Whirlpool WRT351SFYM Support Question
Whirlpool WRT351SFYM Support Question
Find answers below for this question about Whirlpool WRT351SFYM.Need a Whirlpool WRT351SFYM manual? We have 4 online manuals for this item!
Question posted by tntorder on March 28th, 2014
Large Gap In The Humidity-controlled Crisper Bins From The Shelve Above
There is a large gap/separation in the humidity-controlled crisper bins from the shelve above which make the bins worthless because there is no seal.
Current Answers
Answer #1: Posted by Odin on March 28th, 2014 8:03 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
It seems you have a defective product. Arrange to return it to the merchant, or phone Whirlpool at 866-698-2538.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WRT351SFYM Manual Pages
Warranty Information - Page 1
... assistance using your major appliance, to replace or repair house fuses, or to refrigerator or freezer product failures.
7. EXCLUSION OF INCIDENTAL AND CONSEQUENTIAL DAMAGES
YOUR SOLE AND...designated service company. You can write to you on the inside wall of the refrigerator compartment.
Have your correspondence. Please keep these limitations and exclusions may not apply to...
Use & Care Guide - Page 1
... PORTE .......... 52 ENTRETIEN DU RÉFRIGÉRATEUR 54 DÉPANNAGE 55 ACCESSOIRES 56 FEUILLE DE DONNÉES SUR LA PERFORMANCE 57 GARANTIE 58
REFRIGERATOR SAFETY
Your safety and the safety of others . This symbol alerts you still need your model and serial number, located on your appliance. W10359300A We...
Use & Care Guide - Page 2
... pieces. Failure to do so can damage the surface of Your Old Refrigerator
WARNING
Suffocation Hazard Remove doors from behind the control panel on ice maker
kit ready models only). Do not wiggle or "walk" the refrigerator when trying to move and install refrigerator. Shelves and covers may not easily climb inside of your old...
Use & Care Guide - Page 3
... so can result in death, explosion, or fire.
Use an outlet that a separate circuit serving only your refrigerator next to a fixed wall, leave a 2" (5.08 cm) minimum space on the model) to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on each side and at the back for ½" (1.25 cm...
Use & Care Guide - Page 4
....
Connect to 3.18 cm) vertical cold water pipe near the refrigerator. Turn OFF main water supply.
IMPORTANT:
■ Make sure it will help keep water away from the drill and normal...hole in the valve.
4. Tighten the pipe clamp screws slowly and evenly so washer makes a watertight seal. Screw compression nut onto outlet end with your cold water supply, the water pressure to...
Use & Care Guide - Page 5
...after "Final Steps."
12-24 Torx®† Head Screw
1. Remove door handle sealing screws.
NOTE: Allow 24 hours to follow the instructions for the appropriate door style...in place while you begin, turn the refrigerator control OFF, unplug
refrigerator or disconnect power. Keep all parts together. Tighten any adjustable door or utility bins from your
water conditions require a second...
Use & Care Guide - Page 6
.... See Graphic 5. Final Steps
1. See Base Grille graphic.
2. Reset the controls. 4. Refrigerator Door 1. Position refrigerator handle on door as shown in the Top Hinge graphic. Freezer Door 1. See...6. Remove door handle sealing screws.
Remove door stop . NOTE: When you are in Graphic 3. 2. Move to make sure that the bottom of refrigerator door
as shown in ...
Use & Care Guide - Page 7
... Hinge Hole Plugs
3
1-1
A
A
A. 12-24 Torx® Head Screws
A
A. Freezer Handle
4
A
7 A. Door Stop
6-1
A
A. Refrigerator Handle C. Center Hinge B. 12-24 Torx® Head Screws
Bottom Hinge
A B
A. Flat-Head Handle Screws B. Door Handle Screw Cover
Door Handle Seal Screw Front
6-2
A 6-3
B
C
A. Style 1-Standard Door
Door Removal & Replacement
Base Grille
A A
A. Door Hinge Hole...
Use & Care Guide - Page 8
... Screws
C. Center Hinge B. 12-24 Torx® Head Screws
Bottom Hinge
A B
A. Refrigerator Handle
C. ¹⁄₄" Setscrew
A
Front View
Side View 6
A. Hinge Pin
Center Hinge
A B
A. Door Stop Screw A B B. Top Hinge Cover (Left Side)
B Hex-Head Hinge
Screws C. Door Handle Sealing Screws
8 Top Hinge D. Freezer Handle
B. ¹⁄₄" Setscrew
9
C. Cup Handle...
Use & Care Guide - Page 9
... be activated and installed at the same time the air filter is already installed at the base of the refrigerator or turn both leveling screws to make sure they close easier, adjust the refrigerator's tilt using a socket or wrench. 3. NOTE: The indicator will easily remember - See the Base Grille graphic in a visible place...
Use & Care Guide - Page 10
...Remove the old status indicator. 3.
Move the dial to the desired number of the refrigerator or freezer compartments. Temperature Controls
For your convenience, the temperature controls are not blocked before the refrigerator has cooled completely, your refrigerator, make sure the controls are located at a time. Wait 24 hours between adjustments for 3 seconds. Dial Recommended...
Use & Care Guide - Page 11
... individual storage needs. It will make it slides beneath the back half of time the refrigerator door is open, and save energy. Shelves and Glass Shelves (on the shelf until it easier... and press up in on some models)
Crisper Drawers
To remove and replace the crisper drawer: 1. Meat Drawer Cover (on some models)
Refrigerator Shelves
(Glass shelves on some models)
To remove and replace ...
Use & Care Guide - Page 12
... shelf supports. Crisper Humidity Control (on some models)
To remove and replace a wire shelf:
1. HIGH (closed paper bag on some models)
To remove and replace a glass shelf:
1. Important information to raise the shelf tabs up and out of fruits and vegetables with skins. ■ Fruit: Wash, let dry and store in refrigerator in each...
Use & Care Guide - Page 13
... around packages. Ice crystals inside a sealed package are positioned within 24 hours (no more information on some models)
To remove and replace the racks/bins:
1. The freezer door must close ...the caddy until the stoppers have condensed, creating ice crystals. Style 1 - Replace the rack/bin by aligning the grooves on the inside the package have been overcome.
2. DOOR FEATURES
Your...
Use & Care Guide - Page 14
...a water filter, after connecting the refrigerator to a water source or replacing the water filter, fill and discard two full containers of ice to the ice storage bin and the dispenser mechanism.
■... covers are removed.
5. See "Using the Control(s)." Press and hold the FILTERS RESET button for use with water that may be avoided, make sure the water softener is operating properly and is...
Use & Care Guide - Page 15
... between both hands, squeeze inward on the sides and
pulling it from the front of the grain to ensure maximum efficiency. Plug in refrigerator or reconnect power.
15 Dial Control
The light bulb is corrosionresistant and not corrosion-proof. Replace the light shield.
5. NOTE: When cleaning stainless steel, always wipe in death...
Use & Care Guide - Page 16
... open ? If the problem continues, call . contraction/expansion of food added?
Plug in the way? Make sure the refrigerator control is working ? Allow several hours for refrigerator to return to enter refrigerator. Push bin or shelf back in the correct
position. ■ Crisper cover in a lamp to its high-efficiency compressor and fans. Plug into a grounded 3 prong...
Use & Care Guide - Page 17
...full ice production.
■ Large amount of low water pressure. ...; Refrigerator connected to your cold water supply? Wash ice bin.
...In Canada, visit our webpage www.whirlpoolparts.ca or call 1-800-901-2042. See "Water Supply Requirements." Ice and Water
The ice maker is an indication of ice recently removed? Wait 24 hours after ice maker installation for ice maker to make...
Use & Care Guide - Page 19
...not installed in accordance with Whirlpool's published installation instructions.
11. Service calls to refrigerator or freezer product failures.
7. DISCLAIMER OF IMPLIED WARRANTIES
IMPLIED WARRANTIES, INCLUDING ANY IMPLIED....
10. Replacement parts or repair labor on the inside wall of the refrigerator compartment.
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your...
Dimension Guide - Page 1
... without notice.
Specifications subject to 414 kPa). It is recommended that a separate circuit serving only your refrigerator be a minimum of Cabinet
"B"
651⁄2" (166.4 cm)
Depth ... your refrigerator has an ice maker, make sure you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
My crisper is stuck/does not close freely
... not close freely My crisper stuck/does not close completely Adjusting crisper humidity control - Replace the drawer into the frame rails, and push it may be necessary to use warm, soapy water and then rinse and dry thoroughly. If the spillover is heavy, it back into the slide control of the crisper bins and cause it is... -
How do I store my refrigerator? - Bottom freezer/French door refrigerator
... then install the water filter. Make sure the refrigerator stays in place to flow. Side by lowering the ice-maker arm. For short vacations or absences (three months or less): Remove all loose items, such as shelves and drawers, by side refrigerator FAQs Knowledgebase search tips Adjusting crisper humidity control - Unplug refrigerator. Thoroughly clean the interior of... -
Sweating/dew in the refrigerator compartment - Top freezer
... end to be blocking the vents. Make sure the air vents between the freezer and refrigerator compartments are designed to hold moisture to keep vegetables fresh. If a humidity control is normal for some sweating or humidity to let moisture out of the crisper. Sweating/dew in the crisper bins Crispers are not blocked. Top freezer Excess...
Similar Questions
Freezer Builds Ice On Wall
Is there a reason or issues that there is ice building up in my freezer
Is there a reason or issues that there is ice building up in my freezer
(Posted by stagiatak 7 years ago)
Moisture Accumulates Under The Top Crisper Bin Glass Shelf
moisture accumulates under the top crisper bin glass shelf
moisture accumulates under the top crisper bin glass shelf
(Posted by dday1814 8 years ago)
Freezer Temperature Control
Where is the temperature control located for the freezer compartment on the Whirlpool WRT351SFYM? Th...
Where is the temperature control located for the freezer compartment on the Whirlpool WRT351SFYM? Th...
(Posted by kevinericguy 10 years ago)
Humidity Control Drawer?
What is part number? Do you have it in stock?
What is part number? Do you have it in stock?
(Posted by tmoco1 10 years ago)
Loud Noise - I Think Coming From Freezer
Hello - we have had the refrigerator for a month and about 5 days ago it started making a loud annoy...
Hello - we have had the refrigerator for a month and about 5 days ago it started making a loud annoy...
(Posted by Anonymous-71701 11 years ago)