Toshiba 65HM167 Support Question
Toshiba 65HM167 Support Question
Find answers below for this question about Toshiba 65HM167 - 65" Rear Projection TV.Need a Toshiba 65HM167 manual? We have 3 online manuals for this item!
Question posted by pugmcclanahan on May 18th, 2012
Installed New Lamp, Having Same Problem, When I Turn On Tv Red Light Comes On,
very shortly the green light starts blinging about 10 times the TV shuts off. Almost immediately the red light comes back on and the same thing happens, again and again and again
Current Answers
Answer #1: Posted by TVDan on May 19th, 2012 12:47 AM
TVDan
Member since:
August 8th, 2011 Points: 4,732,000
Member since:
August 8th, 2011 Points: 4,732,000
if the lamp is good, the lamp door is closed and the interlock switch is closed (the door has a pin to close this switch), the color wheel is spinning correctly (doesn't sound like a bad fan), then the likely fault is the ballast. Sometimes when the lamp explodes the ballast is damaged too. Unfortunately the color wheel and the ballast is only available as parts on the optical engine: http://www.encompassparts.com/item/7199291/Toshiba/75006693/Optical_Block,_95.
TV Dan
Related Toshiba 65HM167 Manual Pages
Service Manual - Page 6
... in the lamp will generally decrease over time. however, if the lamp unit is replaced. REFER ALL SERVICING NOT SPECIFIED IN THIS MANUAL TO QUALIFIED SERVICE
PERSONNEL. Failure to intentional abuse (such as a light source, the brightness of the lamp in this happens). Using a manual Phillips screwdriver, loosen the two screws on product use projection lamps as excessive...
Service Manual - Page 7
...: Wear soft, lint-free gloves when replacing the lamp unit.
5. NOTE: Never subject the lamp unit to service without removing the lamp unit door completely. Set the old lamp unit aside (-> "Disposing of the TV. WARNING: RISK OF ELECTRIC SHOCK! Make sure the lamp unit and screws are installed securely. Doing so may result in death or...
Service Manual - Page 8
...
NOTE: If, after repeating steps 1-9, the problem still exists:
x In the U.S., call TACP Consumer Solutions at 1-800-631-3811.
For disposal or recycling information, contact your web browser to ensure that the lamp unit and lamp unit door are installed correctly:
x No picture
x Dark picture
x TV will not turn on .
9. Replace the door screw and tighten...
Service Manual - Page 15
Re-assemble by pulling it down.
8. Remove the DMD Fan.
14 Place the fixing rubbers at 4 corners on the new Lamp Fan.
9. DMD FAN REPLACEMENT
1. While lifting the Cover, take the Lamp Fan out by following Steps 1 - 8 in reverse. 7.
Owners Manual - Page 1
... the TV is powered off and then quickly on again when the lamp unit is NOT a sign of malfunction. For details, see page 10. Model number: Serial number:
YC/N VX1A000391A0
HM67 (E/F) Web 213:276
50HM67_EN.book Page 1 Thursday, March 29, 2007 11:28 AM
Integrated High Definition DLP® Projection Television
50HM67 57HM167 65HM167
HIGH-DEFINITION TELEVISION...
Owners Manual - Page 2
...lamp ruptures, the TV will not operate until the lamp unit is committed to the presence of uninsulated "dangerous voltage" within an equilateral triangle is the Sponsor, Producer and Manager of your TV (and other electronic components). Television Stand Model
50HM67
ST 5067
57HM167
ST 57167
65HM167
ST 65167
NOTE TO CATV INSTALLERS... lamp unit contains mercury. NEC, which time you...
Owners Manual - Page 3
...: This product contains a lamp to project the picture, and requires ...installing your safety.
Installation, Care, and Service
Installation
Follow these instructions. 3) Heed all warnings. 4) Follow all times. When a cart is dropped and the cabinet or enclosure surface has been damaged or the TV does not operate normally, take the following precautions: • ALWAYS turn off the TV...
Owners Manual - Page 4
... component connected to rest on the cabinet. If this happens, turn off the TV for example, when the TV is first delivered), condensation may make sure the antenna system is replaced. The length of the quartz glass in the lamp will not operate until the lamp unit is properly grounded to make the picture appear distorted...
Owners Manual - Page 6
... be able to restart the lamp.
or • If the TV is a projection lamp unit with a limited service life. If both LEDs are blinking. This is normal and is turned
off and then on again within a few minutes; If either light flashes, see a "rainbow effect" on the screen, which time you turn the TV off . "Voice announce" feature
When...
Owners Manual - Page 7
... your new TV 9 Overview of steps for installing, setting up, and using your new TV 10 TV front and side panel controls and connections 11 TV back panel connections 12
Chapter 2: Connecting your TV 13 ...TV's advanced features 56 Using the advanced picture settings features 56 Using dynamic contrast 56 Using the static gamma feature 56 Selecting the color temperature 57 Selecting the lamp...
Owners Manual - Page 35
...-On Mode and press c. 3 Press b or B to Fast and you repeatedly turn the TV on page 66 for a few minutes:
• The screen (lamp) lights dimly;
To set the Power-On Mode feature:
1 Press Y and open the Setup menu. 2 Highlight Installation and press T. 3 A new set to select either Power-Saving or Fast mode.
This is a property...
Owners Manual - Page 45
...Preview window
4 To save the new settings, highlight Done and press ...3 Press B or b to Off.
• To turn off the closed caption mode: Select Off in step 3...
66
19
TOKYO
65
18
Current
Weather...same color. If this happens, set the Caption Text ...Red, Green, Blue, Yellow, Magenta, Cyan
45
HM67 (E/F) Web 213:276 w.
09C06.fm Page 45 Thursday, March 29, 2007 4:24 PM
Chapter 6: Using the TV...
Owners Manual - Page 57
... field, select the mode you select one of the factory-set the lamp mode to Low Power mode after the TV is turned on the TV, the lamp will start out in High Bright mode but will be grayed out for a while after a short period of time.
Note: If you
prefer (Cool, Medium, or Warm). This is normal...
Owners Manual - Page 60
... a highly directional outdoor antenna (if applicable). • The station may have broadcast difficulties.
television broadcasts, video games, DVDs), you turn on the TV, the lamp will switch to be replaced (-
If the TV is set the lamp mode to Low Power, each time you may notice that contain a digital display, in rare instances, when viewing certain content...
Owners Manual - Page 62
.... page 35). This is a property of DLP® TV lamp technology and is installed securely. or TCL Customer Service at 1-800-268-3404 in again and turn ON the TV. Turn OFF the TV. "Temperature warning." Red blinks. 9) Blue blinks slowly.
10)Blue blinks quickly.
11)Blue blinks quickly. If the problem persists, contact TACP Consumer Solutions at 1-800631-3811...
Owners Manual - Page 63
... light source for this happens). The lamp has a limited service life that use and user settings. page 68), as applicable. CAUTION: Always handle the lamp unit with internal atmospheric pressure that can affect the useful service life of the lamp, your consumer electronics dealer. Using any lamp other users. Always replace the lamp unit with all projection TVs that...
Owners Manual - Page 64
... when
replacing the lamp unit.
6 Carefully insert the new lamp unit straight into the TV
until it .
4 Using a manual Phillips screwdriver, loosen the two
screws on the back of electric shock and excessive ultraviolet radiation.
TO REDUCE THE RISK OF ELECTRIC SHOCK, NEVER REMOVE TV COVERS, EXCEPT AS SPECIFIED HEREIN. Always turn off the TV and unplug...
Owners Manual - Page 65
...TV will not turn off the TV, unplug the power cord, and repeat steps 1-9 to ensure that may affect the image quality and reduce the service life of children and pets.
however, if the lamp unit is installed
securely; 50HM67_EN.book Page 65... click "Support." The lamp unit in the empty box from the new unit. • Keep the lamp unit out of reach of the lamp. Disposal of flammable liquid...
Owners Manual - Page 67
... the original lamp unit contained in this warranty. DURING THIS PERIOD, TACP WILL, AT TACP'S OPTION, REPAIR OR REPLACE A DEFECTIVE PART WITH A NEW OR REFURBISHED PART WITHOUT CHARGE TO YOU. Your Responsibility THE ABOVE WARRANTIES ARE SUBJECT TO THE FOLLOWING CONDITIONS:
(1) You must retain your home or the DLP® Television will come to...
Owners Manual - Page 68
... PERIOD, TCL WILL, AT TCL'S OPTION, REPAIR OR REPLACE THE DEFECTIVE LAMP UNIT WITH A NEW OR REFURBISHED LAMP UNIT WITHOUT CHARGE TO YOU FOR THE LAMP UNIT. Reception problems caused by inadequate antenna systems are your responsibility. (5) Warranties extend only to material defects in the Television failing for a period of ninety (90) days after the date...
Similar Questions
Toshiba Tv Won't Turn On. Red Light Stays Blinking Slowly And Green Light
TOshiba tv doesnt turn on, when I press power on button red lights turns on and stays blinking after...
TOshiba tv doesnt turn on, when I press power on button red lights turns on and stays blinking after...
(Posted by useridmaria 9 years ago)
Toshiba 65 Inch Dlp Tv Green Light Comes On When I Turn Tv Off
(Posted by ricver 9 years ago)
Will Cleaning Any Part Of Toshiba 65 Rear Projection Hd Dlp Tv Get Rid Of White
dots
dots
(Posted by amlaet 10 years ago)
Toshiba 65hm167 65' Rear Projection Tv
what's wrong with my tv, the picture is full with little stars. I could still watch tv.
what's wrong with my tv, the picture is full with little stars. I could still watch tv.
(Posted by fernandobriceno25 12 years ago)