Whirlpool WFW8300SW Support Question
Whirlpool WFW8300SW Support Question
Find answers below for this question about Whirlpool WFW8300SW - Duet Sport Washer.Need a Whirlpool WFW8300SW manual? We have 1 online manual for this item!
Question posted by holdendoucet95 on July 7th, 2010
Whta Does It Mean When The Washer Stops And Flashes F-33?
IT IS NOT ALWAYS 33 BUT IT IS THE AMOUNT OF TIME LEFT ON THE WASHER.
Current Answers
Related Whirlpool WFW8300SW Manual Pages
Use and Care Guide - Page 3
...carry out. Close
s Do not wash articles that could ignite or explode.
These words mean:
DANGER
You can kill or hurt you and others are not followed. s Do not repair or replace any part ...to reduce the chance of children is necessary when the washer is
flammable, do not smoke or use an open flame during
this manual or in this time.
This will tell you what can be killed or...
Use and Care Guide - Page 4
... plug E. additional drain hose Part Number 8318155; Companion appliance location requirements should also be installed under entire washer. s Hot and cold water faucets located within 6 ft (1.8 m) of where the power cord is attached to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
Overhead sewer
Standard...
Use and Care Guide - Page 5
....2 (155 cm2)
3" (7.6 cm)
1" 29¹⁄₄" 4" (2.5 cm) (80 cm) (10.2 cm)
A
B
A. Recessed area B. closet or confined area B. Side view - s Additional clearances might be considered. Washer on all sides of installation and servicing.
s Additional spacing of 1" (2.5 cm) on pedestal
29¹⁄₄" (74.3 cm)
38" min. (96.5 cm)
Recommended installation...
Use and Care Guide - Page 6
... recommended spacing.
48 po2 * (310 cm2)
3" (7,6 cm)
24 po2 * (155 cm2)
3" (7,6 cm) 12" (30,5 cm)
1" (2,5 cm)
Drain System
The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. See "Tools and Parts." Floor drain system (view B) The floor drain...
Use and Care Guide - Page 7
...to follow these instructions can result in accordance with local codes and ordinances. A time-delay fuse or circuit breaker is recommended that a separate circuit serving only this... if you are in accordance with all local codes and ordinances.
For a permanently connected washer: This washer must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor...
Use and Care Guide - Page 8
... the rear panel and close the hole with the attached cap.
4. Failure to the cold water faucet.
8 Connect the Inlet Hoses
Insert new flat washers (supplied) into a laundry tub, drainpipe or bucket, to the valves can result in the water lines that the rear of the unit is loose, move and install...
Use and Care Guide - Page 9
...siphoning, do not force excess drain hose into the rear of the drain hose in the laundry tub or standpipe as shown. Using pliers, tighten the couplings with an additional two-thirds ...floors from damage due to the coupling can result.
4. Connect the inlet hoses to the washer
H
C
Laundry tub drain or standpipe drain Connect the drain hose form to its final location.
3.
Periodically...
Use and Care Guide - Page 10
... floor.
Check for a medium sized load.
Pour the detergent into the detergent dispenser. Level the Washer
One foot has been installed at the factory. Check that the appliance is on . 6. First ...three feet were preset at a different height on the floor. Push on the edges of the washer. See "Electrical Requirements."
2. Dispose of or recycle all four feet are pushing on the ...
Use and Care Guide - Page 11
... water is available in all laundry additives before the washer is included in the dispenser allow loading of the load, this feature allows the washer to use whether you are ...washer allows a 7-minute period in the EXTRA RINSE, if selected. The washer is dispensed in the rinse cycle or in which means fewer loads.
The detergent is added at the optimal time for a conventional washer...
Use and Care Guide - Page 12
...This initial cycle serves to using your washer. Sort laundry according to color and type of fire,... electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this type of suds for the selected cycle will likely result in washer errors, longer cycle times, and reduced rinsing performance. Do not overload washer...
Use and Care Guide - Page 13
... not put laundry additives directly into the washer.
This wash system, along with the detergent.
s Powdered detergent: Measure the amount of liquid detergent with the measurement device which comes with the powdered detergent. The bleach will be automatically diluted and dispensed at the proper time during the wash cycle, making it stops.
NOTE: Overfilling...
Use and Care Guide - Page 14
... and hold START (for 3 seconds. To continue the cycle, select and hold END OF CYCLE SIGNAL for approximately 1 second) to restart
the washer at any time, select PAUSE/CANCEL. 2. To stop a cycle and select a new cycle
1. Select and hold START (for 3 seconds until the CONTROL LOCKED Status light turns off. Select and hold...
Use and Care Guide - Page 15
... small items such as sport shirts, blouses, casual business clothes, permanent press blends, cottons and linens, and synthetic fabrics. This cycle combines fast-speed tumbling, a shortened wash time, and high-speed spin to shorten drying times. See "Cleaning Your Washer." Drain/Spin
0:14
N/A
High
*The cycle times vary automatically based on your washer fresh and clean...
Use and Care Guide - Page 16
..., you will not illuminate when selected. s See the "Laundry Guide" section for each Wash Cycle selection. The countdown to...are part of possible options for an overview of normal washer operation.
s The Cold rinse temperatures depend on the ...additional rinse with the same water temperature as in
the Estimated Time Remaining display. Wash Temp
Each cycle has a preset water ...
Use and Care Guide - Page 17
Laundry Guide
Refer to each of 2-3 lightly soiled cotton, polyester, nylon, and cotton
✔
✔
✔
blends.
Select ON or OFF. SPIN SPEED
Each cycle has a preset SPIN SPEED. Delicate
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
✔
✔
✔
Clean Washer... items from the washer as soon as it stops.
CYCLE
SUGGESTED LOAD...
Use and Care Guide - Page 18
... may rust if left in washer errors, longer cycle times and reduced rinsing performance. Follow the manufacturer's instructions to determine the amount of detergent to avoid scratching the washer interior. When possible...such as infant socks, in component failures and noticeable mold or mildew.
LAUNDRY TIPS
Preparing clothes for washing
Follow these recommendations to avoid pilling. HE ...
Use and Care Guide - Page 20
...will stop the cycle. Seal/Bellow
3. c) Let stand 5 minutes. Always do so will proceed to allow for foreign objects. Washer Maintenance ...run to inspect all the Cycle lights will flash and the WASH and CONTROLS LOCKED lights will ...) of washer interior.
Open the washer door and remove any clothing or items from the washer.
2. The door will cause product damage over time.
4. ...
Use and Care Guide - Page 21
... and return the dispenser to faucets. 3. Put 1 qt (1 L) of time, you are at home. Do not use an adapter. NOTE: Do not wash components in washer or reconnect power. 5. Reinstalling the washer
1. To use or vacation care: Operate your washer for easy cleaning. 1. If washer will be moved during freezing weather, winterize it will not...
Use and Care Guide - Page 23
...grounded 3 prong outlet. s Is the washer overloaded? Wash smaller loads. Add the correct amounts of last cycle? s Are you using an extension cord? washer stops
WARNING
Electrical Shock Hazard Plug into a ...an extension cord. s Are the laundry additives in death, fire, or electrical shock. s Is the door locked and is normal.
Use of the washer during certain cycles. s Are you ...
Use and Care Guide - Page 25
...right cycle for small, lightly soiled loads.
To avoid dye transfer, unload the washer as soon as it stops.
For best results, use warm or hot wash water.
See "Connect the...
s Features and specifications on a large load? If you unload the washer promptly? In the U.S.A. Unload the washer as soon as it stops.
A hot rinse followed by spin will not operate correctly with any ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The amount of water seems too low - Front-load Duet washer
... several minutes. The water level will not fill - Allow the unit to side. Front-load Duet Sport Washer is empty. Front-load washer Washer will not be completely underwater. Make sure the washer is not cleaning laundry - Wait for each load. When the washer stops filling, press the Pause/Cancel button. Guides: /shared.whirlpoolcorp.com/service/modelnumber.jsp','modelnumber... -
Washer will not fill - Front-load Duet washer
...soak. Duet Sport washer Washer is at the lowest 6 o'clock position. Front-load washer FAQs Knowledgebase search tips Front-load Duet ® If the washer is...not cleaning laundry - Allow the unit to occur, call an electrician. This may look closed again to protect the washer during certain... kinked? When the washer stops filling, press the Pause/Cancel button. Are the water inlet... -
The chlorine bleach dispenser is not working correctly - Top-load HE washer with Dispenser Drawer - video
... not properly dispense from the chlorine bleach dispenser. Top-load HE washer with Dispenser Drawer - Front-load Duet Sport washer Guides: /shared.whirlpoolcorp.com/service/modelnumber.jsp','modelnumber',500,480);return...using an oxi laundry boost product or color-safe bleach, add it to the liquid chlorine bleach dispenser. Front-load Duet washer The fabric softener ...
Similar Questions
Lock Indicator Will Not Stop Flashing
Washer was working fine. Went to start a new load, pressed the start button and all that happened wa...
Washer was working fine. Went to start a new load, pressed the start button and all that happened wa...
(Posted by dors412 7 years ago)
Wha Does A F28 Code Mean On A Whirlpool Duet Sport Washer Wfw8300sw01
(Posted by mrtDker 10 years ago)
What Does The Code Ds Mean On My Whirlpool Duet Sport Washer?
(Posted by ccslane 12 years ago)
Duet Sport Washer Fabric Softner Compartment Fills Up With Water
my duet sport washer fabric softner compartment fills up with water after every wash, is the drain p...
my duet sport washer fabric softner compartment fills up with water after every wash, is the drain p...
(Posted by jetmech1027 12 years ago)
Whirlpool Duet Sport Washer Drainage Problem
I have a whirlpool duet sport washer/dryer and the washer fabric softner holder fills up with water ...
I have a whirlpool duet sport washer/dryer and the washer fabric softner holder fills up with water ...
(Posted by jetmech1027 12 years ago)