Whirlpool LCE4332PQ Support Question
Whirlpool LCE4332PQ Support Question
Find answers below for this question about Whirlpool LCE4332PQ - 22" Washer w/2.1 cu. Ft. Capacity.Need a Whirlpool LCE4332PQ manual? We have 3 online manuals for this item!
Question posted by daveamrani on June 25th, 2013
Unit Turns On But Will Not Start
my unit has been working fine for eight months until yesterday where we turned it on and the buttons light up but after you press the start button to begin putting water inside it does nothing. does not start putting water into the unit. please help asap!!
Current Answers
Related Whirlpool LCE4332PQ Manual Pages
Owners Manual - Page 3
...explode.
s Before the washer is the safety alert symbol.
s See "Electrical Requirements" for such a period, before using the washing machine, turn on all safety messages. WASHER SAFETY
Your safety and ...others are not followed. This symbol alerts you to the weather.
If the hot water system has not been used for several minutes.
All safety messages will be produced in...
Owners Manual - Page 4
... "Assistance or Service" section of the drain hose)
D. INSTALLATION REQUIREMENTS
Tools and Parts
Assemble the necessary tools and supplies before beginning the washer installation. If You Have:
You Will Need to Buy:
Laundry tub or standpipe taller than 72" (183 cm)
Sump pump system (if not already available)
1" (2.5 cm) diameter standpipe
2" (5 cm) diameter...
Owners Manual - Page 5
... cord having a 3 prong grounding plug. s This washer is required. Front view B. Side view C.
s Hot and cold water faucets located within 5 ft (1.5 m) of 5-100 psi (34.5-690 kPa).
...follow these instructions can result in a basement, laundry room, closet, or recessed area.
Installing the washer on all sides of the washer is the personal responsibility and obligation of the...
Owners Manual - Page 6
... the event of a malfunction or breakdown, grounding will not fit the outlet, have a fuse in doubt as to turn the washer legs out approximately ¾" (1.9 cm).
To protect the floor, place two corner posts from the shipping material on the floor in accordance with a qualified electrician ...
Owners Manual - Page 7
...inside of the straight end of the standpipe must be no higher than water.
3. Place clamp over area marked "CLAMP." Drain hose B. See "Tools and Parts." The minimum carry-away capacity... the cabinet.
¼" (6 mm)
A
B
Laundry tub drain system (view C) The laundry tub requires a minimum carry-away capacity of the washer.
4.
Select the drain hose installation method you need...
Owners Manual - Page 8
... the remaining water inlet port. Drain hose
2. Put hooked end of drain hose into the washer: s Do not straighten hooked end of air. Hose should be secure, but loose enough to the washer 6. Run water through both faucets and inlet hoses, into a bucket or laundry tub, to tighten connection with an additional two-thirds turn . Screw on...
Owners Manual - Page 9
...any cycle, and then press START/OFF.
Do not force excess drain hose back into the rear of /recycle all packaging materials.
Check to be transported. 5. Dispose of the washer.
Failure to final location....foam plug for leaks around the water inlet hoses and the drain hose. Check for use if the washer should be sure you have all parts are recessed, put the hooked end of the drain...
Owners Manual - Page 10
...-and-drain hose to water leakage. Hot water (right) inlet valve is capped. PORTABLE INSTALLATION INSTRUCTIONS
Drain System
The washer must drain into the end of the inlet hose.
IMPORTANT: To ensure proper installation, this valve capped.
¼"
C
(6 mm)
A. Wet inside end of the fill-and-drain hose with a carryaway capacity of double-wire clamp...
Owners Manual - Page 11
... the WASH/RINSE TEMPERATURE setting on the hose connector. To test the water, press the red water-flow button on your washer, measure and add ¹⁄₂ the normal
recommended amount of the faucet connector. Check to the washer. If there is attached to help avoid movement during spin.
2. Do not remove ground prong. Select...
Owners Manual - Page 12
... the detergent dispenser drawer. Overloading can completely remove oil. s To reduce wrinkling of permanent press clothes and some synthetic knits, use a cup with gasoline or other sections of the cycle...through the wash water.
s Do not use . s To avoid spilling, use the large load water level setting to the bottom of the washer basket. WASHER USE
Starting Your Washer
WARNING
1. Doing...
Owners Manual - Page 13
... wash loads.
Press START/OFF. s The washer pauses briefly throughout each cycle. The Wash/Rinse Temperature control does not set the wash temperature. For Permanent Installations
Press the WASH/RINSE TEMPERATURE button to shorten drying time. Wash combines medium-speed agitation and high-speed spin to set temperature.
For a medium load the indicator light is off...
Owners Manual - Page 14
....
Wash selected time
3. Fill
2. s Turn synthetic knits inside -out. s Mend tears, loose hems, and seams.
s Treat spots and stains. s Turn down cuffs;
Rinse
3. s Stained or wet garments should be closed , and Start/Off is pushed, the washer fills (to the selected load size) before spin When the cycle changes from lightly soiled ones, even if
they...
Owners Manual - Page 15
... five years of hose failure.
Non-use or vacation care: Operate your washer where it looking new. s Turn off both water faucets.
2.
Shut off the water supply to the washer. To use to reduce the risk of use washer again: 1. Flush water pipes and hoses.
2. Reconnect water inlet hoses.
3. Unplug the power cord.
6.
Periodically inspect and replace inlet...
Owners Manual - Page 16
...water faucets turned on?
Are the water inlet valve screens clogged?
Check electrical source or call electrician. If problem continues, call electrician.
Do not use less detergent.
Wash smaller loads. See "Starting Your Washer...standpipe or laundry tub?
The wash load should be able to draining or spinning, you may hear air being pulled through the pump.
The washer must ...
Owners Manual - Page 17
...detergent to the dispensers before starting the washer. s Did you sort properly? s Are the hot and cold water hoses reversed?
Sort dark...the washer? s Did you use the dispenser to dissolve and work properly.
17 Refer to the bottom of the washer basket.... hard water. Water temperature should be level. Washer basket is normal. Dispensers clogged or leaking
s Are the laundry products...
Owners Manual - Page 18
...and provide afterwarranty service, anywhere in the United States. s For portable installations: Is the...
18
This information will fit right and work right because they are trained to Whirlpool...installations: Are the hot and cold water inlet hoses reversed?
ASSISTANCE OR SERVICE
...local dealers. It may save you overload the washer?
Call the Whirlpool Customer Interaction Center toll ...
Owners Manual - Page 19
... state or province to contain water, if defective in remote areas. Some states and provinces do not allow the exclusion or limitation of your washer, to instruct you need it.... Damage resulting from anywhere in
accordance with the product, Whirlpool Corporation will pay for units operated outside the United States and Canada. 6. at 1-800-253-1301 from accident, alteration, misuse, abuse...
Dimension Guide - Page 1
...carry-away capacity (for permanent installations). D
Ref. 326035915 09-22-04 The top of the standpipe must be no higher than 72" (183 cm) from the bottom of the washer. For... (49.2 L) per minute.
Additional hoses might be provided. Laundry tub drain system (view C)
The laundry tub requires a minimum carry-away capacity of 13 gal. (49.2 L) per minute (for permanent ...
Warranty - Page 1
... use your sales slip together for FSP® replacement parts and repair labor costs to contain water, if defective in remote areas.
Damage resulting from accident, alteration, misuse, abuse, fire, ...fifth year from the date of purchase, when this washer is designed to be repaired in materials or workmanship. Outside the 50 United States and Canada, this exclusion or limitation may ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dishwasher will not start
... not start Why won't my dishwasher start option activated? Is the delay start ? Is the Start/Resume indicator flashing? Press and hold the Heated Dry option (button with the door operation. A lower dish rack that the water shutoff valve is the case, the motor will automatically reset itself within 3 seconds of pressing the Start/Resume to the beginning of... -
Will the Microban® Refrigerator Air Filter fit my refrigerator?
... numbers that begin with either S or HR. ft. built side by side refrigerator serial number does not begin with S or HR, the Microban Refrigerator Air Filter will fit only U.S. capacities. To remove.... To verify your size and serial number, review the labels on the inside of your refrigerator or refer to clean your refrigerator Refrigerator/freezer odor removal Find Manuals &... -
Will the Microban® Refrigerator Air Filter fit my refrigerator?
...capacities. NOTE: If your side by side refrigerators in the space below. To remove odors, you may need to clean your refrigerator To verify your size and serial number, review the labels on the inside... Odd taste or odor in my ice or water Food storage tips Will the Microban ® built side by side refrigerator serial number does not begin with S or HR, the Microban Refrigerator Air...
Similar Questions
How Much Did This Unit Cost New
(Posted by acerpacerap 7 years ago)
Cabrio Washer Wtw7800xw2 Just Quit Working No Power At All I Checked The Obvious
we just moved the washer could it be out of balance or something out of wack could that stop power I...
we just moved the washer could it be out of balance or something out of wack could that stop power I...
(Posted by mb98632 9 years ago)
I Got One Whirpool And The Water Wont Stop As Soon As The Machine Start Working,
when machine start working the water wont stop and will spill out from the machine and will be water...
when machine start working the water wont stop and will spill out from the machine and will be water...
(Posted by limo222 10 years ago)
Washer Only Works Fine On Cold
When I try to wash a load on hot it fills then stops fills then stops it takes a long time to wash a...
When I try to wash a load on hot it fills then stops fills then stops it takes a long time to wash a...
(Posted by chefdave1981 11 years ago)
Wont Agitate
Can anyone help please everything works fine but the agitator will only go counter clockwise, twisti...
Can anyone help please everything works fine but the agitator will only go counter clockwise, twisti...
(Posted by dreamrelm2000 12 years ago)