Home » Whirlpool » Refrigerators » Whirlpool GSF26C4EXS

Whirlpool GSF26C4EXS Support Question

Find answers below for this question about Whirlpool GSF26C4EXS.
Need a Whirlpool GSF26C4EXS manual? We have 4 online manuals for this item!

Whirlpool Overview Questions Manuals Reviews Videos Research

Question posted by Jonschaben on August 20th, 2017

Main Panel Display Inoperative

My Refrigerator model GSF26C4EXS is not producing water or ice and the main control board on the front of the freezer section is dead. I've already installed a new board but unfortunately this didn't solve the issue.I can't find any wiring diagrams to help trouble shoot. I have power to the board on the rear of the unit and power to compressor etc. I don't seem to have any power to the solenoid valves in the bottom right corner but can't trace back to a source to even know if that's my issue. Are there fuses in this system and if so where might they be locatedAny help would be appreciated.Thank you.Jon

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on August 20th, 2017 3:57 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,690

1,100
points

See https://www.repairclinic.com/RepairHelp/Refrigerator-Repair/4-5--R1NGMjZDNEVYUyA=/Whirlpool-Refrigerator-Troubleshooting. The links most likely to solve are listed second, third, fourth, or fifth.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Whirlpool GSF26C4EXS Manual Pages

Owners Manual - Page 1

...Contents / Índice / Table des matières REFRIGERATOR SAFETY 1 INSTALLATION INSTRUCTIONS 2 REFRIGERATOR USE 9 REFRIGERATOR CARE 13 TROUBLESHOOTING 14 ACCESSORIES 16 SEGURIDAD DEL REFRIGERADOR 19 INSTRUCCIONES...INSTRUCTIONS D'INSTALLATION 40 UTILISATION DU RÉFRIGÉRATEUR 48 ENTRETIEN DU RÉFRIGÉRATEUR 53 DÉPANNAGE 54 ACCESSOIRES 56 WATER FILTER ...

Owners Manual - Page 2

... cord. ■ Disconnect power before servicing. ■ Replace all parts and panels before installing ice maker (on ice maker kit ready models only). ■ Use a sturdy glass when dispensing ice (on some models). ■ Do not hit the refrigerator glass doors (on some models). This is heavy. Junked or abandoned refrigerators are not problems of the past. Always pull the...

Owners Manual - Page 3

...wrench, ¹⁄₄" and open to remove the refrigerator and freezer doors. Face of your home, measure the doorway of ... 2 Water Dispenser Tubing Connection A A A. If door removal is necessary, see whether you begin, turn the refrigerator control OFF....before starting installation. Unplug refrigerator or disconnect power. IMPORTANT: Before you need to 90˚...

Owners Manual - Page 4

... base grille will not come off bottom hinge. Remove food, the ice storage bin, and any gaps between the refrigerator, leveler bracket and hinge. Use a hex key to the tube that runs underneath the freezer. Use a hex key to feed the water tubing and wiring through the door hinge, and must only be disconnected...

Owners Manual - Page 5

...to the rear by lifting the door onto the bottom right hinge. 7. Open the freezer door and repeat the previous steps to turn both feet are preinstalled in the handle...the ice storage bin and any adjustable door or utility bins. 9. This makes it stops, then push the smaller ¹⁄₄" (6.35 mm) water tube into its final location. Handle Installation Style 1 - Open the refrigerator ...

Owners Manual - Page 6

...installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the refrigerator ...models have the proper electrical connection. Allow for product installation is important to make sure you move your model) to allow for the water line connections. When installing your refrigerator next to the desired setting. Do not install...

Owners Manual - Page 7

... the water line is recommended. If you have questions about your refrigerator has a water filter, it will remain above freezing. Turn OFF main water supply....water flow to connect the shutoff valve and the refrigerator. ■ Ensure that you turn the refrigerator on the water pipe. IMPORTANT: ■ All installations must meet the water line inlet, which reduces water...

Owners Manual - Page 8

... valve) or nuts that is already installed at the top of ice. This will help avoid damage to maintain a cleaner environment inside the cabinet. On some models, the air filter is attached to the inlet of the refrigerator to secure the tubing to produce the first batch of the refrigerator compartment. 1. Refrigerator water tubing B. Tighten any connections (including...

Owners Manual - Page 9

..." appears on the dispenser panel. either inside the refrigerator, or elsewhere in the previous sections. Adjusting the Controls For your convenience, your kitchen or home. The factory recommended set point. REFRIGERATOR USE Using the Controls The refrigerator and freezer controls are made . When the zone has been changed from white to activate the display screen. When you will appear...

Owners Manual - Page 10

... on for the refrigerator and freezer compartments. When cooling is off. See "Ice Maker and Storage Bin." ■ Press FAST ICE to turn on . The Fast Ice setting will disappear when the feature is off, "COOLING OFF" will appear on the dispenser display screen. Setting the freezer to a colder temperature may make some models) You can control the amount...

Owners Manual - Page 11

... freezer when the dispenser lever is open. ■ Allow 24 hours for 2 minutes or more. To turn off automatically and enter "sleep" mode when the control buttons and dispenser levers have not been used for the refrigerator to cool down and chill water. ■ Allow 24 hours to produce the first batch of ice. Before dispensing ice...

Owners Manual - Page 12

... off power to the refrigerator, to the ice maker, or to the dispenser light. It simply deactivates the controls and dispenser levers. Water softener chemicals (such as the quality of the water supplied to the ON (left ) position. The switch is closed tightly. Pull the covering panel up and out. To restart ice production, push the wire...

Owners Manual - Page 13

...; When the dispenser control panel's water filter status display changes to "ORDER," this tells you need to the other harsh cleaning tools. 1. See "Water and Ice Dispensers." See the "Door Removal" instructions, either in the top-right corner of unknown quality without adequate disinfection before or after the covers are removed. 5. However, clean both sections about once...

Owners Manual - Page 14

... heard when ice melts during the defrost cycle and water runs into a grounded 3 prong outlet. Push bin or shelf back in refrigerator or reconnect power. Unplug refrigerator or disconnect power. 4. Electrical Shock Hazard Plug into the drain pan ■ Creaking/Cracking - Replace the fuse or reset the circuit breaker. See "Using the Controls." ■ New installation? Remove...

Owners Manual - Page 15

... instruction sheet provided with your cold water supply? Be sure the ice bin is not producing ice or not enough ice ■ Refrigerator connected to begin . Temperature and Moisture Temperature is normal. ■ Humid room? Wait 24 hours after ice maker installation for refrigerator to return to normal temperature. ■ Controls set to cool completely. ■ Door...

Owners Manual - Page 16

... 30 psi (207 kPa)? Connect refrigerator to a cold water pipe. See "Water Supply Requirements." ■ Kink in the ice bin? Clean chute and bottom of ice, empty the storage bin and clean both thoroughly. Straighten the water source line. ■ New installation? Use only cubes produced by the current ice maker. ■ Has the ice melted around the auger (metal spiral...

Owners Manual - Page 18

...freezer product failures. 7. Any food or medicine loss due to repair or replace appliance light bulbs, air filters or water filters. This major appliance is intended to be provided by a Whirlpool designated service company. The removal and reinstallation of your complete model number ready. Discoloration, rust, or oxidation of the refrigerator...instructions and/or installation instructions. 2....

Dimension Guide - Page 1

... Open 90° GSF26C4EX GSF26C5EX WSF26C2EX WSF26C3EX WSF26D2EX WSF26D4EX 26.4 cu. When you are for product installation is recommended. handle C top of space behind the refrigerator. Allow for 1⁄2" (1.25 cm) of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer control depending on your refrigerator next to change without...

Warranty - Page 1

...or medicine loss due to repair or replace appliance light bulbs, air filters or water filters. This warranty gives you specific legal rights, and you also may have ...installed in an inaccessible location or is not installed in accordance with original model/serial numbers that have other rights that vary from state to state or province to province. Service calls to refrigerator or freezer...

Energy Guide - Page 1

Refrigerator-Freezer • Automatic Defrost • Side-Mounted Freezer • With Through-The-Door-Ice Service Whirlpool Corporation Models: GSF26C4EX*0*, GSF26C5EX*0* Capacity: 26.4 Cubic Feet Estimated Yearly Operating Cost $63 ▼ $60 $78 Cost Range of Similar Models 587 kWh Estimated Yearly Electricity Use Your cost will depend on your utility rates and use. • Cost ...

Whirlpool Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Why won't my SpeedCook microwave oven with convection operate?
...Is a spacer (on the control panel. See "Learning Mode" section below . The only control that will rotate (if set On). When set, functions can be entered, with real displays and tones, without actually turning...the Cancel pad on some models) attached to use of cold water for two minutes at 100% cooking power. On Settings & Is the electronic oven control set ? If you do...
Temperature Control, French Door with Ice Bin in the Door
... the TEMP button on the dispenser panel. Press the down arrows on the display screen allow you first install your refrigerator and freezer controls are made. Press the up and down arrows are set point. The set point. higher REFRIGERATOR too warm 1° Bottom freezer/French door refrigerator Too cold in Fresh Food Section - French Door with Exterior Dispenser...
The Humidity Control
... four touch pads located on the display screen, not the selection itself. The Humidity Control How do I use my Humidity Control feature? Press only the touch pads next to "Options." On the main menu, press the touch pad next to your selection on either side of my refrigerator - Bottom freezer The control panel is On. Press the touch...