Whirlpool WET3300XQ Support Question
Whirlpool WET3300XQ Support Question
Find answers below for this question about Whirlpool WET3300XQ.Need a Whirlpool WET3300XQ manual? We have 5 online manuals for this item!
Question posted by reorder49 on February 27th, 2013
Water
I want more water in the wash tub. Whirlpool combination WET3300XQ. It only fills 3/4 the way up the wash tub in reference to the tub holes
Current Answers
Related Whirlpool WET3300XQ Manual Pages
Installation Guide - Page 4
... Utility Sink, Sump Pump and Connectors (available from whom you purchased your washer/dryer. Optional equipment: (Not supplied with washer/dryer) Refer to 1" (25 mm) diameter Standpipe Adapter Part Number 3363920, Connector Kit Part Number 285835
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
Drain hose too short
Extension...
Installation Guide - Page 5
... located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 500 lbs (226.8 kg).
This washer/dryer has been tested for mobile home installations.
n F or... conform to the washer. See "Washer/Dryer Care" in a basement, laundry room, closet, or recessed area. You will be considered for purchase from your washer in the "Washer/Dryer Use and ...
Installation Guide - Page 7
... "Use and Care Guide." install no higher than 4.5" (113 mm) of drain hose should be inside standpipe or below the top of washer/dryer. (Additional hoses may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Top of washer/dryer. IMPORTANT: To avoid siphoning, no more than 96" (2.4 m) from bottom of wash tub.
Installation Guide - Page 20
...only)
2. See "Tools and Parts." Place hose into standpipe or lay on the side of the washer/dryer. Open clamp. Wet the inside standpipe; do not force excess hose into standpipe (shown in ...silver double-wire clamp with tap water. You may need to open.
Twist hose back and forth while pushing onto drain connector on bottom of laundry tub.
Place drain hose in picture)...
Installation Guide - Page 21
... are working in a closet or recessed area: move the washer/dryer into a laundry tub, drainpipe, or bucket to washer correctly. Do not use tape or sealants on coupling by hand until it is connected to hot water to help in the couplings.
2. Firmly seat the washers in attaching hoses to prevent clogs. Connect inlet hoses to...
Installation Guide - Page 22
... with shipping strap removed earlier.
After washe/dryer is in dryer. Move washer/dryer to final location
Secure drain hose to check for leaks
Connect vent
1.
Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Connect vent to exhaust outlet
Turn on water faucets to laundry tub leg, drain standpipe, or inlet...
Installation Guide - Page 24
...that both fuses are intact and tight, or circuit breakers have not tripped.
See "Level Washer/Dryer."
In the U.S.A.:
q For power supply cord installation, plug into a ... Check that the washer/dryer is first heated. q To test the washer, measure 1/2 the normal recommended amount of your tools. q Check that the water faucets are tight. q Read the "Washer/Dryer Use and ...
Energy Guide - Page 1
...(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$31 ▼
$10
$71
Cost Range of ...$21
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility rates and use....on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10....
Warranty Information - Page 1
... of products not approved by a Whirlpool designated service company. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from...proof of original purchase date is used for future reference. This limited warranty is valid only in the...filters or water filters. Replacement parts or repair labor on how to correct house wiring or plumbing.
3.
WHIRLPOOL SHALL NOT...
Use & Care Guide - Page 4
... at www.whirlpool.com/accessories. ft (0.18 cu. fits 29" (737 mm) Super Capacity Plus, 7.0 cu. white All-purpose appliance cleaner
Laundry supply storage cart
This washer does not include inlet water hoses. Traditional washer
Reduced water washer
4 fits 29" (737 mm) Super Capacity, 6.5 cu. m) - As a result, water levels will be lower, and hot and warm wash temperatures may...
Use & Care Guide - Page 6
...KNOB Use your laundry load. Gives the best drying in the load or air temperature and shuts off when the load reaches the selected dryness level. washer
1 WASH CYCLE KNOB Use the Wash Cycle knob to... select a cycle for your Dryer Cycle knob to select the desired setting (On or Off).
NOTE: The highest water level will depend...
Use & Care Guide - Page 9
... of the washer basket before adding clothes. Helpful Tips:
• When washing water-proof or water-resistant items, load evenly.
• Use mesh garment bags to help avoid tangling when washing delicate or small...washing, because heat can set stains into the bottom of detergent to avoid pilling.
If using an Oxi or color-safe bleach laundry boost product, add to items during washing....
Use & Care Guide - Page 10
Load laundry into dispenser, always follow manufacturer's directions for best cleaning and to choose your load size.
Lift the lid and add the measured recommended amount of liquid fabric softener (diluted with warm water until the washer has completed filling, push in the same cycle with liquid chlorine bleach. 10
Turn Cycle knob clockwise to...
Use & Care Guide - Page 11
... to the appropriate setting based on your hot water heater setting. This will be cooler than your load. If your previous washer provided. Select LOAD SIZE
9.
Wash Temp
Suggested Fabrics
Hot
Some cold water is very cold, warm water may be cooler than what your tap cold water is added to help dissolve detergent.
Whites and...
Use & Care Guide - Page 12
... or wash screen to dryness level. Push the lint screen firmly back into place. NOTE: Your model may want to put... on a hanger to complete drying.
Selecting Very Dry, ENERGY PREFERRED, or Less Dry automatically adjusts the dryness level at which the dryer will shut off the screen with a damp cloth to remove dust from storing and shipping.
1. Load the dryer
Place laundry...
Use & Care Guide - Page 14
...washer or clothing, do not wash clothes with a damp cloth. 3.
Use a soft, damp cloth or sponge to liquid chlorine bleach dispenser. Cleaning the dryer interior
To clean dryer drum 1. Tumble a load of the washer...laundry in the Cycle knob. Using recommended AFFRESH® washer cleaner, add one tablet to washer... washer for proper washer/dryer operation. WASHER/DRYER MAINTENANCE
WATER INLET...
Use & Care Guide - Page 15
... to gas supply
line. 4. To wash: 1. Scrub lint screen with hot water. 5. Close shut-off the screen into place. n If lint falls off valve in washer/dryer base. 6. Reinstall screen in washer/dryer base. 4. Disconnect wiring. 3. Reinstalling the Washer/Dryer
Follow the "Installation Instructions" to washer/dryer. 2. As needed cleaning Laundry detergent and fabric softener residue can...
Use & Care Guide - Page 16
.... Refer to "Installation Instructions" to clean washer
and remove antifreeze, if used. Replace the bulb with the screw.
4.
Use half the manufacturer's recommended amount of the cover. Remove the cover.
3. Plug into a pan or bucket. Shut off both water faucets.
2. Place packing tray from back of washer/dryer. Replace the cover and secure with...
Use & Care Guide - Page 17
... humming sound with floor, and washer/dryer must be draining water.
http://www.whirlpool.com/help - Load could unbalance washer.
Fill hoses not attached tightly. Check household plumbing for service to remove items.
It is normal to operate properly. WASHER
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to...
Use & Care Guide - Page 19
...load washers. The high spin speeds combined with water
than traditional top-load washers.
Check that hot and cold inlet hoses are not reversed. This includes cooler hot and warm washes....for the fabrics being washed. See "Using Your Washer" section.
Load with dry items only. In Canada www.whirlpool.ca
If you experience
Possible causes
Solution
Washer not performing as ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I clean my Cabrio® top-loading washer?
... new. Use a soft, damp cloth or sponge to wipe any hard water deposits using hot water. t op-loading washer? For cleaning information regarding the Cabrio top-loading washer with the parts upside down. IMPORTANT: Be sure the inner cone-shaped cup is not cleaning laundry - How do I clean my top-loading super- Do not use... -
Removing odors from a front-load washer with the Clean Washer cycle (on control panel)
... washer before beginning the cleaning process. Do not add detergent or other laundry...washer display shows rL or F34 . If you are not ready to thoroughly clean the inside of visible residue. See Make sure you are washing requires cold water...combination with stored program for washers with Affresh TM washer cleaner or liquid chlorine bleach to run the Clean Washer... -
How do I clean my top-loading washer?
... softener dispenser. Do not add detergent or bleach to the washer, select a hot wash, and run it looking new. Use mild soap and water. Purchasing Affresh washer cleaner Using Affresh washer cleaner? How to the washer or clothing, do I clean my top-loading washer? This information is on cleaning the Bravos TM top-loading...
Similar Questions
Washer Will Not Go Past Wash Cycle Wash Light Stays On And Busses. Prior To This
it went thru the cycle but left water in tub then it bussed and wouldn't shut off. So I took the hos...
it went thru the cycle but left water in tub then it bussed and wouldn't shut off. So I took the hos...
(Posted by Yoliwallace 8 years ago)
Low Water Wash Plate
The retaining nut came loose from the washplate. How tight should I tighten the nut? Should the wash...
The retaining nut came loose from the washplate. How tight should I tighten the nut? Should the wash...
(Posted by jjc1925 9 years ago)
Washer Won't Fill With Water
I went to do a load of laundry tonight and the washer wouldn't fill with water. I turned it on the s...
I went to do a load of laundry tonight and the washer wouldn't fill with water. I turned it on the s...
(Posted by sobelps 10 years ago)
Water Presure - Washer
I have not enough water pressure in the washer. The machine has some filters that can be cleaned? ...
I have not enough water pressure in the washer. The machine has some filters that can be cleaned? ...
(Posted by agcd 10 years ago)
Wet3300xq0 Leaking And Disrupted Water Flow
This machine is just over a year old. When filling, water leaks onto floor. The flow of water is dis...
This machine is just over a year old. When filling, water leaks onto floor. The flow of water is dis...
(Posted by chelsypelkey 10 years ago)