Home » Troy-Bilt » Lawn & Garden » Troy-Bilt Storm 3090

Troy-Bilt Storm 3090 Support Question

Find answers below for this question about Troy-Bilt Storm 3090.
Need a Troy-Bilt Storm 3090 manual? We have 1 online manual for this item!

Troy-Bilt Overview Questions Manuals Reviews Videos Research

Question posted by robertemmerson on November 22nd, 2015

Chute Directional

chute directional doesn't work cable off track?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TechSupport101 on November 22nd, 2015 9:00 AM

This answer was accepted by the poster of the original question.

TechSupport101

Member since:
May 24th, 2013

Points: 12,171,305

1,100
points

Hi. Please have a look at the Troubleshooting steps on page 24 of the Operation Manual here https://www.helpowl.com/manuals/Troy-Bilt/Storm3090/187735 and see if they cannot help in correcting the Chute Directional issue at hand.

www.satechhelp.co.za

Related Troy-Bilt Storm 3090 Manual Pages

Operation Manual - Page 1

Storm 2410, 2620, 2840 & 3090XP WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY ...

Operation Manual - Page 2

... applicable to safely and easily set up and operating your machine, for all times. You can seek help from the options below: ◊ Visit us directly. To The Owner 1 Thank You Thank you seek technical support via our web site, Customer Support Department, or with a local authorized service dealer. Choose from...

Operation Manual - Page 4

...or in the auger/ impeller housing or chute assembly. Disengage power to the auger/impeller when transporting or not in place and working. 4 Section 2 - slippery surfaces. gasoline... area. Wash your clothes which are explosive. Important Safe Operation Practices Never direct discharge at all moving parts have stopped before refueling. Move machine to vibrate...

Operation Manual - Page 5

... 1. Disconnect the spark plug wire and ground against the engine to clean out the discharge chute. Also, visually inspect machine for instructions. 7. Refer to a complete stop the engine. Maintain... snow throwers. Check bolts and screws for SORE (Small Off Road Equipment) are working condition. Check control levers periodically to keep the machine in accidents, injuries or death...

Operation Manual - Page 6

... on the machine before attempting to assemble and operate WARNING- warning! Read, understand, and follow the warnings and instructions in the auger/impeller housing or chute assembly. Your Responsibility-Restrict the use the engine's electric starter in a poorly ventilated area.

Operation Manual - Page 7

... 1. Secure the handle by tightening the plastic knob located on both cables are aligned with roller guides before pivoting the handle upward. Figure 3-2 Chute Assembly (Model 2410) 1. See Fig. 3-2. 3. They are seated properly in the Forward-6 position. 2. Figure 3-1 NOTE: Make certain the cables are for packaging purposes only. See Fig. 3-3. See Fig. 3-1. Figure...

Operation Manual - Page 8

...upward. See Fig. 3-4. clip from the end of each. Assembly & Set-Up Figure 3-7 Chute Control Head Chute Support Bracket Chute Chute Base Figure 3-4 Figure 3-6 Chute Directional Control (Model 2410) 2. Figure 3-5 2. 2. Close the flange keepers to secure the chute assembly to Chute Bracket Adjustment on Page 19. 8 Section 3- NOTE: If the flange keepers will click into...

Operation Manual - Page 9

...the joystick to the one o'clock position so that the silver indicator arrow on the joystick and rotate the chute by Figure 3-10 hand to the right at this time. NOTE: The joystick will be angled slightly ... - See "Top View" in the rod with your other hand to line up . The holes in the chute control input will be facing up the hole in Fig. 3-9. trigger on the pinion gear, and will be ...

Operation Manual - Page 10

... top of the hex rod. See Fig. 3-13. See Fig. 3-3. 9. Some models only have one cable to route through the Chute Clean-Out Tool The chute clean-out tool is used to achieve further engagement of the chute control rod into the pinion gear if required. Refer to the top of replacement auger shear...

Operation Manual - Page 11

...Chute Directional Control. Adjustments Skid Shoes The snow thrower skid shoes are over-inflated for shipping purposes. To adjust the skid shoes: 1. Make certain the entire bottom surface of the chute assembly. Pivot the chute...to the tire side wall for recommended pressure. Refer to side wall of the chute assembly. 2. To do not exceed manufacturer's recommended psi. See Fig. 3-...

Operation Manual - Page 12

... "up " position, walk to stop before releasing the auger control. While standing in the disengaged "up " position, the cable should NOT be tight. 2. Repeat this several times. 5. Allow the auger to increase cable tension). 9. Retighten the upper hex screw. 10. Perform all instructions below. It should have very little slack. Assembly & Set...

Operation Manual - Page 13

... Shift Lever † Headlight † 4-Way/2-Way Chute Directional Control † Auger Control Heated Grips † Steering Trigger Control † Standard Chute Directional Control † Augers Skid Shoe † If Equipped...right side of the handle panel and is used to determine ground speed and direction of the handle panel and is automatically turned on top of travel. Adjust ...

Operation Manual - Page 14

..., turn off . NOTE: Always release the drive control before changing speeds. The 2-way chute directional control is located on the left side of the dash panel to the left. Controls and...the left handle) and the augers will result in which snow is thrown, rotate chute directional control. 2-Way Chute Directional Control (if so equipped) The drive control is thrown, squeeze the button on ...

Operation Manual - Page 15

... the rear of the auger housing with these controls. Controls and Features 15 4-Way Chute Directional Control (if so equipped) The 4-way chute directional control is located on the left side of the dash panel. • To change the direction in which snow is thrown, squeeze the button on the joy-stick and pivot the...

Operation Manual - Page 17

... (hex) shaft should be rotated 180° to the Engine Operator's Manual. Tighten securely. Tire Pressure Refer to get any excess or spilled oil. Standard Chute Directional Control (Model 2410) Once a season, lubricate the eye-bolt bushing and the spiral with a multipurpose automotive grease before reinstalling wheels. Allow the engine to the...

Operation Manual - Page 19

... rod until the fuel tank is not fully engaging with the second hole in the chute rotation assembly. Chute Bracket Adjustment (Model 2410) If the spiral at the bottom of the chute directional control is empty and it stops due to lack of the engine and the snow thrower. Loosen the two nuts which...

Operation Manual - Page 24

...auger with fresh fuel. 4. Drive control cable in need of the extension cord to the electric starter outlet and the other... position. 2. Fill tank with clean, fresh gasoline. 4. Connect and tighten spark plug wire. 2. Chute assembly clogged. 2. Refer to Service section 3. Contact an authorized Service Center. 1. Fill tank with...Prime engine as directed in the Operation section. 5.

Operation Manual - Page 25

... Cotter Pin 784-5580 790-00091 Slide Shoe, Standard Slide Shoe, Deluxe 931-2643 Chute Clean-out Tool 790-00120 790-00121 790-00118 790-00119 Shave Plate (Storm 2410) Shave Plate (Storm 2620) Shave Plate (Storm 2840) Shave Plate ((Storm 3090XP) 731-05632 Key 951-10292 Spark Plug Phone (800) 828-5500 to order...

Operation Manual - Page 26

... number and serial number ready). Model Number Description 753-05762A OEM-390-679 490-241-0010 OEM-390-995 490-241-Y014 *Not compatible with Storm 2410.

Operation Manual - Page 28

... of purchase. Attachments - Troy-Bilt shall not be liable for incidental or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for a period of two (2) years commencing on how long an implied warranty lasts, so the above . Phone: 1-866-840-6483, 1-330-558...