Whirlpool WED9550WR Support Question
Whirlpool WED9550WR Support Question
Find answers below for this question about Whirlpool WED9550WR.Need a Whirlpool WED9550WR manual? We have 4 online manuals for this item!
Question posted by shannonbolt on June 15th, 2014
Dryer Stops Before Clothes Are Dry
dryer stops before clothes are dry
Current Answers
Answer #1: Posted by Odin on June 15th, 2014 12:29 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See this webpage. (Ignore the paragraph in red relating to a partial model number.)
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WED9550WR Manual Pages
Installation Instructions - Page 1
... the word "DANGER" or "WARNING." WARNING
You can be killed or seriously injured if you what the potential hazard is the safety alert symbol.
ELECTRIC DRYER INSTALLATION INSTRUCTIONS U.S.A. All safety messages will tell you don't follow instructions. These words mean:
DANGER
You can be killed or seriously injured if you and...
Installation Instructions - Page 2
...188;" nut driver (recommended)
■ Tape measure
■ Pliers
Parts supplied Non-Steam Models
Steam Models
A
B
C
D
E
A. "Y" connector C. NOTE: Do not use leveling legs supplied with dryer if installing on a pedestal. Leveling legs (4) B. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before purchasing parts. Parts needed
Check local codes...
Installation Instructions - Page 3
...a companion appliance should also be exposed to water and/or weather. The combined weight of the dryer in longer drying times.
Steam (Electric or Gas)
A
38" (965 mm)
B
32 9/16" (827 ... outlet located within 4 ft (1.2 m) of the dryer, and water pressure of 1" (25 mm) under entire dryer. Contact your dryer.
Clothes may not tumble properly and automatic sensor cycles may use...
Installation Instructions - Page 4
...(0 mm) spacing is allowed. Custom undercounter installation - This dryer has been tested for this dryer. Dryer on all sides of installation
and servicing.
■ Additional ...the door are not recommended for recessed or closet installation. Recessed or closet installation -
Closet installation - Dryer only
(460 mm) C
A*
B
Side View
Steam (Electric or Gas)
Non-Steam (Electric ...
Installation Instructions - Page 5
...qualified electrical installer.
■ To be at least twice as large as the dryer exhaust opening (such as a nearby window) should be sure that the electrical ...installation
NOTE: Some models are not recommended for cabinet installation.
■ For cabinet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing.
48 in.2 * (310 cm2)
3"* (76 mm)
24 ...
Installation Instructions - Page 6
... for use with clothes dryers. When the neutral ground conductor is secured under the neutral terminal (center or white wire) of the terminal block, the dryer cabinet is isolated from...cord, at least 4 ft (1.22 m) long, must be used , it here.
■ This dryer is manufactured ready to install with a 3-wire electrical supply connection. Disconnect power before making electrical connections....
Installation Instructions - Page 7
... gauge solid copper wire. Reaching inside the strain relief. External ground conductor screw C. Install strain relief. The strain relief should have a tight fit with the dryer cabinet and be connected to do so can result in a horizontal position. Ground wire (green or bare wire) must be in death, fire, or electrical...
Installation Instructions - Page 8
...wire receptacle (NEMA Type 14-30R)
A UL listed, 120/ 240-volt minimum, 30-amp, dryer power supply cord*
4-wire connection: Power supply cord
4-wire direct
5" (127 mm)
3-wire ...10-30R)
A fused disconnect or circuit breaker box*
A UL listed, 120/ 240-volt minimum, 30-amp, dryer power supply cord*
4-wire connection: Direct Wire
3-wire connection: Power supply cord
3-wire direct
(89 mm)
A...
Installation Instructions - Page 11
...." Connect the other wires to achieve the best drying performance. The dryer exhaust must be used .
4.
Rigid metal vent ■ For best drying performance, rigid metal vents are
recommended.
■...an existing vent system
■ Clean lint from your electrical connection. Insert tab of dryer rear panel. Now go to neutral wire. 1. Center, silver-colored terminal block screw...
Installation Instructions - Page 13
.... Avoid 90º turns. To avoid damaging the floor, use the fewest number of cardboard from the dryer carton. Select the type best for close clearances
Venting systems come in longer drying times and increased energy usage. Terminate the exhaust vent outside.
■ Plan the installation to use a large flat piece of...
Installation Instructions - Page 15
...live in a hard water area, use 2 household fuses or circuit breakers. See "Level Dryer." 6. Read "Dryer Use." 9.
If you have not tripped. Over time, the buildup of lime scale ... Timed Dry heated cycle, and start , check the following : Was the drying cycle interrupted by a power failure? Do not select the Air Only Temperature setting.
If you may be a problem with a damp cloth to ...
Installation Instructions - Page 16
... the correct length? All rights reserved.
4/09 Printed in a closet? Confirm the power cord is not too long or has too many turns.
Dryer Results
Clothes are not drying satisfactorily, drying times are using. Hold your vent system falls within the recommended run cleaned.
■ "E" Variable (E1, E2, E3) service codes: Call for most...
Owners Manual - Page 5
... that has ever had anything that has ever had any type of oil on it (even after washing).
Do not dry anything flammable on it (including cooking oils).
Failure to use your dryer following installation instructions apply:
■ Installations and repairs must be a T-handle type. ■ A flexible gas connector, when used, must...
Owners Manual - Page 7
... using a Steam Cycle.
■ The Quick Refresh Cycle is best for smoothing out wrinkles and reducing odors from loads consisting of one to four dry items of Residential Clothes Dryers
Automatic Preset Cycle Settings NOTE: Not all models. NSF Protocol P154 Sanitization Performance of wrinkle-free cotton, cotton-polyester blend, common knits, and...
Owners Manual - Page 8
..., it stops, wrinkles can be dried using Air Only ■ Check that cycle is preset to "ON." Cycle Time*
(Minutes)
TIMED DRY
High
40
Heavyweight items,
bulky items, bedspreads,
work clothes
TOUCH UP...a small amount of water is sprayed into the dryer drum after several minutes of clothes from loads consisting of
one to four dry items.
ENHANCED TOUCH UP
Medium
20
Helps to smooth...
Owners Manual - Page 9
... partially dry items that your dryer shuts down.
This change will flash.
4. Damp Dry Signal On some models, the Damp Dry Signal may be selected to alert you that may need ironing. You can be stopped by the current drying setting.
3. NOTE: If you happen to press Pause/Cancel twice, the program clears and your clothes are...
Owners Manual - Page 10
... water. 5. Dry unstable dye items inside out to avoid transfer of clean cloths or towels to remove residue buildup. Unplug dryer or disconnect power. 2. Clean lint screen. Steam models only: Turn off the screen into place. Cleaning the Dryer Interior
To clean dryer drum 1.
Roll lint off while the screen is hard to stop before each...
Owners Manual - Page 12
... there may be cleaned before laundering.
■ Are the four legs installed, and is present. Replace the fuse or reset the circuit breaker. Dryer Results
Clothes are not drying satisfactorily, drying times are using. Under certain environmental or installation conditions you do not feel air movement, clean exhaust system of lint or replace exhaust...
Owners Manual - Page 13
... ■ Is the lint screen clogged? Lint on Automatic Cycles. Check for small loads of dryer cycles requires temperatures above 45ºF (7ºC).
■ Is the dryer located in clothing (usually blue jeans). Loads are still wrinkled following Steam Cycle? Dry smaller loads that water inlet hose is connected to both the faucet and...
Dimension Guide - Page 1
... continuous commitment to improve our products, we reserve the right to achieve the best drying performance. Do not have a 90° turn to the cold water faucet using...venting, 0" (0 mm) spacing is allowed. To determine maximum exhaust length, add one 90° turn inside the dryer. Louvered doors with equivalent air ventilation openings are acceptable.
48 in.2 * (310 cm2)
3" (76 mm)
14...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Wrinkles in load after Steam cycle - Steam dryer
... wrinkles from items such as clothes packed in a suitcase or wrinkled from loads consisting of one to four dry items of wrinkle-free cotton, cotton-polyester blend, common knits and synthetic garments. Is the dryer connected to see water spraying or steam in the dryer too long. Steam dryer Steam nozzle has blue-green... -
Loads are wrinkled - Dryer
...removing the laundry items from the washer and separately add them into the dryer. Items going ...dryer cycle ends. Mixing fabric types also increases wrinkling. Check clothing fabric care labels for recommended drying temperatures. Temperatures too high for best drying results. For best drying and wrinkle results, untangle items from the dryer... -
My dryer makes sounds or vibrations
...dryer shake or vibrate. Use a dry rack when drying tennis shoes. This will cause the dryer cabinet to vibrate. Leave space between the washer and dryer...knotted or balled up . Laundry items with a towel load inside the dryer along the front and rear ...dryer without legs, or that is not level, which will regain their shape and the sound should stop. If the dryer...
Similar Questions
Dryer Sensor - Does This Dryer Have A Dry Sensor That Requires Regular Cleaning?
does this dryer have a "dry" sensor that requires periodic cleaning?
does this dryer have a "dry" sensor that requires periodic cleaning?
(Posted by pratt7872 5 years ago)
Older Ggw92250pw Dryer Has Continous High Pitched Squeel. Clothes Dry Normally.
The Squeel Appears To Be Coming From Drum As It Turns. When The Dryer Is Paused The Squeel Stops. Ca...
The Squeel Appears To Be Coming From Drum As It Turns. When The Dryer Is Paused The Squeel Stops. Ca...
(Posted by frothenp 9 years ago)
1 Yr Old Wgd8200yw Dryer Does Not Dry Clothes
Dryer will start the fire and heat, but no air flows out the exhaust.I have removed the external ven...
Dryer will start the fire and heat, but no air flows out the exhaust.I have removed the external ven...
(Posted by kenwenzel 10 years ago)
Dryer Won't Dry Clothes But Is Spinning And Getting Super Hot??
(Posted by Ckadavy 11 years ago)
My Gas Dryer Is Not Drying My Clothes.
I have checked my breaker and cleared my vent. Its still not drying what else could it be?
I have checked my breaker and cleared my vent. Its still not drying what else could it be?
(Posted by dsolis4187 13 years ago)