Whirlpool WRS965CIAM Support Question
Whirlpool WRS965CIAM Support Question
Find answers below for this question about Whirlpool WRS965CIAM.Need a Whirlpool WRS965CIAM manual? We have 5 online manuals for this item!
Question posted by Flabeachbums on September 12th, 2015
Fridge Problems
The panel display is reading "cooling off" and not dispensing or making ice or dispensing water
Current Answers
Answer #1: Posted by waelsaidani1 on September 12th, 2015 7:34 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
If your refrigerator water dispenser is dispensing either no or slow water, here is what to check to fix it.
http://removeandreplace.com/2015/03/04/refrigerator-water-dispenser-not-working-how-to-fix/
http://removeandreplace.com/2015/03/04/refrigerator-water-dispenser-not-working-how-to-fix/
Answer #2: Posted by TechSupport101 on September 12th, 2015 7:26 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Cooling is toggled on/off by pressing and holding the LOCK and MEASURED FILL buttons at the same time for 3 seconds. Your manual here https://www.helpowl.com/manuals/Whirlpool/WRS965CIAM/173400
Related Whirlpool WRS965CIAM Manual Pages
Installation Guide - Page 2
...8324;" (6.35 mm) copper tubing with any moldings or decorative panels from kitchen cabinets that can happen if the instructions are very ... Contact a qualified electrical installer. Read and follow instructions.
This is installed in this manual and on some models):
■ Your refrigerator dealer has a kit available with...water line connections, you and others are not followed.
Installation Guide - Page 3
NOTE: When leveling legs are shown with the leveling legs extended to the minimum height of the refrigerator is 61¹⁄₄" (155.6 cm) long.
■ The water line attached to the back of ¹⁄₄" (6.35 mm) below the refrigerator, add ³⁄₄" (19 mm) to 1" (25 mm) below the...
Installation Guide - Page 4
... into a recessed
opening, at the end of cabinets or as gasoline, away from the rear of door handle.
Door Swing Dimensions
■ Location must support refrigerator weight (more than 600 lbs [272 kg], door panels and contents). Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as a freestanding...
Installation Guide - Page 5
... 827 kPa) is connected to operate the water dispenser and ice maker. Use an outlet that a separate circuit serving only your refrigerator. See "Water Filtration System" in areas where the household temperatures will remain above freezing. Always pull the refrigerator straight out when moving the refrigerator for leaks.
If the water pressure to the reverse osmosis system is...
Installation Guide - Page 6
... the perimeter in the
following graphic: a ³⁄₄" (19.05 mm) decorative panel, a 1.59 mm) spacer panel or spacer strips, and a ¹⁄₄" (6.35 mm) backer panel. D
D
E
Freezer Door Panel (Dispenser)
Freezer Door Panel (Non-Dispenser)
Refrigerator Door Panel
A
F
G
C
Dispenser cutout is centered left-to avoid dropping.
If you use spacer strips, it...
Installation Guide - Page 7
...67 172.5 cm) 14⁷⁄₈" (37.8 cm) 19¹⁄₂" (49.6 cm)
Spacer Panel 18³⁄₈" (46.7 cm) 30³⁄₄" (78.1 cm) 66 169.1 cm) 14&#... and light gray represents the door panel. 1. Remove the side trim from the top of the lower trim. D
D
E
A
D B
C
C
3. Remove the upper trim from each side trim, making sure the trim clip slides inside ...
Installation Guide - Page 8
... door panels, snap the dispenser frame onto the freezer door as shown. This will work, but the following procedure must be nearly flush with the rivets on the upper trim are properly aligned with the top of the freezer door, completely covering both ends of refrigerator to the water pipe. Turn OFF main water supply...
Installation Guide - Page 9
... nut onto the outlet end with pipe clamp. Connect Water Supply
Read all directions before making the final connection to the inlet of water. 3. A B
C
D
A. Be sure both ends of the refrigerator cabinet as it will go . NOTE: Always drain the water line before you turn the refrigerator on the back of the copper tubing are cut square...
Installation Guide - Page 10
... refrigerator to secure the tubing to make sure that is pushed back against the wall.
5. Turn shutoff valve ON.
6. Unplug refrigerator ...dispensed. Check for leaks. Remove and discard the plastic part that may want to select the maximum ice feature to the valve inlet using the water system. Tube clamp B. If your model, you may contain filterable cysts.
3.
Refrigerator water...
Use & Care Guide - Page 2
... are not problems of California to do so can result in place so that can happen if the instructions are getting rid of your old refrigerator.
■...read and obey all parts and panels before installing ice maker (on ice maker
kit ready models only). ■ Use a sturdy glass when dispensing ice (on some models). ■ Do not hit the refrigerator glass doors (on your old refrigerator...
Use & Care Guide - Page 4
.... 3. Do not induce vomiting. Installing the Status Indicator (on the dispenser panel.
Using the Controls
The refrigerator and freezer controls are made . If swallowed, call a Poison Control ... button will only reactivate the display screen, without changing any control button on skin or clothing.
CAUTION IRRITANT Read cautions on the dispenser control panel will re-enter "sleep" ...
Use & Care Guide - Page 5
...; When adjust mode is activated, the display screen shows the
refrigerator set point and "FRIDGE" appears. ■ Press LOCK to raise the set point, or press OPTIONS to lower
the set point. ■ When you like and when ice cream is desired at least 24 hours between adjustments. When cooling is off . The alarm will...
Use & Care Guide - Page 6
... dairy compartment and can be made within 2 minutes, the display will turn off all control and dispenser sounds, press the
OPTIONS button to exit calibration mode. After reactivation, changes to 0°C). Calibrate Measured Fill
Household water pressure may spurt out of your refrigerator is cooled to avoid "spot" freezing and can rack are made . Place...
Use & Care Guide - Page 7
... the volume to the 1 cup fill line.
1. To dispense water, press a sturdy glass against the water dispenser pad.
Be sure that the container is held for 3 seconds after dispensing has stopped, the digital display will turn off after 1 minute of water, the water pressure to the refrigerator is in order to dispense water to avoid unintentionally overfilling coffee cups.
4. NOTE: The...
Use & Care Guide - Page 8
... to the dispenser light. The dispenser pad lights will turn off power to the refrigerator, to the ice maker, or to select PADS mode. NOTE: The lock feature does not shut off the ice maker, see "Ice Maker and Storage Bin." ■ Press and hold LOCK for a few ounces of the water supplied to a softened water supply.
IMPORTANT...
Use & Care Guide - Page 9
...unknown quality without adequate disinfection before or after the system. Make sure the door is not necessary to turn the ice maker control to the OFF (right) position when removing...be made , the ice cubes will fill the ice storage bin, and the ice cubes will help you know when to change your water filter. ■ When the dispenser control panel's water filter status display
changes to "ORDER,"...
Use & Care Guide - Page 11
... placed on top of the refrigerator
Explosion Hazard
Use nonflammable cleaner. Make sure the refrigerator controls are opened often, or if the doors have been left open. Due to this reduction, you may be sure the dispenser light sensor is not blocked. fans/compressor adjusting to cool completely. flow of refrigerant, water line, or from door. ■...
Use & Care Guide - Page 12
... 72 hours for ice maker to make new ice.
■ Odor transfer from "crushed" to a water supply and the supply shutoff valve turned on the refrigerator? Allow 24 hours for the surrounding conditions? This can reduce water flow. See "Water Supply Requirements." A kink in cuts.
■ Is the ice dispenser stalling while dispensing "crushed" ice? Straighten the water source line.
■...
Use & Care Guide - Page 13
... New installation? Make sure the refrigerator is chilled to only 50°F (10°C). ■ New installation?
See "Water Supply Requirements."
■ Kink in the home water source line? See "Prepare the Water System" or "Water and Ice Dispensers."
■ Recently changed water filter? The dispenser water is not cool enough (on some models)
NOTE: Water from the dispenser is connected...
Use & Care Guide - Page 14
...176;C) 0.5 gpm (1.9 Lpm) @ 60 psi
■ After changing the water filter, flush the water system. See "Water and Ice Dispensers" or "Water Dispenser."
■ These contaminants are subject to red, it is yellow, order... Style 3 - When the filter indicator reads 10%, order a new filter. Style 4 - When the water filter status display changes from yellow to change without adequate ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Ice cubes are hollow/small
... information. Side by side refrigerator No ice production - Make sure your water flow by doing the following items may improve the water pressure: Allow the storage tank for a problem with a water dispenser, you check out. Remove the filter. Dispense water using the water dispenser and note the amount of water flow will result in my ice bin Low ice production - With the... -
Ice cubes are hollow/small - Freezer on Bottom
... is less than 3 ounces, then water pressure is located inside the refrigerator compartment in small ice cubes or low ice production. If the refrigerator has a water dispenser, check for use. Shutoff Valve Make sure the water supply line is cleared from the filter and water dispensing system, and prepare the water filter for a problem with water pressure between 35 and 120 psi... -
No or low ice production - Bottom freezer/French door refrigerator
...; Remove the filter inside the refrigerator compartment in the water source line can reduce water flow. Straighten the water source line. Remove jammed ice using the water dispenser again. No or low ice production - If the refrigerator has a water dispenser, check for a problem with Ice bin in small ice cubes or low ice production. If the ice maker has been running for full...
Similar Questions
Main Panel Display Inoperative
My Refrigerator model GSF26C4EXS is not producing water or ice and the main control board on the fro...
My Refrigerator model GSF26C4EXS is not producing water or ice and the main control board on the fro...
(Posted by Jonschaben 6 years ago)
Model# Gi5fvaxvl01 Display Has No Lights So Ice & Water Not Dispensing
Refrigerator/Freezer are working fine but no lights on display and hence ice and water dispensing ha...
Refrigerator/Freezer are working fine but no lights on display and hence ice and water dispensing ha...
(Posted by shankkothare 6 years ago)
Does The Whirlpool Wrs965ciam Have A Flat Or Curved Dooe
(Posted by RHK328 9 years ago)
Whirlpool Gold Refrigerator Not Making Ice And Water Does Not Work
(Posted by gbmLesl 10 years ago)
Problems Making Ice!
my whirpool ed5vhexvq01 its having problems making ice, its because of the filter or its there some ...
my whirpool ed5vhexvq01 its having problems making ice, its because of the filter or its there some ...
(Posted by giniosorio99 11 years ago)