Troy-Bilt TB516 Support Question
Troy-Bilt TB516 Support Question
Find answers below for this question about Troy-Bilt TB516.Need a Troy-Bilt TB516 manual? We have 1 online manual for this item!
Current Answers
Answer #1: Posted by Victoria45 on May 14th, 2023 2:43 AM
Victoria45
Member since:
May 10th, 2023 Points: 1,190
Member since:
May 10th, 2023 Points: 1,190
remove belt cover to expose the belt and pulleys. Take note of how the belt is routed.! you will need to follow the same route with the new belt. You may need to remove the Blade guard if the belt doesn't fit over the head of the guard. There may also be a sprung idle tension pulley, which will take up the slack in the belt once replaced. Looks pretty straight forward.
Related Troy-Bilt TB516 Manual Pages
Operation Manual - Page 1
TB516 EC Electric Start Capable 4-Cycle Lawn Edger
Operator's Manual
English - Page 1
Remove Unit From Carton
Assemble The Unit
NO TOOLS REQUIRED!
1 Remove ...IF the engine does not start lever back up for 30 to the front of both lower shafts and align the holes. Edger Blade
Depth Adjustment Lever
Blade Shield
10 X 19
Press primer bulb 10 times, or until the unit starts.
Page 5
...
Operation Manual - Page 2
...short time after turning off for maintenance or repair. • Use only original equipment manufacturer replacement parts and accessories for the job. OTHER SAFETY WARNINGS • Never store a fueled ...free from the operating area.
• HOT SURFACE
WARNING: Do not touch a hot engine. Replace damaged parts. SAFETY WARNINGS FOR GAS UNITS
WARNING: Gasoline is dusty. • Wear heavy, ...
Operation Manual - Page 3
...wheel increases the cutting depth.
As it wears it as needed . Replace the blade when it . Check the oil level in the table...injury, the operator and unit must be performed by a Troy-Bilt or other qualified service dealer. Fill the fuel tank with...be in the ON (I ) position at all times (Fig. 5).
ADJUSTING EDGER CUTTING DEPTH
1. Refer to the instructions on a flat, level surface.
...
Operation Manual - Page 4
...gauge (Fig. 24).
5.
Check alignment of children. We reserve the right to start the edger after checking the fuel and cleaning the air filter, the engine still will flow freely and ...more impurities.
1. NOTE:
Use the bottle and spout saved from the cylinder before tightening the screws. Replace the oil fill plug. Unscrew the knob on the bottle measures approximately 3.04 fl.oz. (90 ml...
Similar Questions
Need New Motor Engine For Troy Bitl Riding Lawn Mower 15.5
(Posted by janicesutton60 2 years ago)
How To Adjust Troy Bilt 4 Cycle Tb516 Ec Edger Carburetor. Blade Won't Turn
(Posted by famterry10 8 years ago)
Troy Bilt Tb554 Lawn Edger Wont Start Has Fuel And I Primed It...
(Posted by r8rnation210 10 years ago)
My Tbe516 Edger Will Not Start. I Have Replaced Carb And Spark Plug .
(Posted by dmcolter 10 years ago)
What Is The Model Number For Tb516ec Edger Blade
(Posted by Anonymous-121477 10 years ago)