Whirlpool WTW4850XQ Support Question
Whirlpool WTW4850XQ Support Question
Find answers below for this question about Whirlpool WTW4850XQ.Need a Whirlpool WTW4850XQ manual? We have 5 online manuals for this item!
Question posted by gatankjr on May 14th, 2014
Model Wtw4850xq1 Won't Drain Or Spin In The Wash Cycles
My washer seems to work normally during the wash cycle but it is not draining during final spin. The indicator will say done but the clothes will still be wet. There is not any standing water in the tub but the clothes are dripping wet. If i switch over to Drain and Spin it will finally spin and finish.
Current Answers
Answer #1: Posted by Odin on May 14th, 2014 7:02 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See http://www.repairclinic.com/RepairHelp/Washing-Machine-Repair/11-5--V1RXNDg1MFhR/Whirlpool-Washing-Machine-Troubleshooting (first and fourth links).
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WTW4850XQ Manual Pages
Installation Instructions - Page 2
Install your washer to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied:
NOTE: All parts supplied for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
...need:
Overhead sewer
Standard 20 gal. (76 L) 39" (990 mm) tall drain tub or utility sink, sump pump and connectors (available from local plumbing suppliers)
1" (...
Installation Instructions - Page 3
... cord on washer, and water pressure of washer.
Select method you will need .
Recessed area or closet installation
3" (76 mm)
Minimum diameter for winterizing information. Minimum carry-away capacity: 17 gal. (64 L) per minute. Top of standpipe must install higher than 96" (2.44 m) from bottom of washer. (Additional hoses may be needed.)
Laundry tub drain system
Minimum...
Installation Instructions - Page 5
.... 3. Squeeze clamp with pliers and slide black elbow end of laundry tub. For a laundry tub or standpipe drain, go to remove all parts from rear panel. You may need to back of washer.
4.5" (113 mm)
Place hose into standpipe or lay on elbow end of laundry tub. do not force excess hose into standpipe (shown in picture) or...
Installation Instructions - Page 6
... step with a red ring.
Record hose installation or replacement dates for cold water faucet. Check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to hot water faucet. Remove drain hose form (floor drain installations only)
9. Do not use tape or sealants on washer. n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or...
Installation Instructions - Page 8
...water faucets are now installed.
q Read "Washer Use" in your washer, measure 1/2 of normal
recommended amount of /recycle all parts are on some models). Be sure you have correct electrical supply and recommended grounding method. q Remove protective film from back of your tools. 16. Plug into washer... that washer is an extra part, go back through steps to complete full cycle.
8...
Dimension Guide - Page 1
...washer. Minimum siphon break: 28" (710 mm) from bottom of wash tub. Top of 1" (25 mm) on the sides. To order, please see Installation Instructions packed with equivalent air ventilation openings are for walls, doors, and floor moldings.
Add spacing of standpipe must be needed.)
Laundry tub drain...purposes only. Top-Loading Washer
PRODUCT MODEL NUMBERS WTW4900X, WTW5500X, ...
Energy Guide - Page 1
... per therm.
• For more information, visit www.ftc.gov/appliances (P/N W10062936) U.S. Clothes Washer Capacity: Standard
Whirlpool Corporation Model: WTW4850X* Cat. V1as9DYA(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$15 ▼
$10
$71
Cost Range of Similar Models
144 kWh
Estimated Yearly Electricity Use
$10
Estimated Yearly Operating Cost
(when...
Use & Care Guide - Page 3
... washer. This wash system, along with dirty laundry, fill it is normal for some of your load or allows time for clothes to determine the correct water level for the best performance. Follow the manufacturer's instructions to use.
You will be marked "HE" or "High Efficiency." There will hear the motor turn the basket in the "Cycle...
Use & Care Guide - Page 4
... is working properly. See "Cycle Guide" for 3 seconds to thoroughly wet the load. This process may take 20 seconds to pause the cycle and unlock the lid.
It ensures that are available on the type of a cycle. The washer will flash. CONTROL PANEL AND FEATURES
3 2 1
Not all models. The sensing process will unlock briefly before water is added...
Use & Care Guide - Page 5
.... This light indicates that use a spray rinse you need to penetrate the clothes. The lid will hear the motor and agitator moving the load. WASH
You will unlock once the washer movement has stopped. During the first stage of the sensing/wash cycle, water will hear sounds similar to the wash cycle as the tub spins, allowing the rinse water to open...
Use & Care Guide - Page 6
... loads. After time has expired, water will drain, but the washer will use intermittent agitation and soaking. To set in a hurry.
Use this cycle to soak small spots of set a follow-up cycle, select Drain & Spin, add additional detergent and select a cycle based on the care label. High
Use this cycle to wash lightly soiled garments indicating "Machine Washable Silks" or...
Use & Care Guide - Page 7
... the washer basket before adding clothes. IMPORTANT: Follow the manufacturer's instructions to determine the amount of the washer basket, as well. Helpful Tips:
• When washing water-proof or water-resistant items, load evenly.
• Use mesh garment bags to help avoid tangling when washing delicate or small items.
• Turn knits inside out to your laundry
2.
Synthetics...
Use & Care Guide - Page 8
...wash cycle. Pour a measured amount of the rim. MAX FILL
Dilute liquid fabric softener by filling the dispenser with liquid chlorine bleach.
8 Select cycle
IMPORTANT: Do not tightly pack or force items into washer... than 1 cup (250 mL). Do not use more information, see "Cycle Guide". Load laundry into washer.
Then select Fabric Softener Added-Yes option. Items need to move freely ...
Use & Care Guide - Page 9
... or fade
Light soils
Cold
This is the temperature from your tap cold water is very cold, warm water may be cooler than 10 minutes, the water will unlock once the washer movement has stopped. Press START/Pause/Unlock
to begin wash cycle
Press the START/Pause/Unlock button to help dissolve detergent. Unlocking the lid...
Use & Care Guide - Page 10
... product over time. 3. Shut off water supply to washer, to avoid flooding due to cancel the cycle. disconnect and drain water
inlet hoses.
2. Do not use more than recommended amount of replacement on RINSE & SPIN cycle for 3 seconds to water pressure surge. Close washer lid. 4. NOTE: For best results, do not interrupt cycle. If cycle must be interrupted, press START/Pause...
Use & Care Guide - Page 11
... hoses and drain hose inside washer.
If washer will be moved during freezing weather, follow Winter Storage Care directions before moving :
1. Disconnect drain hose from drain system and drain any remaining water into basket opening. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again:
1. Turn on both water faucets. Disconnect and drain water inlet...
Use & Care Guide - Page 12
... during the Drain & Spin cycles. See "What's New Under the Lid." Both hot and cold water faucets must be tight against the basket.
Wash smaller loads to drainpipe or laundry tub.
Noises -
This is added to www.whirlpool.com/help -
Fill hose washers.
Washer not loaded as expected
Not enough water in the washer
Load not completely covered in water. Washer not performing...
Use & Care Guide - Page 13
... add more than cycles with a low spin speed. Select the Drain & Spin cycle to run or fill, washer stops working or wash light remains on (indicating that the washer was unable to determine if load is power to allow the washer to slow or stop the washer.
http://www.whirlpool.com/help -
Press START/Pause/Unlock. Evenly arrange the wet load for correct...
Use & Care Guide - Page 14
... "Cycle Guide" to the inlet valve. Washer is less efficient at rinsing when load is normal.
In Canada www.whirlpool.ca
If you experience
Possible causes
Solution
Washer not performing as recommended.
Check for the fabrics being washed.
The high spin speeds combined with dry items only. Energy Star® qualified washers use cooler wash and rinse water temperatures...
Use & Care Guide - Page 15
.../help - In Canada www.whirlpool.ca
If you experience
Possible Causes
Solution
Washer not performing as expected (cont.)
Not cleaning or removing stains (cont.)
Not using HE detergent or using a Quick Wash cycle, wash only a few items.
Use Super Wash and Normal Heavy cycle for proper fabric softener distribution at the correct time.
Be sure to avoid...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The cycle time is not correct - Front-load washer
... a Delicate, Hand Washables or Quick Wash cycle? Washer not draining, not spinning out water; Front-load washer Cycle time is not correct - Does the number jump to spin out water. The Estimated Time Remaining is based on , the washer is on your load may not be fully rinsed or the water may differ from real cycle time? See: Is "Sud" ... -
Cycle time is not correct - Duet® Steam washer
... break. When using a cycle, temperature or option that displayed. wet loads - If the Whitest Whites cycle, Heavy Duty cycle, Sanitize temperature, or Deep Clean option are more likely to provide your washer may be fully rinsed or the water may stay at the end of the cycle. Front-load washer Washer not draining, not spinning out water; Duet® Do... -
Sounds during wash - Cabrio® washer with Dispensers in Corners
... your load in Corners Sounds during wash cycle. Cabrio® This is a normal part of the basket moving. (6 seconds, 120 KB) Are you can also clang or scrape against the washer basket. Top-load washer Sounds during drain - Metal buckles, snaps or zippers from your particular model. washer with the washer, or use our search feature below...
Similar Questions
Have A Cabrio Model #wtw6300sw1, Serial # Ct407128 Wont Spin Or Drain But Makes
i have a cabrio washing machine MODEL#wtw6300sw1 wont drain or spin but makes lots of noices then it...
i have a cabrio washing machine MODEL#wtw6300sw1 wont drain or spin but makes lots of noices then it...
(Posted by glee7 11 years ago)
Does Not Spin Properly Or Wring Clothes
Loud screeching sound during wash cycle and close never fully wring out during spin cycle
Loud screeching sound during wash cycle and close never fully wring out during spin cycle
(Posted by Amdaniel1 11 years ago)
Spin Cycle Not Performing Properlywwww
the spin cycle does not seem to be operating properly. the clothes are still dripping wet after. pur...
the spin cycle does not seem to be operating properly. the clothes are still dripping wet after. pur...
(Posted by soperjerk 11 years ago)
Whirlpool Washer Top Load Model Wtw4950xw0 Won't Drain Or Spin.
(Posted by cbmarshall 11 years ago)