Question posted by Krazymike74 on September 13th, 2016
I Have A Viper Smart Start That Has Been Reactivated And I'm Getting Error 12
error 12
Current Answers
Answer #1: Posted by waelsaidani1 on September 13th, 2016 10:33 PM
The command sent from SmartStart (Lock, Unlock, SmartStart, Trunk, Panic, Aux1, Aux2, Status) was sent to the vehicle but no response was received. This can be caused by any of the following: 1) Device is outside coverage of the cell network 2) Device is powered down 3) Device is in the middle of resetting data connection or power cycling 4) Device has locked up or stopped communicating due to internal issues.
If this issue persists please contact SmartStart support.
If this issue persists please contact SmartStart support.
Similar Questions
Just Changed My Car Battery Ever Since I Changed The Battery I Can't Get The Rem
hey there just changed my car battery after I changed it I went to go remote start my car will sound...
hey there just changed my car battery after I changed it I went to go remote start my car will sound...
(Posted by Adamdamrau 3 years ago)
Remote Start Run Time Adjustment
Hello,I would like to change the remote start run time and delay on my diesel I want to extend both ...
Hello,I would like to change the remote start run time and delay on my diesel I want to extend both ...
(Posted by jpearson24513 4 years ago)
Lexus 400h Starts But Once Key In Car Shuts Off When Brake Pressed
(Posted by Yodaahpie 8 years ago)
Won't Start
i had to learn a new remote and the lock and unlock features work but,the remote start will not.the ...
i had to learn a new remote and the lock and unlock features work but,the remote start will not.the ...
(Posted by llombardo 10 years ago)
Where Can I Get Install Info On A Viper 4105v For A 07 Sante Fe?
Where can i get info on how to install my viper remote start model #4105v for my 2007 Hyundia Sante ...
Where can i get info on how to install my viper remote start model #4105v for my 2007 Hyundia Sante ...
(Posted by blackwoodauto 10 years ago)