Whirlpool WFW862CHC Support Question
Whirlpool WFW862CHC Support Question
Find answers below for this question about Whirlpool WFW862CHC.Need a Whirlpool WFW862CHC manual? We have 4 online manuals for this item!
Question posted by scotthorn40 on February 17th, 2022
Machine Door Won't Lock And Unit Will Not Run
I have a unit that will not lock the door and therefore won't start. is there a way to reset unit?
Current Answers
Related Whirlpool WFW862CHC Manual Pages
Owners Manual 1 - Page 2
... not been used for such a period, before using a washing machine, turn on your appliance, follow instructions. This will be produced ...let the water flow from service or discarded, remove the door.
� Do not reach into the appliance if the...the appliance. All safety messages will follow instructions. Service Personnel - WASHER SAFETY
Your safety and the safety of others . We have not...
Owners Manual 1 - Page 4
...laundry packets, Oxi-type boosters, color-safe bleach, or fabric softener crystals to the bleach compartment. The bulk dispensers will likely result in the last rinse, even if Extra Rinse is selected.
4
IMPORTANT: Do not overfill, dilute, or use thickened, easy-pour, or no-splash bleach when running the Clean Washer...to the high position. Close fill door. It will not dispense correctly. ...
Owners Manual 1 - Page 5
... and detergent accumulate.
3. Open the washer door and remove any clothing or items from the washer.
2.
On some models).
� Do not add single-dose laundry packet to dispenser drawer. IMPORTANT:
� Disable the Load & Go™ option before starting a single load (on the washer inlet valves.
� Use new washers in the new inlet hoses to...
Owners Manual 1 - Page 6
... flash at the end of your washer, you run 30 wash cycles. Open the washer door and remove any items are detected in the washer cabinet and make sure that option. Touch and hold Start/Pause to the
washer when following this initial phase. Description of the Washer
IMPORTANT: To avoid damaging the washer's finish, do not interrupt cycle...
Owners Manual 1 - Page 9
...® Machine Cleaning Wipe. The drawer should be fully engaged and the rails locked in the... Flashlight
Additional Cleaning
Gently pull back the rubber door seal and clean any stained areas, soil buildup...Start Guide for installations are available; Replace and close as close the dispenser drawer. Drain hose with clamp, U-form, and cable tie
Parts Needed: (if not supplied with flat washers...
Owners Manual - Page 6
...This cycle removes excess water from the load or special-care items washed by model. Door Locked
The Door Locked symbol will be unable to a wash cycle.
6 Remove the load promptly for your...cycle is running low, the display will light up to enable the buttons. Additional wash modifiers or options selected after a power failure. Drying (on the washer before touching START/PAUSE.
...
Owners Manual - Page 12
...™ bulk
DRAFT dispenser.
For powdered detergent, lift the selector to lift the fill door.
Add directly to the low position. Add laundry products as described below.
3.
liquid detergent.
Adding HE detergent to the "MAX" line (see the "Washer Care" section.
Fill to dispenser
Load & Go™ bulk dispenser (on dispenser, or enough...
Owners Manual - Page 16
... you touch and hold START/PAUSE for 3 seconds to start the wash cycle. The washer door will hear the door lock. Then close door and touch and hold START/PAUSE to restart the cycle. When unloading garments, pull back the door seal and check for up to reselect cycle and restart. Touch and hold START/PAUSE again to begin wash...
Owners Manual - Page 17
...splash bleach when running the Clean Washer with a damp cloth. U se an affresh® Machine Cleaning Wipe or... door window.
e. Do not add any clothing or items.
b. i. Touch and hold START/...washer door slightly ajar between uses to inspect all interior surfaces of an affresh® Machine Cleaning Wipe. WASHER CARE (cont.)
iii. Let stand 5 minutes. O pen the washer door...
Owners Manual - Page 18
...door window during the steam phase. Close the washer door and the dispenser drawer.
NOTE: The washer remembers your washer to wipe up .
Description of Clean Washer with affresh® Cycle Operation:
1. The Clean Washer... 30 more regular wash cycles. g. Touch and hold START/PAUSE to run the Clean Washer with an affresh® Machine Cleaning Wipe or a damp cloth and towel dry either ...
Owners Manual - Page 20
...The drawer should be fully engaged and the rails locked in the clip. Hose clip
Black hose
3. Then... drained. ADDITIONAL CLEANING
Gently pull back the rubber door seal and clean any stained areas, soil buildup,...will go, with the textured side of the washer/dryer.
Drain pump filter
With your finger, push... at the base of an affresh® Machine Cleaning Wipe.
20 Make sure to insert ...
Owners Manual - Page 21
... generate a high level of detergent to complete, or the error code cannot reset. Unit will not lock) appears in the washer drum that the door is higher than 41⁄2" (114 mm).
Remove any clogs from closing...Causes
Solution
Error Code Appears in washer. When complete, touch POWER once to determine the amount of suds. Make sure the drain hose is running a suds reduction routine.
Owners Manual - Page 22
...® cycle. If code appears again, call . Open and close the door to run 30 wash cycles and is touched
Clean Washer LED flashing at the end of a wash cycle as a reminder.
22
The washer has run the Clean Washer with affresh® cycle. Door not closed for at least three cycles.
After 30 more regular wash...
Owners Manual - Page 23
... at certain stages of the cycle. Washer may make a partial turn and the door will reduce sound. See "Level the Washer" in the housing.
Door locking or unlocking. Empty pockets before washing....a service call for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Remove strainer/stocking from washer" in firm contact with the floor and locked. Avoid tightly packing the load....
Owners Manual - Page 24
..., easy-pour, or no-splash bleach when running the Clean Washer with affresh® cycle. Always measure detergent and follow manufacturer's directions based on door window. Water can drip off the inside of the door when the door is low. Leaking around door
Hair, lint, or other debris on .
Reset a tripped circuit breaker. Plug power cord into...
Owners Manual - Page 25
...cycle has started to continue.
See "Installation Requirements" in Installation Instructions.
25
Washer not draining/ spinning; Door not opened and then closed .
Touch START/PAUSE. ...the end is disabled if you experience
Possible Causes
Washer Not Performing As Expected (cont.)
Washer won't run .
Washer may see condensation on your load requirements.
Only ...
Owners Manual - Page 26
...the best cycle time for assistance and to inlet valve. The door will not unlock Door locks when cycle has started. Both hoses must be attached to both hot and cold ...washer door will unlock at end of hot or warm washes. Inlet valve screens on load size and soil level.
26 Use only HE detergent.
loads are See "Cycle Guide" for the available settings and options for your load. Run...
Owners Manual - Page 28
...wash cycles. Run the Clean Washer with detergent, and slide it between uses.
See the "Washer Care" section.
Items may have tangled. Avoid tightly packing the washer.
Liquid chlorine ... door open after washer has started. Do not overfill the washer. Tie all strings and straps before starting a cycle. See "Washer Care" in pockets during wash cycle. Sharp items were in the "Washer...
Owners Manual - Page 30
... call. Run a high-speed spin cycle. On some models: Clean the drain pump filter.
See "Cleaning the Drain Pump Filter/Draining Residual Water."
Results may also vary depending on load
Area under door seal is clogged with the textured side of an affresh® Machine Cleaning Wipe.
The washer was not removed from washer at...
Owners Manual - Page 31
.... Travel or transportation expenses for appliances with this limited warranty.
1. WHIRLPOOL® LAUNDRY LIMITED WARRANTY
ATTACH YOUR RECEIPT HERE. Some questions can be provided by the use ...warranted by unauthorized service, alteration, or modification of appliance doors. 7. In the U.S. If outside the 50 United States and Canada, contact your retailer about the quality,...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Using the delay start on my dishwasher
... To delay the start the cycle, press Start/Resume. My dishwasher is not latched. Press Start/Resume. If the door is unlatched, the Start/Resume indicator flashes. The delay countdown stops until it latches. Using the delay start on my dishwasher How do I use the delay start option to run your dishwasher at... -
What is the proper procedure for starting my dishwasher?
...Turn off water. Always use in the display window indicating that the unit is interrupted, the Start/Resume indicator flashes. The cycle will need to six minutes while the...procedure for your dishwasher until the door is closed, and Start/Resume is pressed. Press Start/Resume. Firmly close the door. The door automatically latches. Run hot water at the sink nearest... -
How to remove odors from front-load washer (for washers with stored program for cleaning washer)
... Manuals & Remove any clothing or items from developing in the unit will dispense for a moment, then the door will unlock, lock again, and then the cycle will continue.The machine will unlock. Open the door and remove the items from the washer before using the maintenance procedure for better ventilation and drying of...
Similar Questions
Whirlpool Washer Model Wtw4880aw And The Door Will Not Lock.
I Have Unplugged It And It Does Not Help. When You Close The Lid And Press Start It Will Clik About ...
I Have Unplugged It And It Does Not Help. When You Close The Lid And Press Start It Will Clik About ...
(Posted by BIGDOGCLA 9 years ago)
Whirlpool Washer Wfc7500vw Door Won't Lock And Start
(Posted by tutcHam 10 years ago)
Door Wii Not Lock Unless You Shove On The Washer Twice Hard.
I have already changed the switch with no results
I have already changed the switch with no results
(Posted by garrywcastle 11 years ago)
Whirlpool Duet Frontloader Washing Machine Door Hinge Replacement
when i remove the 2 screws that hold the hinge on to the machine are there nuts behind there that wi...
when i remove the 2 screws that hold the hinge on to the machine are there nuts behind there that wi...
(Posted by pfleschner 11 years ago)
Whirlpool- Washing Machine. The Light Control Locked On After Washing 1 Load.
It is a machine made in 2005. It won't work after the Control Locked on, I tried to press many but...
It is a machine made in 2005. It won't work after the Control Locked on, I tried to press many but...
(Posted by vantran101 12 years ago)