Whirlpool WTW8200YW Support Question
Whirlpool WTW8200YW Support Question
Find answers below for this question about Whirlpool WTW8200YW.Need a Whirlpool WTW8200YW manual? We have 4 online manuals for this item!
Question posted by unicorn927 on January 20th, 2013
The Washer Is Not Draining The Pump Is Working. Buy, The Water Will Not Drain.
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Whirlpool WTW8200YW Manual Pages
Installation Guide - Page 2
....
Tools needed:
Parts supplied (located in the washer basket):
Pliers that open to 19/16" (39.5 mm)
Flashlight (optional)
4" min (102 mm)
Adjustable or open-end wrench 9/16" (14 mm)
Wood block
Drain hose form
Cable Tie
Parts needed (Not supplied with washer):
Water inlet hoses (2)
Flat inlet hose washers (4)
Tape measure or ruler
Level
2
Installation Guide - Page 3
... additional parts. To order, please refer to the phone number or website on the back page of your washer in a basement, laundry room, closet, or recessed area.
See "Electrical Requirements."
■■ Hot and cold water faucets located within 4 ft. (1.2 m) of where the power cord is not recommended.
■■ A sturdy floor to...
Installation Guide - Page 4
... separately. install no higher than 41⁄2" (114 mm) of washer. Wall standpipe drain system
41/2" (114 mm) See requirements for a standpipe drain: 2" (51 mm).
install no higher than 96" (2.4 m), you need a sump pump system. Minimum siphon break: 28" (710 mm) from bottom of laundry tub must be plugged into a mating, 3-prong, grounding-type outlet...
Installation Guide - Page 5
IMPORTANT: ■■ Be sure the foam shipping base has been removed from the
bottom of the drain hose helps to avoid water leakage and damage to move the washer in the "Remove Shipping Base and Packing Ring" section. ■■ If foam shipping base has not been removed, be sure lid is necessary...
Installation Guide - Page 6
... into one end of the laundry tub. Coupling B. Do not use old hoses. Clear water lines
Run water for the cold water faucet. For a floor drain, do not install drain hose form. Do not use hoses without washers.
2. IMPORTANT: To keep drain water from going back into the washer: ■■ Do not force excess drain hose into standpipe (shown in...
Installation Guide - Page 7
... in firm contact with cold water inlet valve.
If the washer rocks, minor adjustments may enter washer. Check levelness of the washer and the cabinet.
4.5" 4.5" (114 mm) (114 mm)
4.5" (114 mm)
A
A
A
Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for leaks
Move the washer to level the washer on your washer properly reduces excess noise and...
Installation Guide - Page 8
...water faucets are on.
■■ Check for leaks around faucets and inlet hoses.
■■ Remove film from console and any tape remaining on washer. Dispose of/recycle all packaging materials.
■■ Check that all of your washer...or adjustable wrench to complete one whole cycle.
8 Close lid. Jam nut
When washer is not level, use a 9/16" or 14 mm open -end or ...
Energy Guide - Page 1
...183 kWh
Estimated Yearly Electricity Use
$12
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility rates and use.
• Cost range based only ...visit www.ftc.gov/appliances (P/N W10405151)
Clothes Washer Capacity: Standard
Whirlpool Corporation Models: WTW8200Y*, WTW8240Y*,
WTW8400Y*, WTW8440Y*, WTW8600Y*, WTW8800Y*
Cat. U.S.
Use & Care Guide - Page 3
... or allows time for the load.
For example, you may hear a clicking and hum at all, as with a regular non-HE detergent.
The washer automatically adjusts the water level to produce the right amount of suds for some of the wash cycle, you may hear sounds and noises that more garments should...
Use & Care Guide - Page 4
... being washed.
If you to increase your energy savings on your previous washer provided.
• Even for your fabric.
• Warm and hot water may be added to the washer to start to work with any selected options, will unlock once the washer movement has stopped. press again to pause a cycle.
6 CYCLE SIGNAL BUTTON Use...
Use & Care Guide - Page 7
... separate cycle knob positions for that cycle.
This cycle drains the water and spins at a high speed. Spin speed is adjustable. Items to keep the inside of your washer fresh and clean. Use with AFFRESH® cycle. See "Cleaning Your Washer." After time has expired, washer will drain, but will not spin and a tone will sound...
Use & Care Guide - Page 8
... fabrics.
Synthetics, knits, and corduroy fabrics will pick up lint from lint-givers.
Load laundry into fabric.
• Treat stains promptly.
• Close zippers, fasten hooks, tie strings and sashes. Helpful Tips:
• When washing water-proof or water-resistant items, load evenly. NOTE: Always read and follow fabric care labels instructions to...
Use & Care Guide - Page 9
... for information on recommended method of fabric softener based on washer
Liquid chlorine bleach dispenser
Do not overfill, dilute, or ...water washing creates excessive sudsing with liquid chlorine bleach.
9
Then select Fabric Softener option.
The package will likely result in the last rinse. Overfilling dispenser will not dispense correctly. Do not overfill or dilute. Using Laundry...
Use & Care Guide - Page 10
...time. 2. 7. You may be cooler than your previous washer provided.
Select cycle modifiers, if desired
Wash Temp
Suggested Fabrics
Hot Some cold water is left open the lid to set ). Select cycle options.../PAUSE again to avoid odor, reduce wrinkling, and rusting of cycle signal will pump out. NOTE: Always read and follow fabric care labels instructions to avoid damage to your wash...
Use & Care Guide - Page 11
... not interrupt cycle. disconnect and drain water inlet hoses.
2. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are home. IMPORTANT: Do not add detergent to water pressure surge.
Because some water may find laundry product residue leftover in your washer only when you are found.
Unplug washer or disconnect power.
11
Make...
Use & Care Guide - Page 12
... freezing weather, follow WINTER STORAGE CARE directions before moving : 1. Flush water pipes and hoses. Disconnect drain from original shipping materials back inside washer basket.
6. Unplug power cord.
5. Turn on both water faucets. Shut off both water faucets. 2. Keep lid taped until washer is placed in washer or reconnect power. 3. Close lid and place tape over the console...
Use & Care Guide - Page 13
...to washer.
Do not place tape over the center of alignment and cause water to be level. Washer may hear the hum of water for leaks (laundry tubs, drain pipe, water pipes... basket. It may block pump.
Water may not be completely underwater.
Fill hose washers Drain hose connection
Check household plumbing for proper installation:
Washer not level.
Make sure all...
Use & Care Guide - Page 14
... and following detergent directions based on . Press START/PAUSE.
Washer not draining/ spinning, loads are still wet
14
Empty pockets and use HE detergent.
Replace any kinks in pump or between basket and tub, which can restrict water flow.
You may take 2 to 3 minutes before water is normal. Remove several items, rearrange load evenly around...
Use & Care Guide - Page 15
... of load items. Use the recommended cycle for your garment.
Drain hose extends into standpipe farther than traditional top-load washers. Evenly arrange the wet load for proper water supply.
Check for balanced spinning. Energy Star® qualified washers use cooler wash and rinse water temperatures than 4.5" (114 mm).
Make sure hot and cold inlet...
Use & Care Guide - Page 17
... too large. Do not tape over drain opening . See "Installation Instructions". Do not place load items on washer lid prevent it from locking. Homes with low water pressure may be remain in the washer will damage fabrics.
Close the lid to continue. Incorrect dispenser operation
Clogged dispensers or laundry products dispensing too soon.
Liquid chlorine...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Sounds different than my previous washer - Top-load HE washer with Dispensers in Corners
... the sound of water from the washer, the pump may sound different in different homes, depending on how your previous washer. Some noise during wash - These sounds are part of the cycle is drained from the load. This may make a continuous humming with Dispensers in Corners Sounds during wash - How does this washer work differently than... -
The amount of water seems too low - Top-load HE washer with Dispenser Drawer - video
...; Washer is pressed, the washer will first perform a self-test on the lid lock. Top-load HE washer with Dispensers in my Cabrio TM High Efficiency washer. The amount of water seems too low in Corners There is not enough water - How Sensing works and water amount determined: When the Start button is not cleaning laundry... -
Washer will not fill or start - Top-load HE washer with Dispenser Drawer - video
...works and how water level is pressed, the washer will not properly operate with the lid open. Close the washer ...washer will first perform a self-test on ? The washer will make a slight turn on the water and check for draining. As long as a status light is on and off the water and remove the inlet hoses from the water inlet valve screens. Front-load washer Washer...
Similar Questions
Having Trouble Starting It, And When It Starts, Will Not Drain
(Posted by Anonymous-155200 8 years ago)
Whirlpool Washer Wtw8200yw How Much Water Does It Use Per Wash
(Posted by msaletu 9 years ago)
What Is The Difference Between Whirlpool Cabrio Washer Wtw8200yw And Wtw8240yw
(Posted by rizlatim 9 years ago)
Washer Won't Fill With Water
I went to do a load of laundry tonight and the washer wouldn't fill with water. I turned it on the s...
I went to do a load of laundry tonight and the washer wouldn't fill with water. I turned it on the s...
(Posted by sobelps 10 years ago)
How Can I Get Washer To Wash Only In Cold Water It's A Wtw8240yw Whirlpool Washe
I have tried different cycles and set them on cold water and I still get warm or hot water to wash c...
I have tried different cycles and set them on cold water and I still get warm or hot water to wash c...
(Posted by suegenet 11 years ago)