Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by golfnutken on April 19th, 2013
How Do I Change The Bushings In The Pivot Arm Asm Of A Toro Model 20037 Ppsrlm.
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Toro 20333 Manual Pages
Operation Manual - Page 1
...blade, walk-behind lawn mower is not equipped with Canadian ICES-002.
WARNING
CALIFORNIA Proposition 65 Warning The engine exhaust from an Authorized Service Dealer or at www.Toro.com... Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have similar laws. 22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up Model No...
Operation Manual - Page 2
...lawn mower will be thrown by the blade. Always be ordered through the engine manufacturer. For models with the following safety instructions.
Material may be sure of objects such as rocks, wire, toys, etc., which can result in wet grass. walk;
Exercise extreme caution when changing..., to potential personal injury hazards.
To reduce this mower could lose your...
Operation Manual - Page 3
...with manufacturer's recommended parts, when necessary.
• Mower blades are often attracted to prevent unintended starting ....if necessary, before filling.
• Remove gas-powered equipment from your view of ignition.
• ... you last saw them .
• Do not change clothing immediately.
• Never overfill fuel tank. ...personal injury or property damage, use a nozzle lock-open flame...
Operation Manual - Page 4
... before servicing or performing maintenance.
4. Unlock
4 Cutting/dismemberment hazard of hand or foot, mower blade-disconnect the spark plug wire and read the Operator's Manual.
2. Lock
112-8867 ... Decals
Important: Safety and instruction decals are located near areas of hand or foot, mower blade-stay away from the machine.
3. Replace damaged decals. Indicates the blade is identified...
Operation Manual - Page 5
... Blade Control Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle (Figure 3).
1. Figure 3
Figure 4
2. Remove the handle knobs from the mower housing (Figure 4).
Operation Manual - Page 6
... of oil. 1. Handle
8. Handle knob (2)
6. change it does come with a bottle of SF, SG,...Changing the Engine Oil.
1. Grass bag
Figure 7 2. Side-discharge deflector
4. Cutting height lever (4)
2. Wait 3 minutes after the first 5 operating hours; Fuel tank cap
11. Recoil start handle
7. 3
Filling the Engine with Oil
Product Overview
No Parts Required
Procedure
Your mower...
Operation Manual - Page 11
...
Use the grass bag when you want to Operating the Bag-on the mower, remove it is damaged, install a new Toro replacement bag. WARNING
A worn grass bag could allow small stones and other...it to the bagging position (refer to collect grass and leaf clippings from the lawn. contacting the blade can result in serious personal injury. Grass bag pin (2)
2. Raise and hold up the rear deflector ...
Operation Manual - Page 13
...mower for the best lawn appearance. then mow again at the highest cutting height setting and walk slower; If the grass is too long, the mower...striking solid objects with a Toro replacement blade. For example,
13 Set the cutting height on your mower.
- Raise the cutting height... Cut only about a third of the grass blade at a slower pace while mowing.
- Refer to stall.
• Mow only dry ...
Operation Manual - Page 15
...the Air Filter
Service Interval: Every 25 hours 1. Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to your engine operator...• Refer to run dry through normal usage. Gasoline is flammable, explosive and can cause personal injury. never siphon. Disconnect the spark plug wire from the normal operating position.
Recommended Maintenance...
Operation Manual - Page 16
... of adjustment, adjust the self-propel drive cable. 1. Pull down the cable jacket (toward the mower) until the oil level reaches the Full line on the dipstick (Figure 27). Loosen the cable support...SG, SH, SJ, SL, or higher.)
5. Changing the Engine Oil
Service Interval: After the first 5 hours Yearly
Run the engine a few minutes before changing the oil to drain the used oil properly at ...
Operation Manual - Page 19
.... Important: Route the cables to the outside of fuel. 4. Preparing the Mower for Storage
WARNING
Gasoline vapors can no longer start models only). 2. Dispose of the year, add fuel stabilizer to 15 ft-lb.... Tighten all nuts, bolts, and screws.
1. Start the engine again. 5. Removing the Mower from Storage
Connect the wire to prevent cylinder corrosion during the off-season. 8. Recycle it ...
Operation Manual - Page 20
...on the same lot as filters, fuel,
lubricants, oil changes, spark plugs, air filters blade sharpening or worn blades... or workmanship or if it is covered under "Lawn Mowers") or access our web site at more than
...Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly promise to repair the Toro...
Parts Catalog - Page 1
Form No. 3371-848 Rev A
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com.
Original Instructions (EN)
Parts Catalog - Page 2
...: phillips pan head thread forming PRH: phillips round head PTH: phillips truss head PTO: power-take-off RH: right hand ROPS: roll-over protection system
RRB: rear roller brush SFH...6:2, and the wheel by reference number 37 are indicated. List of Abbreviations
AR: as required ASM: assembly BBC: blade brake control BHTF: button head thread forming CARR: carriage CCW: counter clockwise CW: ...
Parts Catalog - Page 3
... Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Upper Handle Assembly 9 Upper Handle Component Assembly 10 Attachments and Accessories 11
© 2011-The Toro® Company
Contact us at www.Toro.com.
8111 Lyndale Avenue South Bloomington, MN 55420
3
Printed in the USA.
Parts Catalog - Page 4
Description
1 117-1084
1 Housing ASM
1:2 94-8072
1 Decal-Danger
1:3 115-4676
1 Decal-Recycler
1:4 112-8867
1 Decal-Port, Washout
2 114-7963-01 1 ...
16 114-7959
1 Latch-Recycle
17 117-1031
1 Spring-Compression
18 32104-120
2 Screw-PPH
19 121-5776
1 Rear Door ASM
19:2 114-7982
1 Decal-Warning
20 115-2859
1 Spring-Torsion
21 114-7924
1 Spring-Torsion
22 112-6400
1 Port-Washout...
Parts Catalog - Page 6
...
2 Nut-Lock
33 3229-5
1 Screw-CARR
34 106-6801 35 121-2371
1 Anchor-Cable, BBC 1 Decal-Shroud
● Not serviced separately
■ Obtain parts from www.briggsandstratton.com
3371-848A... 107-0759 7 107-0797
1 Bolt-Shoulder 1 Bushing
8 3256-16
2 Washer-Flat
9 3296-73
2 Nut-Lock, NI
10 120-3327 11 603773 12 32144-102 13 107-0758
1 Brake Arm ASM 2 Nut 3 Screw-HWH 1 Spacer-Bearing
14 ...
Parts Catalog - Page 7
...
Ref. Part Number Qty. Description
1 115-1956-03 2 Plate-HOC, Front
2 322-3
4 Screw-HH
3 3296-29
6 Nut-Lock, NI
4 105-1818
2 Bushing-Mount, HOC
5 105-1807
2 Arm-Pivot, Front
6 105-1809
2 Arm-Spring
7 110-0549
2 Knob-HOC
8 105-3048
2 Washer-Flat
9 322-6
2 Screw-HH
10 40-1940
2 Washer
11 614650
2 Bolt-Shoulder
12 115...
Parts Catalog - Page 8
... 3296-29
4 Nut-Lock, NI
5 108-9779
2 Retainer-Bushing, HOC
6 104-8699
2 Bearing-Ball
7 108-9782
2 Bushing-Sleeve
8 108-9781
2 Arm-Pivot, Rear
9 108-9780
2 Arm-Spring
10 110-0549
2 Knob-HOC
11 115-4652
1 Transmission...Retaining
18 110-1792
2 Wheel Cover ASM
18:2 614426
1 Washer-Stepped
19 614650
2 Bolt-Shoulder
20 115-4695
2 8 Inch Wheel Gear ASM
21 115-8406
2 Anchor-Bag
22 ...
Parts Catalog - Page 10
Part Number Qty. Upper Handle Component Assembly
Ref. Description
1 117-5975
1 Switch Housing ASM
2 321-50
1 Screw-HH
3 108-3788-03 1 Bail-Brake
4 115-8439
1 Cable-Brake, BBC
5 3290-337
1 Nut-Speed
6 106-9169 7 107-7462
1 Screw-HWH 1 Spring-Torsion
8 107-7463
1 Spacer
9 106-6802
1 Lever
10 32128-17
1 Nut-Lock, Flange
11...
Similar Questions
How To Change Drive Belt On Toro Personal Pace Mower Model # 20333
(Posted by sewPhila5 10 years ago)
How To Change Self-propelled Mower Belt On Toro Model 20333
(Posted by sadigibso 10 years ago)
How Much Oil To Put In Toro Recycler 20333
(Posted by Clbul 10 years ago)
How To Change The Spark Plug In A 21 Inch Toro Personal Pace Mower
(Posted by hosfast 10 years ago)
Where Do I Find The Model# On My Toro Personal Pace Mower
(Posted by Ricm5ru 10 years ago)