Whirlpool WFC7500VW Support Question
Whirlpool WFC7500VW Support Question
Find answers below for this question about Whirlpool WFC7500VW.Need a Whirlpool WFC7500VW manual? We have 4 online manuals for this item!
Question posted by michelleebersohn on January 25th, 2012
F22 Error On Clean Washer Cycle
WFC7500VW - Front-Load Washer. When I put the washer on the Clean Washer cycle it spins for a few seconds and the F22 error flashes. I have read that this is a problem with the door lock. This error ONLY occurs when I use the Clean Washer cycle and not any of the other cycles. If it was a problem with the lock wouldn't it flash the F22 error on all cycles? What seems to be the problem?
Current Answers
Answer #1: Posted by majorapplirepair on December 29th, 2016 3:21 PM
majorapplirepair
Member since:
October 7th, 2011 Points: 139,880
Member since:
October 7th, 2011 Points: 139,880
The lock may continue to lock and unlock. It will continue to work until it completely fails and will either not allow you to start a load or locks your wet clothes inside the washer. The contacts inside the lock that sends a signal to the control board that the door is locked and ok to ramp up the spin speed are failing. Replace the door lock, this is a common problem.
Related Whirlpool WFC7500VW Manual Pages
Owners Manual - Page 3
...
remove the door or lid. HYDROGEN GAS IS EXPLOSIVE.
This is
flammable, do not smoke or use an open flame during
this manual or in a hot water system that you understand and have provided many important safety messages in the washer. WASHER SAFETY
Your safety and the safety of others .
Always read and obey...
Owners Manual - Page 4
.... Ask for your washer or refer to support the washer with a total weight (water and load) of the items listed here, call the dealer from local plumbing suppliers)
Floor drain
Siphon break, Part Number 285834;
Your washer can cause damage in a basement, laundry room, closet, or recessed area.
Do not operate your responsibility. Some water...
Owners Manual - Page 6
... and Parts." Recommended installation spacing for recessed or closet installation, with a door, the minimum ventilation openings in .2 * (155 cm2)
3" (7.6 cm) 12" (30.5 cm)
1" (2.5 cm)
Drain System
The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. The minimum carry-away...
Owners Manual - Page 8
... spacer covering the bolt.
3. Reaching into a laundry tub, drainpipe or bucket, to get rid of particles in the rear panel of the washer that the rear of the water to make sure...the water lines that might clog the inlet valve screens.
■ Check the temperature of the washer is seated on the washer. 2. Screw on coupling by a certified technician.
8 Using a 12 mm wrench, loosen each...
Owners Manual - Page 9
... water inlet C.
Snap either end of the laundry tub.
Using pliers, tighten the couplings with an additional two-thirds turn. Move the washer to the washer's cold (C) water inlet valve. Turn on... the water faucets completely and check for air.
■ Do not lay excess hose on the washer.
2. Read and follow ...
Owners Manual - Page 10
... top edges. 5. Plug into a grounded 3 prong outlet. Read "Washer Use."
9. If the washer is an extra part, go back through the steps to clean your washer, measure ¹⁄₂ the detergent manufacturer's recommended amount of the washer, first side to side, then front to complete one whole cycle. If the nuts are now installed. If there...
Owners Manual - Page 11
... A precision balancing system allows the washer to give the optimum cleaning, rinsing, and spinning conditions. Smart Dispensers The three compartments in the dispenser allow loading of laundry products. Use only HE High Efficiency detergent.
11 The time of operation may be dispensed into the wash at the beginning of the cycle, and the bleach is added...
Owners Manual - Page 12
... tightly packed. Use only HE High Efficiency detergent. To load washer Open the washer door by pulling on it firmly until the lock clicks. Load evenly.
■ Wash small items such as infant socks in washer errors, longer cycle times, and reduced rinsing performance.
Open the dispenser drawer and add laundry products to avoid spills. Doing so can completely remove...
Owners Manual - Page 13
...Push in washer errors, longer cycle times, and reduced rinsing performance. Do not put laundry products directly into standby mode automatically after the door is opened or 1 hour after the cycle is ... for liquid chlorine bleach, and one is complete, the CYCLE COMPLETE status light illuminates, the door unlocks and the wash load can be automatically dispensed in the final rinse or in the...
Owners Manual - Page 14
... be extended if oversudsing occurs or the load is complete, switch knob to drain out the water and the door will also affect the cycle times that are available with all Cycles. Door Locked
When the Door Locked LED light illuminates, the door is selected. It will illuminate. Not all Cycles. To power down the washer manually after the cycle is unbalanced. The...
Owners Manual - Page 15
... washer fresh and clean. This cycle should not be momentary pauses. Drain/Spin
Use this cycle to drain your washer or to drain and spin your cycle selections. Rinse & Spin is preset to begin the wash cycle later. ■ Select DELAY WASH until the desired time (in hours) shows in the washer during the Clean Washer cycle. Casual
Use this cycle to wash loads of normal washer...
Owners Manual - Page 16
... Spin
✔ ✔
✔
Clean Washer
No clothes, use AFFRESH™ washer cleaner or chlorine bleach
Drain/Spin All loads
✔
Rinse & Spin All loads
✔
✔
Heavy Duty Heavily soiled underwear, towels, shirts, etc., made of these washer cycles.
The water temperature for fabrics. See Preset Cycle Settings table in "Cycles."
■ ATC works for suggested load...
Owners Manual - Page 17
LAUNDRY TIPS
Preparing clothes for washing Follow these recommendations to help you are made to determine the amount of sleepwear
QUICK WASH cycle (2-3 garments)
2 dress shirts 1... items, avoid washing single items, and load evenly.
■ Wash small items, such as zippers, snaps, and buckles may also result in washer errors, longer cycle times and reduced rinsing performance. This wash...
Owners Manual - Page 19
... items from the washer.
2.
Close the washer door and the dispenser drawer.
4. Select the CLEAN WASHER cycle.
5. Seal/Bellow
■ The machine will not fill, but the basket will stop the cycle. a) Mix a dilute solution, using the procedure that uses higher water volumes in the washer.
3.
This will rotate while the washer runs a short sensing cycle. A RINSE/SPIN cycle must then be...
Owners Manual - Page 20
...panel clips. 4.
Turn on a Drain/Spin cycle.
2. Failure to clean the washer and remove the antifreeze, if used .... of HE detergent for a medium-size load, to follow these instructions can damage your washer where it looking new. Put 1 qt...washer through the Normal cycle with ¹ ₂ the manufacturer's recommended amount of time, you are away. ■ Slightly open door...
Owners Manual - Page 21
... Variables [F01 - Select DRAIN/SPIN if there is excessive water in the Estimated Time Remaining display. All four feet of the washer.
■ Are the fill ...Problem-no water or
insufficient water supply) If this error occurs, the system will hear sounds that you will pause. Is the drain hose frozen? F30] (Electrical Problem) Switch knob or press and hold CANCEL/DRAIN to cancel the cycle...
Owners Manual - Page 22
..., use the chlorine bleach dispenser for 3 seconds.
22 Use of non-HE detergent can cause a film residue which can result in death, fire, or electrical shock.
■ Is the power cord plugged into a grounded 3 prong outlet? Door won 't run, fill, rinse or tumble;
After the CLEAN WASHER cycle is complete, wipe away residue if necessary...
Owners Manual - Page 23
... soiled garments.
If the laundry is normal and will add time to the original cycle.
■ Did the load cause imbalance? Transfer of dye can be fully loaded, but not tightly packed. Do not overload the washer. The washer can occur when mixing whites and colors in this activity is detected. Lint can reduce spin speed. See "Secure...
Owners Manual - Page 24
... the detergent. To avoid transfer of load you have hard water? Consider using a low speed wash cycle? If safe for slow-speed cycles such as it in a low-speed cycle? A hot rinse followed by spin will not operate correctly with a low spin speed to reduce wrinkling.
■ Did you overload the washer? ■ Did you use warm...
Owners Manual - Page 25
...Minnesota Court Mississauga, Ontario L5N 3A7
Please include a daytime phone number in your washer with the same precision used to fulfill the product warranty and provide after -... or your correspondence.
31682 1903WH W10135699 W10178021
All purpose appliance cleaner Laundry supply storage cart AFFRESH™ Washer Cleaner Stack kit
25 In Canada
Call the Whirlpool Canada LP Customer ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill - Front-load Duet washer
..., and the four plastic spacers that the washer is not cleaning laundry - This will not fill - Your washer will not be removed from the factory with them, can result in the cycle? Was the door left closed , but Start has not been selected and held for each load. If the door is at the lowest 6 o'clock position. Does... -
Washer will not start - Duet® Steam washer
... a normal pause in noise, vibration, error codes and possible machine damage. Is the washer door firmly shut? The door must be opened between cycles, the washer may not be latched. Open the door and firmly close it , if necessary. Front-load Duet washer Display shows F22 or FdL - Steam washer start filling after the door locks. Has a household fuse blown, or has... -
How do I remove odors from my Top-loading HE washer?
.... Find Manuals & If your washer. HE washer? The Clean Washer cycle uses higher water volumes in my washer? If using the correct amount of fabric softener. Top-load HE with Clean Washer cycle NOTES: Read these instructions completely before beginning the cleaning process. NOTE: Do not add any clothing or items from developing in your laundry room is cancelled, run every...
Similar Questions
Washer Machine Don't Cycle
My washer machine won't start all the light come on, the door lock turn on, drain and unlock light d...
My washer machine won't start all the light come on, the door lock turn on, drain and unlock light d...
(Posted by angelqny77 6 years ago)
Washer Is Frozen With Door Lock Light Flashing.
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
(Posted by wendyfinn892 9 years ago)
I Watched The Cycles More Carefully And The Washer Starts Fine. The Door Lock
light comes on and everything. When it should be in the Spin and Drain part of the cycle it stops an...
light comes on and everything. When it should be in the Spin and Drain part of the cycle it stops an...
(Posted by gatankjr 9 years ago)
Wfc7500vw F22 Error Code
we get an F22 error code after about 30 seconds in to our cleaning cycle. It is the only time this c...
we get an F22 error code after about 30 seconds in to our cleaning cycle. It is the only time this c...
(Posted by kfabian10 11 years ago)
What Does F22 Mean?
I ran the washer through the clean washer cycle. It stopped and F22 came up in the message center. I...
I ran the washer through the clean washer cycle. It stopped and F22 came up in the message center. I...
(Posted by lynnejones49 12 years ago)