Uniden QT206 Support Question
Uniden QT206 Support Question
Find answers below for this question about Uniden QT206.Need a Uniden QT206 manual? We have 1 online manual for this item!
Question posted by bsylva on April 30th, 2012
Uniden Qt-206
where can I purchase just the guage itself in black ?
Current Answers
Related Uniden QT206 Manual Pages
English Owners Manual - Page 3
Contents
Unpacking 2 Features 2 Installing the QT 206 3 Transducer Wiring 4 Power Cable Wiring 4 Installing The Transducer 5
Transom Mount Transducers 5 Through-the-hull Transducers 8 Low Profile Transducers 9... 17 When to Use More Sensitivity 18 Troubleshooting Guideline 19
Features, Specifications, and availability of Optional Accessories are all subject to change without notice.
1
English Owners Manual - Page 4
... Viewing - These readings are missing or damaged, please contact your night time navigational needs.
2 The QT-206 is back lit at all times with 3 lugs attached • Power Cable (attached to the gauge... This Operating Guide
If any items are displayed on a large Liquid Crystal Display (LCD).
The QT-206 is designed to give depth readings from 2.0 feet to 15 feet, and are in 1/10 foot...
English Owners Manual - Page 5
...the shaft until the U-shaped bracket is aligned properly. INSTALLING THE QT-206
1. Look at the front of the instrument to ensure that it ...-005
2 3/8"
2" 2 1/2"
NUT P/N: 3203-009
MOUNTING BRACKET WASHER
P/N: 950-025
P/N: 308-029
X-ducer Red Black Shield
Alarm
More
Less
Shallow
Sensitivity
Power
+
3 After finding the right location for any adjustments with your dash panel which...
English Owners Manual - Page 6
... will need to wire it directly to connect the transducer wires. These lugs need these female lugs, contact your Uniden Marine dealer. Connect the shield to the BLACK wire.
POWER CABLE WIRING
Because the QT-206 has no ON/OFF switch, you need to either the RED, BLUE, or WHITE wire. These terminals are...
English Owners Manual - Page 7
... 12-volt battery using the power cable supplied with Inboard engine(s).
• INSIDE-THE-HULL - Connect the BLACK wire to the centerline (keel) of the boat where the propeller blade is on. Connect the RED wire ...On single drive installations, you must observe proper polarity (i.e., RED is positive and BLACK is usually the right (starboard) side.
Often called "Shoot Through Transducer";
English Owners Manual - Page 9
... of the screws to prevent water seepage into the water to the threads of water.) Coating transducers with the water. Route the cable to the QT-206, being careful not to operate improperly.)
Transducer Wetting
Immediately before launching your vessel, thoroughly wipe the face of the hull. Make sure the cable is...
English Owners Manual - Page 17
... show these numbers in the unit's memory until power is off . A00 indicates the alarm is turned off .
15 SETTING THE SHALLOW WATER ALARM Located just below the LCD window are two keys labeled "DOWN" and "UP" Alarms. These keys are by 2-foot increments (for example: 10, 12, 14, 16, 18...
English Owners Manual - Page 23
... the date of original purchase and a note describing the defect that has caused you are certain that the product does not conform to this warranty at :
Uniden America Corporation Parts and ...may not apply to you without charge for parts, service, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other rights which vary from defects in ...
English Owners Manual - Page 24
©1995,1996 Uniden America Corporation Printed in the United States of America
All rights reserved. OMQT206
Similar Questions
Qt206 Alarm
My boat is sitting on my trailer and I would like to know when the depth finder is on the alarm soun...
My boat is sitting on my trailer and I would like to know when the depth finder is on the alarm soun...
(Posted by billhudson2000 2 years ago)
Where Can I Buy A Uniden Qt-206?depth Finder? Need To Replace Old Unit
I would like to replace the old broken unit on my boat. Where can I buy 1
I would like to replace the old broken unit on my boat. Where can I buy 1
(Posted by Randy44m 6 years ago)
I Have A Impulse Qt-206 Depth Sounder, Is The Uniden Qt-206 The Same Transducer
I have a impulse QT-206 depth souder is the unider qt-206 the same with the tranducer plugs
I have a impulse QT-206 depth souder is the unider qt-206 the same with the tranducer plugs
(Posted by Wmtauro 10 years ago)