Home » Whirlpool » Ranges » Whirlpool WFE371LVQ

Whirlpool WFE371LVQ Support Question

Find answers below for this question about Whirlpool WFE371LVQ.
Need a Whirlpool WFE371LVQ manual? We have 4 online manuals for this item!

Whirlpool Overview Questions Manuals Reviews Videos Research

Question posted by maria57328 on March 25th, 2015

Hot Surface Light

Our hoot surface light will not turn off. All burners as well as the oven are off. We have unplugged the stove and plugged it back in. That did not help either. Any suggestions?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on March 25th, 2015 4:05 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,730

1,100
points

See http://www.repairclinic.com/RepairHelp/Range-Stove-Oven-Repair/13-5--V0ZFMzcxTFZR/Whirlpool-Range-Stove-Oven-Troubleshooting. The links most likely to solve are these listed 1st and 11th.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Whirlpool WFE371LVQ Manual Pages

Dimension Guide - Page 1

... located behind the control panel or on the oven frame behind storage drawer panel) *Range can be raised approximately 1" (2.5 cm) by not less than No. 28 MSG sheet steel, 0.015"...way in* C. 36" (91.4 cm) cooktop height (max.) with ranges. Refer to 22" (55.9 cm) from floor F 2.2 cm) min. The range can be connected directly to the proper electrical voltage and frequency as specified...

Installation Instructions - Page 1

Only 7 Verify Anti-Tip Bracket Location 12 Level Range 12 Storage Drawer 12 Complete Installation 13 Moving the Range 14 ANTI-TIP BRACKET TEMPLATE 15 IMPORTANT: Save for local electrical inspector's use. W10252706B U.S.A. INSTALLATION INSTRUCTIONS 30" (76 CM) FREESTANDING ELECTRIC RANGES Table of Contents RANGE SAFETY 2 INSTALLATION REQUIREMENTS 3 Tools and Parts 3 Location ...

Installation Instructions - Page 3

... on the left side frame behind the storage drawer panel. ■ The range should be revised. This oven has been designed in the kitchen. ■ To eliminate the risk of ... The cord should be used in a mobile home, it conforms to the standards listed above the surface units should be located for convenient use with nominal 1³⁄₈" (3.5 cm) diameter connection opening...

Installation Instructions - Page 4

...the bottom of cooktop, see NOTE*. Do not modify the power supply cord plug. Model/serial rating plate (located on the left side frame behind storage drawer panel) *Range can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA ... electric shock. Check with a qualified electrician or service technician if you are in a risk of the above the cooktop surface.

Installation Instructions - Page 6

... base, cardboard or hardboard. 1. Use wrench or pliers to lower front leveling legs one -half turn . Rear leveling leg B. Failure to rear range foot. Remove shipping materials, tape and film from the anti-tip bracket kit (found inside oven. 3. A A. B A. ¼" drive ratchet B. Front leveling leg C. See the "Storage Drawer" section. It will be...

Installation Instructions - Page 7

... Remove template from floor. Hex-head screws 7 Depending on the bracket template. Electrical Connection - Plug into holes with a hammer. 5. To mount anti-tip bracket to concrete or ceramic floor, ...drill bit to the subfloor. Longer screws are available from the middle post of the range. Use a new 40 amp power supply cord. Failure to follow these instructions can result...

Installation Instructions - Page 8

...) A circuit breaker 4-wire connection: box or fused Direct wire disconnect 5" (12.7 cm) 3-wire receptacle (NEMA type 10-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 3-wire connection: Power supply cord Style 2: Direct wire strain relief ■ Remove the knockout as needed for your home has: And you...

Installation Instructions - Page 9

... Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. UL listed strain relief D. Line 1 (black) 6. Tighten strain relief screws. 9. Ground-...terminal block. Use ³⁄₈" nut driver to connect the neutral (white) wire to the range with ranges. 8. Line 1 (black) 3. Neutral (center) wire F. Neutral (white) wire E. Tighten ...

Installation Instructions - Page 13

...the range in the Use and Care Guide. Read "Range Use" in the drawer glides. Turn power on surface burners and oven. or circuit breaker has not tripped. ■ Range is cold, turn off the range ... an outlet. ■ Electrical supply is level. If range is plugged into the closed position. 5. For more information, read the "Range Care" section of your tools. 3. See the Use...

Owners Manual - Page 1

...and serial number located on some models 9 General Cleaning 9 Oven Light 10 TROUBLESHOOTING 10 ACCESSORIES 11 WARRANTY 12 W10200357B Table of Contents RANGE SAFETY 2 The Anti-Tip Bracket 2 FEATURE GUIDE 4 COOKTOP USE 5 OVEN USE 6 Electronic Oven Controls 6 Aluminum Foil 6 Positioning Racks and Bakeware 7 Oven Vent 7 Baking and Roasting 7 Broiling 7 Convection Baking and Roasting...

Owners Manual - Page 3

... drip bowls or oven bottoms, except as suggested in the manual. Grease should be hot even though they have had sufficient time to cause burns - All other glazed utensils are suitable for range-top service without breaking due to a qualified technician. ■ Storage in or on the Range - Moist or damp potholders on hot surfaces may be...

Owners Manual - Page 4

... the display, press TIMER to set the length of the range. BAKE Baking and roasting 1. Doing so can be displayed. 4. The oven light will function with a.m. Only the CLOCK, OVEN LIGHT, and TIMER keypads will come on some or all racks and accessories from the oven cavity. 2. Press CLOCK. 3. If enabled, end-of-cycle tones will...

Owners Manual - Page 5

... when finished. Delay start is not pressed within 5 seconds, "PUSH?" COOKTOP USE WARNING Fire Hazard Turn off to setting. REMEMBER: When range is too hot to adjust time and temperature settings. Hot Surface Indicator Light On ceramic glass models, the hot surface indicator light is canceled and the time of time, and/or shut off . 5 Food must be set...

Owners Manual - Page 6

...light will be able to move birds to another closed and wellventilated room. Single OVEN USE Odors and smoke are audible signals, indicating the following options. Indicator lights show functions that the oven light will turn... the oven will not glow red when cycling on the display. Tones Tones are normal when the oven is used . End of the other surface cooking areas...

Owners Manual - Page 7

...oven door or bottom. Broiling Broiling uses direct radiant heat to maintain a precise temperature range for contact information. It is directly over another. Bakeware To cook food evenly, hot...out to the stop position to drain juices and help avoid spatter and smoke. The bake and broil elements cycle on the oven. Positioning Racks and Bakeware IMPORTANT: To avoid ...

Owners Manual - Page 8

... in oven more than the one displayed. 3. Press COOK TIME. Press the TEMP/TIME "+" or "-" arrow pads to maintain the oven temperature, while the fan circulates the hot air. Press START. RANGE CARE ... If the temperature is completely closed . Press BAKE. The cook time oven indicator light will turn on when the oven door is closed or the door will not lock and the self-cleaning ...

Owners Manual - Page 9

...as the entire range is heavily soiled, use . Damage may help avoid scratches,... Cooktop Scraper uses razor blades. Light to stainless steel surfaces, even with cooktop scraper and...oven door will become less noticeable. 9 The time remaining will turn off and the oven and cooktop are suggested first unless otherwise noted. When the self-clean cycle is still warm. When the oven is hot...

Owners Manual - Page 10

...surface cooking area, element or surface burner. See the Installation Instructions. See "Control Display" in the "Feature Guide" section. Turn bulb counterclockwise to soft cloth or sponge, not directly on cooktop ■ Is the cookware the proper size? TROUBLESHOOTING First try the solutions suggested... ■ Is the range level? Level the range. Oven will help them slide. See "...

Owners Manual - Page 12

...30 days from the date of purchase. 6. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. Repairs to Whirlpool with any questions or concerns at the ...OR FITNESS, SO THESE EXCLUSIONS OR LIMITATIONS MAY NOT APPLY TO YOU. If you on the oven frame behind the storage drawer panel. IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A ...

Warranty - Page 1

... or operator instructions and/or installation instructions. 4. You can write to repair or replace appliance light bulbs, air filters or water filters. Any food loss due to the appliance. 9. Costs ...your authorized Whirlpool dealer to the Internet and you need further assistance, you on the oven frame behind the storage drawer panel. For assistance or service in your major appliance, ...

Whirlpool Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Indicator lights will not turn off
... for up . It will stay illuminated until the surface cooking area cools down . The "burner on" indicator light is turned on the right side of the control panel. This light, located under the cooktop glass, is a hot surface light. It will illuminate when the surface cooking area heats up to cool down . This...
Cooktop indicator light stays on
... glass cooktop? Are all control knobs have its hot indicator lights come on when power is the Power On light on after the burner has been turned off the hot warning lights. This Is the Hot Surface light on ? Indicator lights will stay illuminated until the surface burner cools down . Is the cooktop On light on ? It is located on ? It will not...
Cooktop indicator light stays on
...; Push in and turn off the hot warning lights. It will illuminate when the burner surface heats up. Are all the cooktop indicator lights on after the burner has been turned off, depending on how long it takes to have been turned off when all control knobs have its hot indicator lights come on when power is turned on from the breaker...