Whirlpool WGD9750WW Support Question
Whirlpool WGD9750WW Support Question
Find answers below for this question about Whirlpool WGD9750WW.Need a Whirlpool WGD9750WW manual? We have 5 online manuals for this item!
Question posted by Anonymous-70783 on August 15th, 2012
Gas Dryer
gas dryer fires up, and burner stays on for aprox. 1 min. and shuts off. It trys to refire and will not. High limit tested ok. Thermal cut-off tested ok. Thermal fuse tested ok. Thermistor tested ok.
Current Answers
Related Whirlpool WGD9750WW Manual Pages
Ventilation Specification - Page 1
... hazards that the owner post, in a prominent location. WARNING
You can happen if the instructions are not followed.
■ If you and others are installing a gas dryer, it is the safety alert symbol. These words mean:
DANGER
You can kill or hurt you are very important. Post the following warning in a prominent...
Ventilation Specification - Page 3
...dryer. IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the dryer.
■ Do not place items exposed to cooking oils in your dryer. The dryer...Gas Code, ANSI Z223.1/NFPA 54. Close supervision of children is necessary when the dryer is used near children.
■ Before the dryer is moving.
■ Do not install or store the dryer ...
Ventilation Specification - Page 4
... the connection of each dryer. International Fuel Gas Code: In the 2003 version, section 614. 3. See the Installation Instructions that the dryer is operated according to be exhausted when installed in confined spaces where specified clearances from the laundry area of these instructions can result in death or fire.
Exhausting the dryer outdoors removes excess heat...
Ventilation Specification - Page 5
...gas dryer models are using. The room venting can be at least 100 CFM.
measure
back pressure from 40 ft [12.2 m] to measure the back pressure. For example, if the Installation Instructions state that have only one dryer unit attached to a single vent system is common in coin-laundry...run cleaned. Dryer - These standards require testing at the connection to the dryer. ■...
Ventilation Specification - Page 6
...on exhaust
system design) G. Main duct F. Outside air source
6
Weighted dampers C. Barometric damper (use depends on each dryer) C.
D
A
F E
B
C
F
F
G
A. 0.6" (15 mm) water column maximum back pressure B....System The vertical system is the horizontal system, in which banks of dryers are all located in high-rise apartments, with a bank of 0.6" (15 mm) water column
back ...
Ventilation Specification - Page 7
... part of the exhaust system) will vary, depending on the system and usage of the dryer. The frequency of these inspections will not open or close completely.
■ After cleaning...of the duct and remove any leaks that are secure.
4. Inspecting the Exhaust System
1. DRYER INSPECTION AND CLEANING
Frequency of Exhaust System Cleaning
Every exhaust system must be inspected periodically and ...
Installation Instructions - Page 3
... this or any electrical switch; do if you smell gas" instructions.
3 WARNING: For your gas supplier from a neighbor's phone. The dryer must be followed to minimize the risk of fire or explosion, or to light any appliance. • Do not touch any other appliance.
- Follow the gas supplier's
instructions.
• If you use gasoline or...
Installation Instructions - Page 4
...)
■ Level
■ Vent clamps
■ Caulking gun and compound (for purchase from the dealer from whom you purchased your dryer.
4 Check that opens to LP gas
(for your dryer. Check existing electrical supply and venting. See "Electrical Requirements" and "Venting Requirements" before starting installation. For further information, please refer to your Use...
Installation Instructions - Page 5
At lower temperatures, the dryer might not shut off at temperatures below 45ºF (7ºC). This can be considered.
■ A level floor with elbow. Some codes limit, or do not permit, installation of the dryer in longer drying times. Steam (Electric or Gas)
A
38" (965 mm)
B
32 9/16" (827 mm)
C
27" (686 mm)
D
52 9/16" (1335...
Installation Instructions - Page 6
...-Steam (Electric or Gas)
A*
1" (25 mm)
1" (25 mm)
B
32 9/16" (827 mm)
31 1/2" (800 mm)
C**
5" (127 mm)
5" (127 mm)
*Required spacing **For side or bottom venting, 0" (0 mm) spacing is allowed. Recommended spacing should be considered. This dryer has been tested for wall, door, and floor moldings.
■ Additional spacing should be required for...
Installation Instructions - Page 7
... spacing
NOTE: Some models are not recommended for Mobile Home Construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH. For gas dryers
■ Mobile Home Installation Kit Part Number 346764.
Mobile home - See "Tools and Parts" section for cabinet installation.
■ For cabinet installation, with stacked washer...
Installation Instructions - Page 9
....
Du Pont De Nemours and Company.
9 Install a shut-off valve. Examples of gas available, contact your home.
GAS DRYER POWER HOOKUP
Gas Supply Requirements
WARNING
Explosion Hazard Use a new CSA International approved gas supply line. If connected to convert the appliance from the gas supply piping
system during pressure testing at pressures greater than 20 ft (6.1 m), use...
Installation Instructions - Page 10
... Test all local codes and ordinances. Do not use pipe-joint compound resistant to whether the dryer is mounted on a pedestal, the gas ...pipe height must be an additional 10" (254 mm) or 15.5" (394 mm) from the gas pipe.
2. A time-delay fuse...death, fire, or electrical shock.
■ 120 Volt, 60 Hz., AC only, 15- Dryer gas pipe
■ The gas pipe ...
Installation Instructions - Page 11
... Exhaust hood must not be connected into the interior of fire, this is recommended to achieve the best drying performance.
Louvered... not be connected or secured with lint. ■ Replace any gas vent, chimney, wall, ceiling, attic, crawlspace, or a concealed... Exhaust vent must be fully extended and supported when the dryer is not plugged with screws or other fastening devices that...
Installation Instructions - Page 13
...people to exhaust hood. Place cardboard under each of the dryer.
■ Reduce performance, resulting in the flexible
gas line. 4. If connecting to connect the exhaust vent. Do not crush or... kink vent. 3. (On gas models) Check that will :
■ Shorten the life of the 2 dryer back corners. NOTE: Do not use a large flat piece of the dryer.
2. Vent system chart
NOTE: Side and...
Installation Instructions - Page 14
...that the water faucets are now installed. If the dryer is plugged into a grounded outlet. Check that all parts are on connector. 6. Gas Models Only: 10. Be sure the water faucets are...outlet and/or electrical supply is connected.
■ Household fuse is intact and tight, or circuit breaker has not tripped.
■ Dryer door is
recommended to the need for leaks around "Y" connector...
Owners Manual - Page 3
...or any other flammable vapors and liquids in your gas supplier. WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance. • Do not ...Gas Code, ANSI Z223.1/NFPA 54. The dryer must conform with the National Electrical Code, ANSI/NFPA 70.
3
IMPORTANT: The gas installation must be followed to minimize the risk of local codes, with local codes, or in the absence of fire...
Owners Manual - Page 5
... and temperature. Press TEMPERATURE until the desired
drying time is displayed. 6. Select a Steam Cycle.
Place laundry in the dryer. Select DRYNESS LEVEL or Option.
3. Select a Manual cycle. 5. Shut the door. 3. Shut the door. 3. Press POWER. 4. To restart the dryer Close the door and press and hold START to persons, read the IMPORTANT SAFETY INSTRUCTIONS before...
Owners Manual - Page 9
... clear and free from items that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may stay in the dryer. As needed cleaning Laundry detergent and fabric softener residue can build up . Dry unstable dye items inside out to remove.
2. This buildup can damage your load is hard to...
Dimension Guide - Page 1
...the ground or any object that may be in the path of the exhaust. A time-delay fuse or circuit breaker and a separate circuit are for planning purposes only. Damage to the coupling can...Required spacing **For side or bottom venting, 0" (0 mm) spacing is required for gas dryers, 30 amp for electric dryers. Do not use the fewest number of elbows and turns. W10255469B 11/2010
Number ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
My gas cooktop doesn't work on my range
...Did you do not have moisture in the search tool below. Is gas coming out of the burners when turned on, but burners will not light? If you experience a power failure or was the...Care Guide instructions. Are the burner knobs turned to ignite The surface burners on my gas range won't operate My gas oven won't operate My gas range cooktop burners are turned to off, you may have... -
My range is not working at all
... your Use and Care Guide. Replace the fuse(s) or reset the circuit breaker(s). If the problem continues, call for gas ranges). Surface burners fail to clear the display. My range ... for electric ranges, 120V receptacle for service. Press OFF to ignite My gas range cooktop burners are not functioning My gas oven won't operate Why is my cooktop not working Look for "Control ... -
My range is not working at all
... a circuit breaker(s) tripped? Replace the fuse(s) or reset the circuit breaker(s). If the problem continues, call for gas ranges). Some ranges may be equipped with Cooktop Control Lock. Surface burners fail to clear the display. Press OFF to ignite My gas range cooktop burners are not functioning My gas oven won't operate Why is my...
Similar Questions
Whirlpool Wed5300sq0 Electric Dryer Heater Element Stays On.
My electric dryer heater element stays on even when the drum stops. It will only go off when the tim...
My electric dryer heater element stays on even when the drum stops. It will only go off when the tim...
(Posted by rcaspland 9 years ago)
My Gas Dryer Model 1cwgd5200vq1 Doesn't Heat Changed Thermal Fuse Still Same Pro
(Posted by rquintana2 11 years ago)
Ultimate Care Ii Dryer Not Working
Whirlpool Ultimate Care II dryer model LEQ8858HQ0--Type DWSR-ELE-2406028-CV54 is not working when pr...
Whirlpool Ultimate Care II dryer model LEQ8858HQ0--Type DWSR-ELE-2406028-CV54 is not working when pr...
(Posted by ajblackerby 11 years ago)
How Do I Order A New Lint Screen ?? I Have A Extended Warranty On My Dryer ?
(Posted by tobeornot121207 11 years ago)