Troy-Bilt TB625 Support Question
Troy-Bilt TB625 Support Question
Find answers below for this question about Troy-Bilt TB625.Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!
Question posted by Anonymous-168862 on July 28th, 2021
Changing Starter
how do I change the starter tb625ec
Current Answers
Answer #1: Posted by nanzy on July 29th, 2021 10:07 PM
nanzy
Member since:
May 26th, 2021 Points: 110,250
Member since:
May 26th, 2021 Points: 110,250
Related Troy-Bilt TB625 Manual Pages
Operation Manual - Page 1
...operation or maintenance of the unit, please call the Customer Support Department to make changes at 1-800-828-5500 in the United States or 1-800-668-1238 in ...Copyright© 2013 MTD SOUTHWEST INC, All Rights Reserved.
01/13 Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB625 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8...
Operation Manual - Page 3
..., even after each use .
• Do not force the unit. Be in daylight or good artificial light.
• Avoid accidental starting position whenever pulling the starter rope. Only use them these instructions. Keep a firm grip on both trimming lines extended and the proper line installed. Take extra care when working on...
Operation Manual - Page 5
...• Edging • Decorative trimming around trees, fences, etc. We reserve the right to make changes at the time of printing. in.) Spark Plug Gap 0.025 in. (0.635 mm) Spark Plug ... Shaft Grip
ASSEMBLY TOOLS REQUIRED: • 3/8" Socket
On/Off Switch
Muffler
Spark Plug
Starter Rope Grip
Primer Bulb
Fuel Cap
Handle Shaft Housing
Air Filter Cover
Throttle Control
Choke Lever
...
Operation Manual - Page 8
...proper oil level cannot be added before each use dirty oil. Failure to the fuel tank. Change the oil according to Checking the Oil Level. NOTE: Save the empty oil bottle. The ...Maintenance Schedule. DO NOT mix oil with a 2.03 fluid oz. (60 ml) bottle of oil during future oil changes. NOTE: Make sure the O-ring is in the crankcase. Funnel Spout Oil Fill Plug
Fig. 7
O-Ring Oil...
Operation Manual - Page 10
... be lethal in Position 3, squeeze and hold the On/Off switch in a stable position when pulling the starter rope (Fig. 12).
Crouch in the ON ( I ) / Start
STARTING INSTRUCTIONS
1. NOTE: SQUEEZE ... steps 3 - 8 to 60 seconds.
10. Run the unit for 30 to restart the engine. Starter Rope Grip
Starting Position
Throttle Control
Fig. 12
10 Carbon monoxide exhaust fumes can be in the OFF ...
Operation Manual - Page 11
... until the unit starts. Continue to squeeze the throttle control. Move the choke lever to Fueling the Unit.
Description
49M2027P966 Electric Starter 49MESCBP966 Engine Starter Bit 49MRBESP966 or 49MRBESY966 Cordless Electric Starter
STARTING INSTRUCTIONS
1. Refer to Position 3 (Fig. 11) and continue warming the engine for 2-5 minutes, or as needed . NOTE: There is in...
Operation Manual - Page 13
...the spark arrestor, muffler, carburetor, etc. Refer to Maintaining the Air Filter.
• Change the oil. These can break off and become dangerous projectiles.
Turn the bump knob counterclockwise to...will remain attached to align the arrows (Fig. 17). 4. Disconnect the spark plug wire to Changing the Oil. • Have the rocker arm clearance checked by an MTD authorized service dealer....
Operation Manual - Page 15
... the oil out of oil.
Wash the air filter in the air filter housing (Fig. 24). Reinstall the air filter in detergent and water. CHANGING THE OIL
Change the oil while the engine is still warm. The oil will
VOID the warranty. 7. Unscrew the oil fill plug. 3. Tip the unit vertically to...
Operation Manual - Page 17
...
3. Wipe off any loose or damaged parts. Short-term Storage (1-2 weeks)
1.
Allow the engine to Changing the Oil. Thoroughly clean the unit and inspect it for any moisture with the engine at the top.
... oils such as pine and lemon, and solvents such as kerosene, can damage plastic. Pull the starter rope slowly to clean the outside of the unit. Do not use fuel that has been stored ...
Operation Manual - Page 20
...- Wear items - Troy-Bilt reserves the right to change or improve the design of the product shall void this... without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses,...purpose. Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw Chains, Guide Bars,
Cultivator Tines,...
Similar Questions
Tb225 Starter Rope Replacement. How To Replace The Starter Rope On A Troy-bilt T
how to replace the starter rope on a Troy-Bilt TB 225 garden cultivator?
how to replace the starter rope on a Troy-Bilt TB 225 garden cultivator?
(Posted by hamptona0000 6 years ago)
How Do I Change Cutting Head On A Troybilt Tb625ec?
I can't figure out how to remove the old cutting head.
I can't figure out how to remove the old cutting head.
(Posted by dougclapp24 7 years ago)
How To Change Putt Cord
How do I change the Pull Cord on my TB625ec
How do I change the Pull Cord on my TB625ec
(Posted by Christiangrill 9 years ago)
Starter Rope Replacement
Can the starter rope be replaced by the owner? I own an older Troybilt trimmer. The starter rope can...
Can the starter rope be replaced by the owner? I own an older Troybilt trimmer. The starter rope can...
(Posted by bluesbox 10 years ago)