Whirlpool WFW9351YL Support Question
Whirlpool WFW9351YL Support Question
Find answers below for this question about Whirlpool WFW9351YL.Need a Whirlpool WFW9351YL manual? We have 4 online manuals for this item!
Question posted by johntoo388 on February 22nd, 2014
Start/pause Button Not Working
The power in on nad cycle selection done but when the start/pause buttion is press there is no action
Current Answers
Related Whirlpool WFW9351YL Manual Pages
Use & Care Guide - Page 4
... the bottom of choosing a cycle, the washer automatically shuts off .
Spin Speed This washer automatically selects the spin speed based on which cycles include which options. As you do not press START/PAUSE within 5 minutes of the display to select less wash time. It is preset with all models.
See "Cycle Guide" for your load.
3 START/PAUSE BUTTON Press and hold to activate...
Use & Care Guide - Page 5
You may still press START/ PAUSE to pause the cycle, or press the POWER button to turn the washer off.
7 Sanitize (with the same type of heavy ...washer to the wash load at anytime to unload your laundry.
• TumbleFresh™ option is not available if the spin speed is recommended that you the convenience of the cycle for up to activate the EcoBoost™ option. A Release lever Press...
Use & Care Guide - Page 6
... promptly for START/ PAUSE, POWER, and CYCLE SIGNAL. When control lock is locked and cannot be a one-touch way to improve your cycle and temperature selections, the Eco Monitor shows how well you may notice sounds or pauses that cycle to conserve energy and water. Adjust the temperature and spin speed within that are different from traditional washers. TumbleFresh...
Use & Care Guide - Page 7
...Start Heavy Extra Rinse Normal Cycle Signal Light TumbleFresh™
Cycle Details:
Uses more water to gently clean garments and minimize wrinkling.
* All temperature selections feature a cold rinse.
† Allergen Allergen cycle... that this cycle reduced tested allergens by medium wash action and medium-... washer. It can be used with a soak to shorten drying time. This cycle starts...
Use & Care Guide - Page 8
... cannot be interrupted. Use this cycle with
Affresh®
High
Delay Start Extra Rinse Cycle Signal TumbleFresh™ Delay Start Extra Rinse Cycle Signal TumbleFresh™
Delay Start Cycle Signal
Delay Start Cycle Signal
This cycle adds water followed by drain. This cycle should not be used together. See "Cleaning Your Washer." SPECIAL-PURPOSE CYCLES
Settings and options shown in...
Use & Care Guide - Page 9
... to items during the final installation step, choose the Normal cycle and run it firmly until the latch clicks. Load laundry into fabric. Place a load of mold or mildew. Items need to prevent pilling. n W ash small items in the washer. IMPORTANT:
n Empty pockets. Loose change, buttons, or any small object can set stains into...
Use & Care Guide - Page 10
...cycle. This is normal.
3. Add HE detergent to dispenser
HE detergent compartment
Add liquid or powdered HE detergent to dispenser (if desired)
Liquid fabric softener
compartment
Pour a measured amount of water may cause garment damage.
IMPORTANT: Use powdered detergent when using the DELAY START...sure it is selected.
adding too much
detergent may
be dispensed into washer. Do not...
Use & Care Guide - Page 11
...and a new wash cycle started.
11 Press DELAY START until light glows to add them to turn on the washer. Adjust cycle settings, if desired
The display will delay the start the wash cycle. When the door locked light illuminates, the door is illuminated. 2.
To cancel a cycle, press the POWER button. Press START/PAUSE once; Press POWER to the selected cycle.
The countdown to...
Use & Care Guide - Page 12
... sure laundry drum is complete, "Int" (Interrupted) will determine whether clothing or other items are detected in the washer, it to unlock.
9. Do not use abrasive products.
12 NOTE: The basket will rotate, then the door will unlock, lock again, and then the cycle will unlock. If START/ PAUSE or POWER is pressed before a new cycle can begin...
Use & Care Guide - Page 13
Press down area thoroughly with a dry cloth and let the
washer interior air dry with door open.
b) Wipe the seal area with a clean towel. IMPORTANT: Wear rubber gloves when cleaning for stained areas. Replace the insert.
7. CLEANING THE DOOR SEAL
1. Remove the insert (the siphon from the washer...
You may find laundry product residue leftover in washer, then slide dispenser back...
Use & Care Guide - Page 14
... on label with a permanent marker. Reconnect water inlet
hoses. Bundle power cord with transport bolts and in basket and
run washer through NORMAL cycle to mix antifreeze and remaining water. 3. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again: 1.
Shut off water supply to washer to avoid flooding due
to locate, level, and
connect...
Use & Care Guide - Page 15
... items.
Use Heavy Duty or Bulky Items cycle for service. Both hoses must be attached and have water flowing to possibly avoid a service call for oversized, non-absorbent items such as a rug or jacket with floor, and washer must be level.
Press START/PAUSE once to restart washer.
Then press POWER and select Rinse/Drain & Spin if there is...
Use & Care Guide - Page 16
...START/PAUSE. Check that the drain hose is opened during the spin/drain cycles. If you experience
Possible Causes
Solution
Noises
Clicking or metallic noises
Door locking or unlocking.
This is normal to drainpipe or laundry...:
Fill hose washers. Water can restrict water flow.
16
Washer won't run or fill, washer stops working
Check for any kinks in washer drain system. ...
Use & Care Guide - Page 17
...on your load requirements. To remove suds, cancel cycle. Select RINSE/DRAIN & SPIN. Press START/PAUSE.
NOTE: If problems continue, contact an electrician. Do not interrupt cycle. Washer may be completely closed and latched for washer to run or fill, washer stops working (cont.)
Check proper electrical supply. Washer not loaded as expected (cont.)
Washer won't run .
Do not add more water...
Use & Care Guide - Page 18
...any kinks in hoses.
The hose needs an air gap.
Select RINSE/DRAIN & SPIN to both hot and cold water flowing to check ...washer after cycle. The door will not unlock
Door locks when cycle has started. Load not rinsed
Washing many loads.
Washer not loaded as recommended. Move open end drum up with tape.
Check for proper installation. This is lit, press START/PAUSE...
Use & Care Guide - Page 19
...Select a slower spin speed.
Always measure detergent and follow manufacturer's directions based on load size and soil level. Consider using dispensers.
Add only 1 or 2 additional garments after washer has started . Unload the washer... softener staining. See the "Cycle Guide" for load size recommendations for each cycle. Not using liquid detergent. Wash action and/or spin speed too...
Use & Care Guide - Page 20
...Washer" section.
Overfilling causes immediate dispensing. Load dispensers before starting a cycle...cycle has finished.
Undiluted bleach will damage fabrics.
Incorrect dispenser operation
Clogged dispensers or laundry products dispensing too soon.
Wipe up bleach spills.
Use only liquid chlorine bleach in "Washer...water leaks.
To avoid, select a warmer wash temperature if...
Use & Care Guide - Page 21
... automatically starts to the original cycle. The cycle times vary automatically based on your garments without increasing cycle times.
21 The Rapid Wash cycle is detected. cycle time too long
Excessive suds in the "Cycle Guide." The options you select will be out of your garments. Not using the Small Load or Delicate cycles, you experience
Possible Causes
Washer not...
Installation Guide - Page 2
...washers (4)
Alternative Inlet Hoses: (may be required for installation are in the washer basket. Beaded tie strap
Drain hose
Drain hose form and hose clamp
Optional tools:
Transport bolt hole plugs (Quantity will need:
Laundry...Parts needed: (Not supplied with washer)
Tools needed:
Adjustable or open ...washer)
Your installation may require additional parts. INSTALLATION REQUIREMENTS
Tools and ...
Installation Guide - Page 6
....
5. Save transport bolts and spacers. Attach drain hose to back of washer. See Floor drain system under "Alternative Parts". Place power cord over top of hole. Pull bolts and plastic spacers from
washer
6. For a laundry tub or standpipe drain, go to center of washer to allow free access to drain port
Close bolt holes on...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Loads are wrinkled - Dryer
...selected dryness. Both cycles minimize wrinkling by reducing overdrying. dryer does not dry FAQs Knowledgebase search tips Loads are wrinkled - washer...problem. How Auto Dry and Timed Dry Work Are you drying a large load? ...cycle, wrinkles can cause wrinkling, too. A crowded dryer keeps load items from the dryer before removing the laundry items from the washer... -
How do I open the lid?- Top-Load HE with Dispenser Drawer
... in Corners The door will not open the lid?- Press the Power button to open the lid of my Cabrio TM washer? Front-load washer Display shows dU - Are you need to turn the washer off . or Are you started , press Start/Pause/Unlock. This will unlock once washer movement has has stopped. Open lid Display... -
Washer will not fill or start - Top-load HE washer with Dispenser Drawer - video
...-load HE washer with agitator. How Sensing works and water amount determined: When the Start button is determined. You may take 2 to 3 minutes before water is not opened and closed again to start after the last cycle? Do not add more water than 1 or 2 garments after the cycle has started ? Is the washer in a normal pause in heaps...
Similar Questions
Washer Won't Start When I Press The Start Button
I press the start button and I press for 3 seconds, the door locks sometimes. The usual lights come ...
I press the start button and I press for 3 seconds, the door locks sometimes. The usual lights come ...
(Posted by Kkissell 9 years ago)
Whirlpool Washer Wfw9351yl Manual
message comes up could not download manual. How can I get a manual
message comes up could not download manual. How can I get a manual
(Posted by maribob60052 9 years ago)
If The Door Seal On This Model Is Not Sealed, Will The Washer Stop Working?
(Posted by maribob60052 9 years ago)
Duet Wfw9251yw E1 F1 Codes
Duet waster won't start or reset after turning off second load for some quiet. Code reads E1 F1 and ...
Duet waster won't start or reset after turning off second load for some quiet. Code reads E1 F1 and ...
(Posted by nielsen03 11 years ago)
The Pressure Start Button On My Washer Stop Working, The Part Is No Bigger Than
I was told I will have to buy the complete panel at a cost of 260.00 dollars. Sounds excessive
I was told I will have to buy the complete panel at a cost of 260.00 dollars. Sounds excessive
(Posted by rand83010 12 years ago)