got error code EHO What does this mean? Filter/condenser all clean.
(Posted by monni47766 9 years ago)