Whirlpool WFW75HEFW Support Question
Whirlpool WFW75HEFW Support Question
Find answers below for this question about Whirlpool WFW75HEFW.Need a Whirlpool WFW75HEFW manual? We have 5 online manuals for this item!
Question posted by Burntmt1 on October 22nd, 2017
How Do You Unlock The Door
my machine was stopped by accident and buttons were pushed by our toddler. Now the door locked light is on and the door won't unlock.A
Current Answers
Answer #1: Posted by Odin on October 22nd, 2017 9:13 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,670
Member since:
April 10th, 2010 Points: 41,236,670
To reset the system, unplug the unit for 30 seconds. If the problem persists (or if you require further explanation), you'll have to obtain a walk-through from Whirlpool: use the contact information here--https://www.contacthelp.com/whirlpool/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW75HEFW Manual Pages
Installation Guide - Page 3
... within 6 ft (1.8 m) of power cord on carpet or surfaces with foam backing is your "Use and Care Guide" for walls, doors, and floor moldings. IMPORTANT: Do not install, store or operate washer where it will need:
n A water heater set to weather or in your responsibility. LOCATION REQUIREMENTS
Proper installation is not recommended...
Installation Guide - Page 4
...(25 mm)
44"" - 1½"** (1(10022mmmm) - 38 mm)
* Recommended spacing of 1" (25 mm) on all sides of washer.
install no higher than 96" (2.44 m), a sump pump and associated hardware are needed .) See "Alternate Parts".
Wall standpipe drain ... 4.5" (114 mm) of washer. (Additional hoses may be at least 30" (762 mm) high; Top of laundry tub must be installed using a floor drain...
Installation Guide - Page 6
...washer.
For a floor drain, remove the preinstalled drain hose form as shown. CONNECT DRAIN HOSE
7. Remove power cord
Pull power cord through opening in a manner that will avoid the drain hose coming out of or leaking from the cord. For a laundry...Cover bolt holes with clamp.
Pull bolts and plastic spacers from
washer
6. Gently place power cord over end of hose, centering it ...
Installation Guide - Page 7
... not overtighten or use tape or sealants on coupling by hand until clear.
7 Coupling
B. In most standard configurations, hoses will need additional parts with flat washers (not provided). 8. do not force excess hose into a laundry tub, drainpipe, or bucket to work properly. Repeat this step with the hose labeled cold for...
Installation Guide - Page 8
... firm contact with floor, go to tighten couplings an additional two-thirds turn on floor. Secure drain hose
Laundry Tub
Standpipe
Wall
4.54".5" (114 mm)
4.5" (114 mm)
4.5" (1143 mm)
Grip washer from side to laundry tub leg, drain standpipe, or inlet hoses for future reference. Secure drain hose to side. n Periodically inspect and...
Warranty Information - Page 1
... service. Proof of original purchase date is effective from accident, misuse, abuse, fire, floods, acts of non...be warranted by the customer.
Service to province. light bulbs, batteries, air or water filters, preservation...doors. 7. Pick-up or delivery. YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR AS PROVIDED HEREIN. WHIRLPOOL® LAUNDRY...
Use & Care Guide - Page 6
...want to 12 hours depending on your laundry load.
Presoak Touch to add a ... a cycle, its default settings will lock while the FanFresh® option is on...washer remembers the last on/off the FanFresh® option, touch FanFresh. NOTE: The door will light up for each cycle. C Extra Rinse Activate this option to add an extra rinse to stop/cancel a cycle at any time. An LED will light...
Use & Care Guide - Page 8
... & Go™ cartridge. Load & Go™ Dispenser Drawer
This will light to start the washer again. Door Locked
Door Locked will be opened without first pausing or canceling the cycle. Add Garment When ... light will not light. The door will continue to the load. After the load size is closed and the cartridge in the Load & Go™ cartridge for only a few more time when it unlocks...
Use & Care Guide - Page 13
...To Fill: Push back on some models)
1. "MAX" line
To Install the Dispenser Cartridge:
1. Slowly slide the dispenser drawer in the single-load compartment; The washer will click into...door. Pull out the dispenser drawer.
2. The maximum capacity of 6x concentration detergent. Lift out the cartridge and set aside. n Do not add single-dose laundry packet to the "MAX" line (see "Using Your Washer...
Use & Care Guide - Page 15
... dispenser. Items need to move freely for loading suggestions. Close the washer door by pushing it firmly until the latch clicks. n Mix large and small items...laundry packets, Oxi-type boosters, color-safe bleach, or fabric softener crystals to reduce wrinkling and tangling. Load laundry into washer
4. n Wash small items in the washer. 3. n Depending on load type and cycle, the washer...
Use & Care Guide - Page 18
...you will hear the door lock, unlock, and lock again.
n This washer has a tight seal to 12 hours. This may do so while the "Add Garment" light is off the FanFresh...washer so that the FanFresh® option does not come on cycle selection and load size.
T ouch and hold START to dry between the tub and the washer drum. The washer door will unlock once the washer movement has stopped...
Use & Care Guide - Page 19
... accumulate inside your last option selection and will lock. e. Close the washer door. Cleaning the Inside of the washer. For better care, wipe the entire inside of the Washer This washer has a special cycle that the old washers are found .
Select the Clean Washer with a damp cloth. To unlock the door, touch POWER. Washer Maintenance
WATER INLET HOSES
Replace inlet hoses...
Use & Care Guide - Page 20
... cycle. To unlock the door, touch POWER. h. Touch and hold START to run 30 wash cycles. Description of a wash cycle as a reminder.
The Clean Washer with affresh® cycle reminder light. After 30 ... allow for future wash cycles until it will stop flashing at the end of the Washer
Use a soft, damp cloth or sponge to the washer when following this initial phase. Use mild soap...
Use & Care Guide - Page 24
...ca for 2 and 3 digit displays) (cont.)
All detergent level status lights are completed, the Clean Washer with affresh® LED will stop flashing at the end of wash cycle (on some models) (cont.)
...to run 30 wash cycles and is touched
Door not closed for 30 seconds; Washer beeps when START is indicating a reminder to clear the code. Unplug washer for at end of a wash cycle after...
Use & Care Guide - Page 25
.... Installation Instructions.
Washer may not be tight against the stainless steel drum.
Do not install washer on slow-speed spin)
Door locking or unlocking.
The shipping bolts...for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Remove strainer/stocking from washer" in Installation Instructions. See "Cycle Guide" and "Using Your Washer."
Loose items...
Use & Care Guide - Page 26
Always measure detergent and follow manufacturer's directions based on inner door glass preventing proper seal with rubber door seal.
Periodically clean the underside of a cycle. Leaking around door
Hair, lint, or other debris on your load requirements. Washer won 't run or fill, washer stops working (cont.)
Check proper electrical supply. This is opened during "Add Garment." Check...
Use & Care Guide - Page 27
... solutions suggested here or visit our website at www.whirlpool.com/product_help -
The washer door is normal.
The door must be closed and latched for washer to complete the wash.
Door not opened and then closed before a new cycle can slow or stop the washer.
After any clogs from drain hose. Do not tape over drain opening...
Use & Care Guide - Page 28
... FanFresh® option by touching POWER. The door will not unlock Door locks when cycle has started.
Desired setting or
For best performance, not all settings are still wet (cont)
Cycles with slower spin speeds remove less water than normal. cannot be attached and have both washer and faucet, and have water flowing to possibly...
Use & Care Guide - Page 31
...on door Detergent is loaded.
31 of cycle
Do not add liquid detergent until laundry is free to flow from whites and lights. ...washer. Single-dose laundry packet not dissolving
Adding laundry packet incorrectly. The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load.
When excessive suds are not responding
Control Lock...
Dimension Guide - Page 2
... installed, top and bottom air openings in door are the minimum required.
Select method you have an overhead sewer and need . Floor standpipe drain system
Laundry tub drain system
4.5" (114 mm)
Minimum diameter for floor standpipe drain system. Top of washer. (Additional hoses may be at least 30" (762 mm) above floor; Floor...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
My dishwasher is locked
... (4) seconds. If you open the door, unlock the control and press Start/Resume to avoid unintended cycle or option changes during a cycle. The dishwasher door can turn off . To turn on the dishwasher FAQs Knowledgebase search tips My dishwasher cycle takes too long The lock light will not start What is the... -
How do I open the lid?- Top-Load HE with Dispenser Drawer
... will unlock once washer movement has has stopped. Top-load washer with Dispensers in Corners The door will reset the lock. Top-Load HE with Dispenser Drawer - or Are you using the washer for first time? Wait until the lid lock light turns off . Open lid Display shows "lid" - Press the Power button to turn the washer off... -
My dishwasher is locked
... opened while the controls are disabled. To turn on the lock while the dishwasher is lit, all buttons are locked. Use the control lock to avoid unintended use the lock feature to restart. When the lock light is running. The lock light will glow. If you open the door, unlock the control and press Start/Resume to avoid...
Similar Questions
Lid Lock Light Flashes. Washer Doesn't Start. What's The Reset Sequence?
lid lock light flashing. Washer won't start. It did this before and I found the fix online. Now, I c...
lid lock light flashing. Washer won't start. It did this before and I found the fix online. Now, I c...
(Posted by tomtcs57 6 years ago)
Washer Is Frozen With Door Lock Light Flashing.
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
(Posted by wendyfinn892 9 years ago)
He Machine Stopped Working While Still In Cycle And We Have An Error Code F06.
the washer stopped in cycle and gave an error code F-06
the washer stopped in cycle and gave an error code F-06
(Posted by janiceduffy 10 years ago)
F25 Code Came Up And Machine Stopped Spinning
F25 code came up. machine stopped. It was making noise.
F25 code came up. machine stopped. It was making noise.
(Posted by dparrish 11 years ago)
The Machine Stops At Second Rinse With Door Lock And Spin Lites Flashing .
what could be causing the problem ?
what could be causing the problem ?
(Posted by plmendoza56 11 years ago)