Troy-Bilt Mustang 50 Support Question
Troy-Bilt Mustang 50 Support Question
Find answers below for this question about Troy-Bilt Mustang 50.Need a Troy-Bilt Mustang 50 manual? We have 2 online manuals for this item!
Question posted by sdap98 on September 10th, 2016
Low Oil Pressure Indicator On
I have troy bilt 42 in zero turn mustang with a kohler engine 1.5 HOURS .the low oil pressure indicator is on.. I changed the oil and filter, I disconnected the battery . But the low oil pressure indicator is still on.. what could be the causing this. I just purchased this mower two weeks ago..
Current Answers
Answer #1: Posted by waelsaidani1 on September 11th, 2016 9:16 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
Oil Pressure Indicator (If Engine So Equipped)
This warning lamp indicates low engine oil pressure. If the
indicator comes on while the engine is running, stop the engine
immediately and check for possible causes. Do not run the
engine while this indicator is illuminated. Contact your Troy-Bilt
dealer to have the tractor and engine inspected
Related Troy-Bilt Mustang 50 Manual Pages
Operation Manual - Page 1
... • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Mustang Series RZT
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. Printed In USA
TROY-BILT LLC, P.O. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
Operation Manual - Page 4
... tractor to the blades when driving in . serious personal injury. Check overhead clearances carefully before turning.
Choose a low enough speed so that stops power to overturn).
Do not touch.
24. Do Not:
where the operator may contact the engine exhaust and/
5. Disengage all instructions provided with grass catchers or other hidden objects. Read...
Operation Manual - Page 6
...Average Useful Life of seven (7) years, or 270 hours of parts which do not meet the original equipment specifications...engine governor. After striking a foreign object, stop the engine, disconnect the spark plug wire(s) and ground against the engine. Do not change the engine governor settings or over-speed the engine. Other states may include the following emission control systems: Engine...
Operation Manual - Page 12
...: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the front/ right of the tractor...engine. Controls & Features
Fuel Level Window Fuel Tank Cap
LH Drive
RH Drive
Control Lever Control Lever
4
Deck Lift Handle
Deck Height Index Throttle/Choke Control Hour Meter/ Indicator...model. Each notch corresponds to a 1⁄2" change in this manual are located on the front/...
Operation Manual - Page 13
... will turn clockwise to
decrease the engine speed. Cup Holder
The cup holder is designed to operate with the rear wheels on the RH console to prevent its loss. Seat Clamp Knob (Not Seen)
The seat clamp knob is located below the front/left of the hour meter/indicator panel.
SL OW
• When...
Operation Manual - Page 14
... warning lamp indicates low engine oil pressure.
If necessary, move the parking brake to the "START" position. When key is turned to the "ON" position, the battery indicator light briefly illuminates and the battery voltage is turned to the ENGAGED position. The maintenance interval lasts for five minutes after every 50 hours of recorded operation. Follow the oil change intervals...
Operation Manual - Page 15
...control levers smoothly and avoid any zero turn maneuver.
• Do not stop...up .
• DO NOT direct the mower discharge at people.
• Avoid slopes...turning and come to operate this operator's manual. Never operate on traction surfaces that are not approved.
• Check the engine oil level.
• Clean the air cleaner element if necessary.
• Check the tire inflation pressures...
Operation Manual - Page 16
... necessary to the booster battery's negative terminal;
Connect the booster battery as follows:
1. Turn the ignition key to the start the engine. 6. Try again after a few minutes at least 15 seconds to allow the engine's starter motor to place the throttle/choke control in the choke position. 4. If the battery indicator light or oil pressure light come on ).
2. Start...
Operation Manual - Page 20
...position,
• Shut engine off switch, the tractor's engine will result. Using the Mower Deck
WARNING! Premature wear and possible failure of the turf, if possible, change the direction that can be... engine.
20
Section 5- Be careful when crossing gravel paths or driveways. On the first pass pick a point on each subsequent mowing. A U-turn is recommended unless a pivot or zero turn ...
Operation Manual - Page 22
... system, never 6.
engage the deck from around the spindle pulleys 4. Do not use
P
Every 10 Hours
P P
Every 25 Hours
P P
Every 50 Hours
Every 100 Hours
Prior to you.
Cleaning the Spindle Pulleys
Once a month remove the belt covers to disconnect the adapter from yours. engage deck in the presence of wet grass clippings is acceptable to...
Operation Manual - Page 23
... steps a & b after every 50 hours of ammonia/ water or baking soda/water.
• NEVER connect (or disconnect) battery charger clips to the battery while the charger is any reason the tractor will not drive or you to remove the battery.
2.
Observe the following guidelines:
• Do not inflate a tire above the maximum pressure shown on clothing, first...
Operation Manual - Page 24
...and lower arm. Clean the engine and the entire tractor thoroughly.
4. NOTE: Using a pressure washer or garden hose is...to prevent possible discharge. Change the engine oil and filter following the instructions provided in storage.
1. Shut the engine off, remove the ...charge the battery, then disconnect the negative cable at the battery to Figure 6-3. The use of the engine, the fuel...
Operation Manual - Page 25
... the same position. Protect your hands by turning lock nut on the left deck hanger bracket...less than the second measurement. 4.
Shut the engine off, remove the ignition key and engage .... The front gauge wheels on the mower deck are perpendicular with the tractor. ...6-5
6. Adjustments
NOTE: Check the tractor's tire pressure before performing any deck leveling adjustments. With the ...
Operation Manual - Page 26
... so that will be performed whenever the riding mower is operating properly.
7. Clean and fully charge the battery, then disconnect the negative cable at the battery to electrical components, spindles, pulleys, bearings or the engine. Change the engine oil and filter following the instructions provided in the seperate engine manual.
3. They may reach an open flame.
Extinguish...
Operation Manual - Page 33
...Problem
Excessive vibration
Uneven cut
Mower will not mulch grass (If Equipped w/Mulching Kit)
Cause
1. Cutting blade loose or unbalanced. 2. Damaged or bent cutting blade.
1. Engine speed too low. 2. Wet grass. 3. Replace blade.
1. Excessively high grass.
4. Place throttle in all four tires.
1. Deck not leveled properly. 2. Uneven tire pressure. 1. Dull blade.
8
Remedy
1. Perform...
Operation Manual - Page 36
... regarding price and availability.
See your Troy-Bilt dealer or the retailer from which you purchased your Troy-Bilt RZT L tractor. Part Number
19A30006OEM 19A30005OEM...42" Mulch Kit 46" Mulch Kit 50" Mulch Kit 54" Mulch Kit 42" Bagger w/ Weight Kit 46" Bagger w/ Weight Kit 50" Bagger w/ Weight Kit 54" Bagger w/ Weight Kit Front Weight Kit Tractor Cover Blade Removal Tool
Oil Siphon Oil Filter...
Operation Manual - Page 40
...identified. The engine or component parts thereof.
Transportation charges and service calls.
Troy-Bilt shall not... or replacement lawn care services or for rental expenses to items such as : batteries, belts, ...Troy-Bilt parts. This limited warranty does not provide coverage in addition to any implied warranty of merchantability or fitness for whom it was purchased as lubricants, filters...
Parts Manual - Page 1
BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 769-03560 (Oct, 2007) Illustrated Parts Manual
Mustang RZT Riding Tractor
Printed In USA
TROY-BILT LLC, P.O.
Parts Manual - Page 7
... 783-1489C 24 712-04064 25 738-0572
Description
Frame, Seat Graphic, Warning/Deck Ht./Brake
Bracket, Foot Rest Graphic, Troy-Bilt Graphic, Ground Control
Bracket, Battery Hold Down Screw, Hex Wash. TroyBilt Mustang 50" RZT
Operator's Platform
Ref. Hd. Hd. Hd. Tapp, 5/16-18 x .625 Screw, Hex Wash. Tapp, 5/16-12 x .75 Screw, Hex...
Parts Manual - Page 11
...Center
40 783-04415 Skirt, RH
41 783-05030 Bracket, Chute Mounting
42 732-04372 Spring, Torsion
43 711-04565 Pin, Hinge
44 736-0315 Washer, Flat, .76 x 1.50 x .12
45 738-1010A Shaft, Spindle, 5.75
46 741-0919...-04074 Gear, Deck Adjustment
22 721-04041 Adapter, Water Nozzle
Ref. Part No. TroyBilt Mustang 50" RZT
11
Mower Deck
Ref. Tapp, 5/16-12 x .75
12 710-1260A Screw, Hex Wash.
Similar Questions
Need New Motor Engine For Troy Bitl Riding Lawn Mower 15.5
(Posted by janicesutton60 2 years ago)
Mowerrunning Then Shuts Off Says Low Oil Pressure. Just Changed Oil
(Posted by alliegoodman94 2 years ago)
Lawn Mower
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
(Posted by sgilbert491974 9 years ago)
What Oil Filter Should I Use On Mustang 50 Zero Turn Mower
(Posted by Clcneale 9 years ago)
What Oil Filter Comes For Troy-bilt Mustang 50
What oil filter do I get for my troy-bilt mustang 50 and how much oil does it take and what grade do...
What oil filter do I get for my troy-bilt mustang 50 and how much oil does it take and what grade do...
(Posted by lisaandbilly3 9 years ago)