Troy-Bilt TB30 Support Question
Troy-Bilt TB30 Support Question
Find answers below for this question about Troy-Bilt TB30.Need a Troy-Bilt TB30 manual? We have 1 online manual for this item!
Question posted by arthurdf on August 21st, 2013
Nothing When I Turn The Key To Start.
When I turn the key to start the mower it doesn't click or do anything at all. The battery is definetly good and I rteplaced the Solenoid. Now what do I check?
Current Answers
Answer #1: Posted by sstaffer on March 9th, 2015 9:17 PM
sstaffer
Member since:
March 9th, 2015 Points: 80
Member since:
March 9th, 2015 Points: 80
If you have not figured this one out yet, the problem will be one of the safety switches that are not closed. There are about four and the main problem I had was with the grass chute attachment, I would have to kick it with my foot when I would not start and then it started right up. A real overkill on the kill switches.
Sherman
Related Troy-Bilt TB30 Manual Pages
Operation Manual - Page 1
... THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Lawn Tractor - 26J Mini-Rider
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
Operation Manual - Page 2
... establish the power rating of printing.
Please refer to the engine manufacturer's Owner's/Operator's Manual, packed separately with regards to ensure your machine, for purchasing a lawn tractor manufactured by looking beneath the seat. This information will operate the machine, carefully follow the recommended safety practices at www.opei.org or the...
Operation Manual - Page 4
...(s) come to a complete stop engine and remove key before attempting to lose control of this machine on...start engine.
1. Tires may lose traction on it . Rapid engagement or braking could result. Avoid starting...mower could cause serious injury. machine by putting your safety, use on
hazard. These operators should not be pushed
6. Do not use care and good judgment.
Always turn...
Operation Manual - Page 5
...over fill fuel tank. Remove key when machine is spilled, wipe it on mower). Follow the manufacturers recommendation for ... Never over accidents, always disengage the cutting blade(s) before starting . Fill tank to cool at all times until fueling ... and the vapors are explosive. Tow only with a plastic liner. "zero-turn machine off . h. Section 2 - g. On slopes, the weight of ...
Operation Manual - Page 6
...working order by an authorized MTD Service Dealer.
Mower blades are subject to be maintained in safe working...and the discharge cover are sharp. Repair the damage before starting and operating.
10. In the State of the California... seconds after operating the blade disengagement control.
3. Periodically check to make adjustments or repairs to improper performance and compromise...
Operation Manual - Page 12
Installing The Deck Chute
WARNING! The studs on the deck surface will not start without the deck chute properly in place.
3. The engine will fit through ...holes on the upper portion of mulch plug is depressing the safety switch located on the deck surface will not start without the mulch plug properly in Step 1. Install the deck chute into the seat bracket when securing the lock ...
Operation Manual - Page 15
.../Choke Lever
4
Speed Control & Parking Brake Lever
Shift Lever Fuel Fill Cap
Cup Holder
Deck Lift Lever
Oil Fill Cap
PTO (Blade Engage) Lever
Figure 4-1
Lawn Tractor controls and features are illustrated in this manual, including the entire Operation section, before attempting to operate this machine.
Operation Manual - Page 16
... plate on the left fender of the lawn tractor, along the running machine unattended. To stop engine and remove key to the START position. Always disengage PTO, move shift... manual for detailed starting instructions. When set parking brake, stop the engine, turn clockwise to prevent unintended starting. FAST
Reverse Caution Mode
Stop Position
Normal Mowing
Start Position
SL OW
Figure...
Operation Manual - Page 17
...tractor must be in the disengaged (PTO OFF) position when starting the engine.
To use , depress the clutch-brake pedal... to the Set-up section in this manual for instructions on checking and adding oil to this window to identify the tractor's fuel...release the lever into an appropriate notch to change the height of the lawn tractor. NOTE: The PTO (blade engage) lever must not be set ...
Operation Manual - Page 18
...on slopes. Do not operate the tractor if the interlock system is malfunctioning. Turn the ignition key clockwise to engage.
Doing so will return to cool before engaging the parking...protection of the operator.
Engage the tractor's parking brake.
4. It will result in the START position for your safety and protection.
Contact an authorized service dealer.
• The safety ...
Operation Manual - Page 19
...
2. If leaving the tractor unattended, also turn the ignition key off and remove the key. Place the shift lever in motion. The lawn tractor is in either FORWARD or REVERSE,....
2. Operation
19 Place speed control lever in highest speed position. 4. Turn the ignition key counterclockwise to prevent unintended starting. Depress clutch-brake pedal. 6. To use speed positions 1 or 2. ...
Operation Manual - Page 20
... a wall or obstruction which may cause discharged material to the lawn.
• Do not cut the grass too short. This ... Engage) lever must be in the disengaged (OFF) position when starting the engine, when traveling in reverse with your application. The ultra... hide obstacles.
• Avoid turns when driving on slopes.
• Watch for your unit. The key is designed to Cutting Blade in...
Operation Manual - Page 21
... PTO, move shift lever into neutral position, set parking brake, stop engine and remove key to prevent unintended starting .
Locate the oil drain valve on the right side of oil. Close the oil ...settled at least once a season with light oil. Front Axles
Each end of tractor operation. Check engine oil level before re-installing them.
Unscrew the oil fill cap and remove the dipstick ...
Operation Manual - Page 22
... levels cannot be checked.
• Always keep the rubber boot positioned over the positive terminal to prevent shorting. When re-installing the battery, always connect the...Battery
The battery is sealed and is being replaced due to damage or wear, the steering will soak the paper element, and water that the wires are connected to remove deposits. Steering Adjustment
If the tractor turns...
Operation Manual - Page 23
...shown on the front end of the blade tip to prevent unintended starting. Uneven tire pressure could cause the cutting deck to have your ...of the PTO Lift Rod. Leveling the Deck
NOTE: Check the tractor's tire pressure before performing any deck leveling ...tractor does not come to a complete stop engine and remove key to the ground. Determine the approximate distance necessary for seat adjustment...
Operation Manual - Page 24
...pipes, and other sources of the engine, and may reach an open flame. Store mower in this section. Maintenance & Adjustments See the complete instructions for approved disposal methods.... extended periods.
Never store lawn tractor with fuel in tank indoors or in the fuel tank during warm weather deteriorates and will cause serious starting problems.
To prevent gum deposits...
Operation Manual - Page 28
...cable to the (positive +) post of your battery charger to the
spindle assembly. Protect your tractor's engine will not crank, first check to Cutting Deck Removal earlier in Figure 7-7.
... start the vehicle's engine when jump starting your battery charger is automatic, charge the battery until it into use for replacement. Do not allow cable clamps to assure a good connection...
Operation Manual - Page 30
...6. Air flow restricted. Damaged or bent cutting blade. 1. Remedy
1. Connect wire to start
Cause
1. Clean grass clippings and debris from around the engine's cooling fins and blower housing...activated.
2. Check the installation of the CHOKE position.
2. Drain fuel tank. Spark plug wires loose. 3. Spark plug gap too close.
1. Excessive vibration Mower will not ...
Operation Manual - Page 31
... Description
954-04318
Drive Belt (Mowing Deck)
918-04822A
Deck Spindle
942-04385
Cutting Blade (30")
925-1707D
Battery
951-12179A 951-04366
625-05002
Fuel Tank Cap Fuel Tank Cap (CA)
Key Asm-Black Key W/Keychain
734-0591
Tire (Rear) 16 x 6.5 x 8
746-04829
Throttle Control/Cable
731-09323
Discharge Chute Assembly
NOTE...
Operation Manual - Page 36
..., and that has a factory installed, and properly operating, adjustment limiting device is still eligible for warranty coverage may be used. Fuel Metering System
• Cold start enrichment system (soft choke) • Carburetor and internal parts (or fuel injection system) • Fuel pump • Fuel tank 2. Miscellaneous Items Used in Above System...
Similar Questions
After Starting Mower I Can't Move Mower Without It Stalling?
unable to move mower after starting
unable to move mower after starting
(Posted by edplock 7 months ago)
Troy Built Riding Mower Turn Key And It Clicks Starter Motor Not Seized ?do
Mower tb30 b Turn key and clicks starter not siezed
Mower tb30 b Turn key and clicks starter not siezed
(Posted by rusthumphrey 11 months ago)
Juice To Ignition Switch But Won T Try To Turn Over
with switch on, no juice to spark plug and switch checks out
with switch on, no juice to spark plug and switch checks out
(Posted by Dfuller951 2 years ago)
Need New Motor Engine For Troy Bitl Riding Lawn Mower 15.5
(Posted by janicesutton60 2 years ago)
Lawn Mower
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
(Posted by sgilbert491974 9 years ago)