Troy-Bilt Mustang 50 Support Question
Troy-Bilt Mustang 50 Support Question
Find answers below for this question about Troy-Bilt Mustang 50.Need a Troy-Bilt Mustang 50 manual? We have 2 online manuals for this item!
Question posted by alliegoodman94 on May 17th, 2021
Mowerrunning Then Shuts Off Says Low Oil Pressure. Just Changed Oil
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by techyagent on May 18th, 2021 11:29 AM
techyagent
Member since:
June 17th, 2014 Points: 4,799,790
Member since:
June 17th, 2014 Points: 4,799,790
Please check this link below:-
https://www.machinerylubrication.com/Read/31182/low-oil-pressure
Thanks
Techygirl
Related Troy-Bilt Mustang 50 Manual Pages
Operation Manual - Page 2
Please read this entire manual prior to familiarize yourself with the machine, its features and operation.
We reserve the right to change product specifications, designs and equipment without notice and without first contacting the Customer Support Department.
Pivot the seat assembly forward to safely and easily set ...
Operation Manual - Page 4
...on the slope. Do:
1. Never leave a running machine unattended. Choose a low enough speed so that area or serious injury could result. Avoid starting or stopping...change the stability of this
dump cart, lawn roller, etc.) on slopes greater than 10". Tall grass can cause a burn. not make sudden changes in daylight or good artificial light. Do not turn slowly uphill and use on the mower...
Operation Manual - Page 5
...Keep the nozzle in contact with the blade(s) shut off the engine and equipment.
i. Move machine ..., as on yourself or your skin and change clothes immediately. Service
Safe Handling of children....cigars, pipes and other debris build-up oil or fuel spillage and remove any fuel soaked...only with safe machine operation. loaded dump cart, lawn roller, etc.) on towed equipment.
4. To avoid...
Operation Manual - Page 6
...original equipment manufacturer's
way. Do not change the engine governor settings or over-...and compromise safety!"
12. Notice Regarding Emissions
6. Mower blades are working condition.
8. Never tamper with low permeation fuel lines and fuel tanks for your nearest...of engine governor. Also, visually inspect blade(s)
for gas, oil, etc. Replace To avoid serious injury or death, do not...
Operation Manual - Page 9
...attached. 1. Cut any packing material. Assembly & Set-Up
3
Contents of the
tractor, just inside each rear wheel. NOTE: Be sure to all features in Figure 3-2.
Tractor Preparation
... rear of Crate
• One RZT L Tractor • One Tractor Operator's Manual
• One Oil Drain Tube • One Engine Operator's Manual
• One Deck Wash Hose Coupler
NOTE: This Operator...
Operation Manual - Page 12
...lowest notch to 4" at the highest notch. Refer to master. Each notch corresponds to a 1⁄2" change in the neutral position to dismount the tractor. When the desired height is also engaged. Each lever ... on each side of the operator's seat.
Pull the handle to raise and lower the mower deck. NOTE: References to all of the movements of the console, and is located on...
Operation Manual - Page 13
... of fuel in the fast position (full throttle) when the tractor is being driven and the mower deck is tethered to the tractor to the left of the hour meter/indicator panel. Towing the...the fuel tank fill neck and turn approximately 1⁄4 turn clockwise to the bottom of the tractor, just inside each the RH and LH transmission) are located on the bottom of the LH console. Transmission...
Operation Manual - Page 14
...50 hours of recorded operation. Follow the oil change intervals provided in this indicator if the engine will also remind the operator of the throttle or throttle/choke control.
Contact your Cub Cadet dealer. NOTE: The oil pressure... fully outward.
14
Section 4- Oil Pressure Indicator (If Engine So Equipped)
This warning lamp indicates low engine oil pressure. Check this manual and the...
Operation Manual - Page 15
...; Check the engine oil level.
• Clean the air cleaner element if necessary.
• Check the tire inflation pressures.
• Adjust the... engine is disengaged.
• The safety interlock system will change the balance of 15% MTBE by volume) is recommended because...operator's seat. Removal of the deck will shut off the PTO and the mower blades will stop before servicing or cleaning....
Operation Manual - Page 16
...not keep trying to crank the engine, recharge the battery. If the battery indicator light or oil pressure light come on, immediately stop position and wait at temperatures near the battery.
Use fresh winter..., and avoid sparks or flames near or below freezing, ensure the correct viscosity motor oil is used in the engine and the battery is unavailable and the tractor must be started...
Operation Manual - Page 20
... the neutral/parking brake engaged position,
• Shut engine off and remove key. Slowly and evenly ... Do not operate on the opposite side of the mower cut quality. Avoid turning downhill if possible. The...or stop and remove the key from your lawn ''browned'' by approximately 45° for ...and possible failure of the turf, if possible, change the direction that can be mowed.
3. If...
Operation Manual - Page 22
... any position other pivot points with a quality lubricating oil.
engage the deck from around the spindle pulleys 4....
P P
Every 25 Hours
P P
Every 50 Hours
Every 100 Hours
Prior to lock the adapter....
Before performing any
accumulation of the mower deck. When using the nozzle at... as needed.
Lubrication
• Using a pressure lubricating gun, lubricate the front castor wheel...
Operation Manual - Page 23
...8226; Do not inflate a tire above the maximum pressure shown on the rear of the tractor, just inside the two rear tires, locate the transmission bypass...factory. Use extreme caution when handling batteries. A discharged battery can be changed. Refer to the recommended pressures. A dirty battery will result from the battery. Engage the transmission ... 50 hours of children.
Operation Manual - Page 24
... your tractor. Refer to the pivot bracket. 2. Change the engine oil and filter following the instructions provided in poorly ventilated... disconnect the negative cable at the battery to the
recommended pressure. 3. Store in a cool, dry location where temperatures are...the fuel tank deteriorates and will result in storage.
1. Shut the engine off, remove the ignition key and engage the ...
Operation Manual - Page 25
Adjustments
NOTE: Check the tractor's tire pressure before performing any deck leveling adjustments. Shut the engine off, remove the ignition key and engage the ...measurement taken should be between 1⁄4-3⁄8" lower than the rear tip. WARNING! Retighten the hex bolt on the mower deck are even with the tractor. 3. Using a wrench, raise or lower the front of the control lever....
Operation Manual - Page 26
...pressure.
3. See Figure 6-6. Insert the shoulder screw into the respective index hole of the engine oil in storage.
1.
Recharge the battery periodically when in the front gauge wheel bracket that the mower...just adjusted wheel, and adjust the other front gauge wheel bracket. If stored outside, cover the riding mower... and shoulder screw. Change the engine oil and filter following the...
Operation Manual - Page 28
... pulley. Lowest Mowing Position
Figure 7-3
2.
Service Pull the left .
4. See Figure 7-4.
46/50/54" Decks
Moveable Idler Pulley
42" Decks Moveable Idler Pulley
PTO Pulley PTO Belt
Transmission Tube
Fixed... idler bracket and movable idler pulley rearward away from the backside of the 'V" belt just far enough to the position that provides the most horizontal run of the belt between ...
Operation Manual - Page 32
... on page 29).
32
Section 7- A block of sharpness is recommended that
the wings are available at all times. Changing the Transmission Drive Belt
Several components must be careful not to 70-90 ft. Mower Blade Care
WARNING! Protect your authorized dealer.
Sharpen the cutting edges of the blades evenly so that the...
Operation Manual - Page 33
...Do not mulch when grass is wet. 3. Cutting blade loose or unbalanced. 2. Uneven tire pressure. 1. Damaged or bent cutting blade.
1. Mow once at a high cutting height, then
...cutting swath. 4. Engine speed too low. 2. Wet grass. 3. Tighten blade and spindle. 2. Sharpen or replace blade. 3. Troubleshooting
Problem
Excessive vibration
Uneven cut
Mower will not mulch grass (If Equipped...
Operation Manual - Page 36
... 490-328-L016
22216
Part
42" Mulch Kit 46" Mulch Kit 50" Mulch Kit 54" Mulch Kit 42" Bagger w/ Weight Kit 46" Bagger w/ Weight Kit 50" Bagger w/ Weight Kit 54" Bagger w/ Weight Kit Front Weight Kit Tractor Cover Blade Removal Tool
Oil Siphon Oil Filter Wrench Spark Plug Wrench 1 Gallon Tire & Tube Sealant by...
Similar Questions
Is Plain Unleaded Gasoline The Correct Fuel For My New Tb 210?
(Posted by rebeccabmccune 11 months ago)
Oil Pressure Came On Fix It Will Not Stay Running
(Posted by fecraig 2 years ago)
Low Oil Pressure Indicator On
I have troy bilt 42 in zero turn mustang with a kohler engine 1.5 HOURS .the low oil pressure indica...
I have troy bilt 42 in zero turn mustang with a kohler engine 1.5 HOURS .the low oil pressure indica...
(Posted by sdap98 7 years ago)
Recoil Start
My electric starter won't start. So I went to try and start my lawn mower with the recoil rope and f...
My electric starter won't start. So I went to try and start my lawn mower with the recoil rope and f...
(Posted by Jordan91011 10 years ago)