Troy-Bilt TB32 Support Question
Troy-Bilt TB32 Support Question
Find answers below for this question about Troy-Bilt TB32.Need a Troy-Bilt TB32 manual? We have 1 online manual for this item!
Question posted by Kclaypool on March 31st, 2015
Tb32ec Cutting Head
how do you remove the cutting head on Tb32ec weed eater
Current Answers
Related Troy-Bilt TB32 Manual Pages
Operation Manual - Page 1
... 3/8" Socket
Starter Rope On/ Off Switch
Coupler
D-Handle
Fuel Cap Throttle Control
Cutting Head Shield
Need Help? Choke Lever
Electric Starter or Power Start Bit Optional! Please ...Hold the inner reel and outer spool together.
Page 1
Removing Unit From Carton
Assemble The Unit
1
2
Remove all contents from the holding slots. IF engine fails to...TB32 EC
2-Cycle Trimmer
English -
Operation Manual - Page 2
...and muffler free from the unit immediately before storing or transporting. Never remove the fuel tank
cap or add fuel when the engine is dusty....operating, maintenance, and repair information. Refer to do
not touch the line cutting blade. Failure to them these instructions for later use . Keep
away ...the head, hands and feet. • Clear the area of California, Maine, Oregon and...
Operation Manual - Page 3
...Remove fuel cap slowly to use the fresh fuel mix explained in the handle should be to the oil and fuel mixing
instructions on its use is
UNLEADED GAS 2 CYCLE OIL
recommended to avoid injury from the upper and lower shafts prior to tighten (Fig. 3). Never operate the
unit without the cutting
head...APPLICATIONS As a trimmer: • Cutting grass and light weeds. • Edging • ...
Operation Manual - Page 4
...seasonal tune-up when engine accelerates without hesitation. These procedures should be performed by removing all times (Fig. 6).
3.
Make sure you are dry.
• ... Head™ cutting head allows the release of the cutting line is dependent upon:
• Following the trimming techniques
• What vegetation is being cut
• Where vegetation is cut thick, stalky weeds
...
Operation Manual - Page 5
...Remove the inner reel from the cylinder head with a replacement part #753-06193, a Champion RDJ7J or an equivalent spark plug.
4. If necessary, remove burrs or replace the inner reel and outer spool. Proceed to make carburetor adjustments. Winding New Trimming Line onto the Inner Reel. Cut...3 - NOTE: The outer spool will cause the cutting head to Part 3 -
Installing the Inner Reel.
The...
Operation Manual - Page 6
...spool Disassemble, remove the welded ...CUTTING HEAD WILL NOT ADVANCE LINE Cutting head bound with grass Cutting head out of line is ready for any moisture with cutting attachment, shield and D-handle) 10 - 11 lbs. (4.5 - 5 kg) Cutting Mechanism Bump Head™ Trimming Line Diameter 0.095 in. (2.41 mm) Cutting Path Diameter 17 in cutting head
Clean and thoroughly dry the cutting head...
Similar Questions
What Direction Are You Suppose To Wind The Line In The Trimmer
(Posted by smellingood56 9 years ago)
Where Is The Spark Arrestor Located On A Tb32 Trimmer
(Posted by tendicott1 9 years ago)
How To Remove Cutting Head
How To Remove Cutting Head From Tb525 Ec Trimmer
How To Remove Cutting Head From Tb525 Ec Trimmer
(Posted by godez 10 years ago)
Remove The Cutting Head
I want to know how to remove the cutting head of TB2044XP trimmer
I want to know how to remove the cutting head of TB2044XP trimmer
(Posted by jthannikary 10 years ago)