Home » Yamaha » Audio Components » Yamaha AX-396

Yamaha AX-396 Support Question

Find answers below for this question about Yamaha AX-396.
Need a Yamaha AX-396 manual? We have 1 online manual for this item!

Yamaha Overview Questions Manuals Reviews Videos Research

Question posted by saby0009 on August 26th, 2017

Yamaha Ax 396 Switching Problem

Yamaha ax 396 switching off sometimes without load it trip sometime works OK. What's the faulty parts to be replaced as I'm a technician myself

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on August 27th, 2017 9:12 PM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,797

1,100
points

Sounds like the overload protection is cutting in. If the impedance is too low the receiver will try to output too much current and the system will overload.

Related Yamaha AX-396 Manual Pages

Owner's Manual - Page 3

... (8Ω) RMS Output Power, 0.019% THD, 20-20,000 Hz AX-396 60W + 60W (8Ω) RMS Output Power, 0.019% THD, 20-20,000 Hz ⅷ Highly Dynamic Power, Low Impedance Drive Capability ⅷ Continuously Variable LOUDNESS Control ⅷ CD/DVD DIRECT AMP Switch Used to Reproduce the Purest CD and DVD Sound ⅷ...

Owner's Manual - Page 4

...plug fitted. WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to use this unit for any audio equipment to the AC outlet on the front panel...coloured markings identifying the terminals in your dealer. 4. This state is faulty. 10. Never pull the wires themselves. 5. YAMAHA will rise rapidly; For U.K. SPECIAL INSTRUCTIONS FOR U.K. If this unit ...

Owner's Manual - Page 5

...leaked material and contact with new ones. otherwise, the remote control may not work properly. Replace both batteries with clothing, etc. Notes ● The area between the remote ... AUX Remote control sensor Within approximately 6 m (19.7 feet) 30° 30° Battery replacement If you should begin by sliding it in particular, an inverter type fluorescent lamp; Insert the batteries...

Owner's Manual - Page 6

...this unit and other components after all connections ...SWITCHED l00W MAX. Also refer to page 5 for audio/video units except speakers. ● The output (or input) terminals of signals. MD recorder, etc. Speakers B 123 * * * , , : Refer to the owner's manual for each of your components. ● Use RCA type pin plug cables for descriptions. : Indicates the direction of YAMAHA audio...

Owner's Manual - Page 7

...SWITCHED) (Europe, China and General models 3 SWITCHED OUTLETS (U.K. If these to connect the power cords of components) that the + and - If you use ) Connecting the ground wire of the speaker wires are faulty, no sound will be connected to the SWITCHED... damaged. Rear panel parts 1 * IMPEDANCE SELECTOR switch WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power...

Owner's Manual - Page 8

... 1 23 4 5 7 STANDBY POWER ON OFF NATURAL SOUND STEREO AMPLIFIER AX-496 AUX MD TAPE CD/DVD TUNER PHONO STANDBY/ON PHONES SPEAKERS A B ON OFF...l6 20 l2 28 8 40 4 60 2 0 -dB 8 90 A B C DE F G AX-396 1 23 4 6 7 STANDBY POWER ON OFF NATURAL SOUND STEREO AMPLIFIER AX-396 AUX MD TAPE CD/DVD TUNER PHONO STANDBY/ON PHONES SPEAKERS A B ON OFF BASS l 0l 2 ...

Owner's Manual - Page 9

...set both ) inward (ON) for details.) Press this switch again to cancel this function. 6 TAPE MONITOR and indicator AX-396 only Press this switch to use . The selected source will be selected with ... balance of the currently selected input source lights up. 5 PURE DIRECT and indicator AX-496 only Press this switch, and the indicator above it lights up. G VOLUME Turn this knob to compensate...

Owner's Manual - Page 10

... the POWER switch on this unit consumes a very small quantity of power to receive infrared-signals from the remote control. 2 Input selector keys Press a key to turn it into the standby mode. Press these keys to those components. E) of the main unit. VOLUME + For Control of the keys to control other YAMAHA components are...

Owner's Manual - Page 11

...TAPE MONITOR to release it outward (OFF). English OPERATION Ⅵ Playing a source 5 8 4 8 STANDBY AX-496 PURE DIRECT AX-396 TAPE MONITOR 2 3 STANDBY POWER ON OFF STANDBY/ON AUX MD TAPE CD/DVD TUNER PHONO PHONES SPEAKERS A ...BALANCE, LOUDNESS controls or the CD/DVD DIRECT AMP switch (or PURE DIRECT switch for AX-496 only). (Refer to the "∞" position. 2 Press POWER...

Owner's Manual - Page 12

... with the INPUT selector will not affect the recording. VOLUME + E-10 l6 20 28 l2 8 40 4 60 2 0 -dB - + - Ⅵ Recording a source to tape (or MD) AX-496 3, 5, 6 STANDBY POWER ON OFF STANDBY/ON AUX MD TAPE CD/DVD TUNER PHONO PHONES SPEAKERS A B ON OFF BASS l 0l 2 2 3 3 4 5 4 5 TREBLE l 0l 2 2 3 3 4 5 4 5 BALANCE l 0l 2 2 3 3 4 L5...

Owner's Manual - Page 13

... copyright laws. Notes on recording ● The VOLUME, BASS, TREBLE, BALANCE, LOUDNESS controls and CD/DVD DIRECT AMP switch (and PURE DIRECT switch for recording, you want to check the sound output. English AX-396 14 STANDBY POWER ON OFF STANDBY/ON AUX MD TAPE CD/DVD TUNER PHONO PHONES SPEAKERS A B ON OFF BASS...

Owner's Manual - Page 14

... counterclockwise to turn it lights up . E-12 WARNING If the CD/DVD DIRECT AMP switch (or PURE DIRECT switch for AX-396 only), and then sent to the audio signals. The indicator above it on , only the CD/DVD DIRECT AMP switch will suddenly increase and may damage your ears or the speakers. (The LOUDNESS control...

Owner's Manual - Page 15

... PURE DIRECT switch for AX-496 only) is off the CD/DVD DIRECT AMP switch. Replace the batteries with the INPUT selector. English TROUBLESHOOTING Refer to the chart below do not help, disconnect the power cord and contact your authorized YAMAHA dealer or service center. This unit does not work . The remote control does not work normally...

Owner's Manual - Page 16