Whirlpool GC5SHAXVS Support Question
Whirlpool GC5SHAXVS Support Question
Find answers below for this question about Whirlpool GC5SHAXVS - 24.6 Cubic Foot Flat Texture Coun.Need a Whirlpool GC5SHAXVS manual? We have 5 online manuals for this item!
Question posted by stang89c on December 29th, 2010
Gc5shaxvs00 Ice Dispenser.
Hi. Makes ice but will not dispense. Motor ok, when lever is pushed I can hear the switch click. Sears parts shows 2 control boards. Would one or the other be safer to buy and try? Thank You. Tom
Current Answers
Related Whirlpool GC5SHAXVS Manual Pages
Dimension Guide - Page 1
... space between the side wall and the refrigerator side. Because Whirlpool Corporation policy includes a continuous commitment to operate the water dispenser and ice maker. Instructions packed with the leveling legs... Depth, Side by a switch. Do not use an extension cord.
PRODUCT DIMENSIONS
Top view
35⁵⁄₈" (90.5 cm)
³⁄₈" (95.3 mm)
24" (61.0 cm)
27...
Installation Instructions - Page 2
...drill bit
s Two adjustable wrenches
s Flat-blade screwdriver
s ³⁄₈" and ¹⁄₂" socket wrench
s or adjustable wrench
PARTS NEEDED: s Your refrigerator dealer has a kit available with ...Product Dimensions
Top View
35⁵⁄₈" (90.5 cm)
³⁄₈" (95.3 mm)
24" (61.0 cm)
27¹⁄₂" (69.7 cm)
30¹⁄₈" (76.4 cm...
Installation Instructions - Page 3
...(167.7 cm) long. Side View
s Height dimensions are fully extended to 1" (25 mm) below the refrigerator. Front View
21¹⁄₄" (54.1 cm)
AB
A
66" (167.7 cm)
C
3⁵... legs are shown with the leveling legs extended to the back of ¹⁄₄" (6.35 mm) below the refrigerator, add ³⁄₄" (19 mm) to the height dimensions.
35 90.6 cm)
Model Size
23' (...
Installation Instructions - Page 4
... cm)
Door and Side Panels
Factory Door Panels and Side Trim Kits
All factory parts are available through your decorator panels. Decorator Door Panel Kits
Decorator door panel kits ... (13.6 kg)
17 lbs (7.7 kg)
Flat panels:
You can create a custom flat panel a maximum of ¹⁄₄" (6.35 mm) thickness to a minimum of the refrigerator.
Color
23' Model
25' Model
Stainless Steel...
Installation Instructions - Page 5
... ground prong. Before you move your refrigerator be removed from the rear of the refrigerator opening. Use an outlet that a separate circuit serving only your refrigerator into its final location, it is important to make sure you are installing the refrigerator to ¹⁄₄" (6.35 mm) backing or by a switch. Raised panels:
A raised panel design...
Installation Instructions - Page 6
...control (Thermostat, Refrigerator or Freezer Control depending on the model) to protect the floor.
Water Supply Requirements
Gather the required tools and parts...refrigerator. If the water pressure to the reverse osmosis system is required to operate the water dispenser and ice...valve, a union, and copper tubing. TOOLS NEEDED:
s Flat-blade screwdriver
s ¹⁄₄" Drill bit
s ...
Installation Instructions - Page 7
...:
s Flat-blade screwdriver...refrigerator. Do not overtighten. 5. Turn shutoff valve ON. 7. Check for leaks around the saddle valve. The ice... maker is under the top trim first.
7.
Determine the length of any packing tape.
2.
Tighten the pipe clamp screws carefully and evenly so washer makes... connection on the water pipe. It is pushed back against the wall. 6. Top trim...
Installation Instructions - Page 8
... nut by dispensing and discarding 1.5 gal. (5.4 L) of water through the copper tubing and into a bucket to follow the steps below to make sure that leak. 8
Plug in Refrigerator
WARNING
Electrical Shock...
4. Open the freezer door and turn off Valve
1. Move the switch to the OFF (right) setting as shown. s Allow 24 hours to an existing household water line. s Depending on the top...
Energy Guide - Page 1
... rates and use.
•Cost range based only on models of similar capacity With Automatic Defrost, With Side-Mounted Freezer and With Through-The-Door-Ice Service
•Estimated operating cost based on a 2007 national average electricity cost of 10.65 cents per kWh
•For more information, visit www.ftc...
Owners Manual - Page 1
... DEL RENDIMIENTO.........22 GARANTÍA 24
SÉCURITÉ DU RÉFRIGÉRATEUR 25 UTILISATION DU RÉFRIGÉRATEUR 26 ENTRETIEN DU RÉFRIGÉRATEUR 30 DÉPANNAGE 31 ACCESSOIRES 33 FEUILLES DE DONNÉES SUR LA PERFORMANCE 34 GARANTIE 36
REFRIGERATOR SAFETY
Your safety and the safety...
Owners Manual - Page 2
...; Disconnect power before servicing. ■ Replace all parts and panels before adjusting the controls.
■ The preset settings should be sure to help prevent accidents. Recheck the temperatures before installing ice maker (on ice maker kit ready models only).
■ Use a sturdy glass when dispensing ice (on your old refrigerator. The factory recommended set points to the...
Owners Manual - Page 3
... point. The set point.
When the backlight is desired at the same time
for the refrigerator is activated, the LOCK and FAST ICE/COOL buttons adjust the refrigerator compartment temperature. Additional Features
NOTE: The display screen on the dispenser control panel has a backlight, which will turn off , the first press of 90 minutes unless manually...
Owners Manual - Page 4
... at the National Livestock and Meat Board recommended storage temperatures of 28° to 32°F (-2° to flow, continue depressing and releasing the dispenser lever (5 seconds on the dispenser control panel has a backlight, which type of ice you may cause a slight delay when dispensing crushed ice. To store meat: Set the control to one or more . Remember to...
Owners Manual - Page 5
.... The display screen indicates when the dispenser is selected. To turn off power to the refrigerator, to the ice maker, or to make sure the water softener is operating properly and is well maintained.
■ Do not use the dispenser, the light will remain on the ice maker, slide the control to the OFF (right) position. To...
Owners Manual - Page 6
... to remove it snaps into place.
Water Filter Status Light (on your refrigerator. Push the filter into the base grille and rotate the cap until it from ... See "Water and Ice Dispensers."
Hand wash, rinse, and dry removable parts and interior surfaces thoroughly. Use a clean sponge or soft cloth and a mild detergent in warm water.
4. Unplug refrigerator or disconnect power. 2....
Owners Manual - Page 7
... into the correct
positions? NOTE: Adjusting the temperature controls to coldest setting will not close completely
Check the following installation for the refrigerator to this reduction, you did not notice from the
ice maker mold. The refrigerator is added to open ? ■ Are all bins and shelves pushed back into a grounded 3 prong outlet. Due to...
Owners Manual - Page 8
...? See "Water Supply Requirements" in it or has no ice been produced?
Allow 3 days after ice maker hookup for ice production to the refrigerator
or freezer? ■ Are the controls set correctly for "crushed" ice and begin . Check the following : ■ Is the freezer door closed setting. The ice dispenser will not operate properly
Check the following : ■...
Owners Manual - Page 9
... Canada, call 1-800-442-9991 and ask for the part number listed below or contact your cold water supply? The dispenser water is held under the dispenser long enough? ■ Has the water system been flushed since installation or
changing filters? Allow 24 hours for dispenser motor to a cold water line with
water pressure of at...
Owners Manual - Page 10
...Canada, use with water that you replace the filter. Prices are subject to the water dispenser or ice maker decreases noticeably before or after the system.
■ Refer to the "Assistance or... limit for water leaving the system, as advertised.
■ Use replacement cartridge T2RFWG2, part #4396841. When the filter indicator reads "REPLACE," it is essential that you replace the...
Owners Manual - Page 11
...for water leaving the system, as advertised.
■ Use replacement cartridge T2RFWG2, part #4396841. Application Guidelines/Water Supply Parameters
Water Supply Water Pressure Water Temperature Service ...T1WG2L: Style 1 - When the filter indicator light changes from "GOOD" to the water dispenser or ice maker decreases noticeably before or after the system.
■ Refer to the "Assistance or ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The ice maker on my upright freezer is not producing ice or not enough ice
..., making the outside of times the freezer door is cooled, the ice maker should produce 70-120 cubes every 24 hours. Your ice maker has an automatic shutoff. Guides: /shared.whirlpoolcorp.com/service/modelnumber.jsp','modelnumber',500,480);return false;" href="#"> Lookup Model # My ice maker runs but doesn't produce ice No ice production - Top freezer Ice dispenser not... -
Dispenser won't dispense ice. French Door with Ice bin in door.
... on the display. Switch back to 'cube' and dispense for the dispenser to see if there is turned on the sides of the ice bin. Bottom freezer/French door refrigerator Removing the Ice Bin, French Door Refrigerator with a plastic utensil if necessary. Check to operate. If there is ice in the ice bin: and you don't hear the auger in... -
My ice maker is making too much ice/won't stop making ice - Bottom freezer /French door refrigerator
... off - Bottom freezer/French door refrigerator Turning the ice maker on and off until you hear a click and the arm stays in Door, Flush Mounted Dispenser with LCD Display Low ice production - Check to see if the shutoff arm is pushed down. Side by side refrigerator Bottom freezer/French door refrigerator No or low ice production - Side by Side...
Similar Questions
Whirlpool Refrigerator Ice Dispenser Motor Not Working
I have a Whirlpool refrigerator (Model #ED5LHAXMB00). The ice dispenser in the door stopped working....
I have a Whirlpool refrigerator (Model #ED5LHAXMB00). The ice dispenser in the door stopped working....
(Posted by mikehkok 10 years ago)
Refrigerator With Frozen Water Line At Icemakermakef
How do I thaw the water line where kt is My whirlpool, GC5THGXLS00,(refridgerator) is not making ice...
How do I thaw the water line where kt is My whirlpool, GC5THGXLS00,(refridgerator) is not making ice...
(Posted by cherylraecanonge 10 years ago)
Ice Bin Is Stuck In Freezer. What Is Best Way To Remove It?
I can tell there is frost/ice build up in the lower part of the bin housing.
I can tell there is frost/ice build up in the lower part of the bin housing.
(Posted by Luv2knit 11 years ago)
