Toro 20330 Support Question
Toro 20330 Support Question
Find answers below for this question about Toro 20330 - Low Wheel Walk Power Mower.Need a Toro 20330 manual? We have 3 online manuals for this item!
Question posted by Lmhersey on December 2nd, 2014
Mower Won,t Stay Running
my mower starts but will not stY running
Current Answers
Answer #1: Posted by freginold on December 7th, 2014 1:20 PM
freginold
Member since:
December 20th, 2011 Points: 23,253,885
Member since:
December 20th, 2011 Points: 23,253,885
If your mower starts but won't stay running, it's likely either a problem in the fuel tank/fuel line or carburetor. Try flushing the gas tank and carburetor, giving the carburetor a good cleaning to make sure no holes are clogged, and checking the fuel hose for burrs or blockages. Then fill the gas tank with new, fresh gas and give the mower a try.
One way you can test if it's the carburetor is to start the mower then pump the primer -- if the mower runs as long as you press the primer bulb but then dies as soon as you stop, there is a clog or blockage inside the carburetor.
If it's a new mower, the air filter probably isn't the culprit, but if the above solution doesn't work, check the air filter to be sure it's not dirty, and either clean or replace it.
One way you can test if it's the carburetor is to start the mower then pump the primer -- if the mower runs as long as you press the primer bulb but then dies as soon as you stop, there is a clog or blockage inside the carburetor.
If it's a new mower, the air filter probably isn't the culprit, but if the above solution doesn't work, check the air filter to be sure it's not dirty, and either clean or replace it.
Related Toro 20330 Manual Pages
Operation Manual - Page 2
... the operator. walk; Always look down...running .
• Be sure the area is used to alert you start to potential personal injury hazards. General Operation
• Read, understand, and follow this machine.
• Clear the area of accessories.
Uneven terrain could cause a slip and fall accidents, which could result in severe injury.
Stay behind rotary lawn mowers...
Operation Manual - Page 3
...the engine running . Allow engine to cool before starting .
•...; Check grass catcher components and the discharge guard frequently and replace with a plastic liner. If this is not possible, then refuel such equipment with a portable container, rather than the operator.
• Be alert and turn mower... filling.
• Remove gas-powered equipment from the truck or trailer...
Operation Manual - Page 4
...cables to the outside of the handle knobs as a part from the original machine manufacturer. Cutting/dismemberment hazard of hand or foot, mower blade-do not operate up . and look behind you
removed in step 1 (Figure 3).
4
Figure 3
2.
Warning-read the... Decals
Important: Safety and instruction decals are located near areas of hand or foot, mower blade-stay away from moving parts.
5.
Operation Manual - Page 6
...on an object.
• Fill the tank outdoors when the engine is cold. Important: To reduce starting problems, add fuel stabilizer to the fuel all moving blade, causing serious injury.
• Stop .... Figure 7
If the engine has been running, the muffler will be damaged. A fire or explosion from igniting the gasoline, place the container and/or mower directly on the dipstick. Fill the fuel ...
Operation Manual - Page 7
...recoil start handle
2.
Raise the mower
Figure 9 2. Adjust the cutting height as the rear wheels. To lower the mower, move all the cutting height levers forward (Figure 9). Lower the mower
Note:...mm); 3-5/8 inches (92 mm); Blade control bar
Figure 10 2. Note: If the mower does not start after several attempts, contact an Authorized Service Dealer. Hold the blade control bar against ...
Operation Manual - Page 9
...cutting grass over any object.
• If the mower strikes an object or starts to stall.
• Mow only dry grass ...direction. This helps disperse the clippings over the lawn for all local fire warnings, and keep the mower free of a potential fire hazard in serious ... at the highest cutting height setting and walk slower;
If the bag is too long, the mower may plug and cause the engine to...
Operation Manual - Page 10
... leaves on your mowing speed if the mower does not cut leaf cover. Walk at 2-1/2 inches (64 mm). For example, set the front cutting height one
notch lower than the rear cutting height.
• Slow down your mower. - Raise the cutting height on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the...
Operation Manual - Page 11
... must
11 replace it sharpened; Refer to your engine operator's manual. • Refer to your engine operator's manual for any maintenance procedure. tip the mower prior to running out of the machine from the spark plug (Figure 14) before annual storage.
• Change the engine oil. • Replace the blade or have...
Operation Manual - Page 12
... the dipstick (Figure 17). Replacing the Air Filter
Service Interval: Every 25 hours 1. Tip the mower onto its side with an API service classification of the used oil out through the oil fill tube... the dipstick securely. 6.
Changing the Engine Oil
Service Interval: After the first 5 hours Yearly
Run the engine a few minutes before changing the oil to drain the used oil properly at a local...
Operation Manual - Page 13
...Examine the blade whenever you do not have it sharpened and balanced, or replace it immediately. Tip the mower onto its side with a block of gasoline.
Important: A bolt torqued to 60 ft-lb (82 ...of the blade to overtighten.
contacting the blade can result in serious personal injury. If you run out of wood, put your weight behind the ratchet or wrench and tighten the bolt securely...
Operation Manual - Page 14
... paved surface.
3. Stop the engine.
8. Wash out the area under the mower housing. • Wear eye protection. • Stay in the operating position (behind the
handle) when the engine is connected to a water supply to the grass bag. Start the engine and run it from rusting.
10. Adjusting the Self-propel Drive Cable
Whenever...
Operation Manual - Page 15
...; Allow the engine to cool before storing it.
1. Run the mower until the engine stops from the cylinder.
2. Fold the upper handle forward as shown in the fuel tank is the leading cause of the handle knobs as directed by pulling the recoil start the engine, it is damaged, contact an Authorized
Service...
Operation Manual - Page 16
... some products. ranty Company, 8111 Lyndale Avenue South, Bloomington, MN 55420-1196; Year Power Train Full Warranty for Residential Use (Limited Warranty for Commercial Use)
22 in Recycler® Walk Power Mowers
Conditions and Products Covered under The Toro GTS Starting Guarantee The Toro Company and its affiliate, Toro Warranty Company, pursuant to...
Service Manual - Page 3
... comments regarding this manual without notice. Copyright© All Rights Reserved ©2006 The Toro Company This book contains material covering the Toro and Lawn-Boy Walk Behind Mower Drive Systems models from 1990 through 2006, and may be specified for Toro servicing dealers. This manual was written expressly for use...
Service Manual - Page 5
... Personal Pace Easy Stride (Generation 2 7-6 Lawn-Boy Sens-a-Speed 7-9
Belt Replacement Mowers with Toro Blade Brake Clutch 8-3 Mowers with Toro Blade Override System 8-3 Zone start 21" Rear Wheel Drive Toro & Lawn-Boy (except Insight 8-2 Zone start 22" Toro Rear Wheel Drive 3-10 Zone start 22" Toro Front Wheel Drive 3-5 Lawn-Boy Insight Zone Start 3-19 Lawn-Boy Insight with Blade Clutch...
Service Manual - Page 9
blade brake clutch
for the mower being serviced. cast deck Vacu Power ES1 - Easy Stride 2nd generation Ins - Personal Pace 1st generation PP2 -... spur bevel SR - TABLE OF CONTENTS
Using this information to select the correct sections of deck material, transmission, wheel pinion clutch, hand controls, and if it has a blade clutch system. blade override system CD - Insight PP1...
Service Manual - Page 80
... pinion gear. When you are ok. As the mower rolls away, the drive will drive the mower. This causes the pinions to rock the drive keys to malfunction. Start the engine and engage the drive, if both wheels turn the keys should re-engage. When the mower is straightened out the pinion is greasing every...
Service Manual - Page 88
...does this control system. The second design was introduced in 2005 and is to as Lawn-Boy Medallion mowers. The two are two basic blade clutching system designs. Fig 146
BBC Control Box ... causes the idler to turn separately from the brake drum and tightens the belt. Refer to run. When the control is adjusted properly. This stops the blade but allows the flywheel and...
Service Manual - Page 115
... each time you stop to stop while the engine keeps running. Remove the two locknuts securing the blade (Fig. 205). Slip end of cable and into the air filter and causing hard starting.
2. Remove the blade and blade stiffener (Fig. 206).
On Lawn-Boy it is named the Blade Clutch System.
Install...
Service Manual - Page 129
To operate this keep the engine running. Top bail
Fig 245
DSC-4864a
The Lawn-Boy Sens-a-Speed handle is made in front of the blade clutch ..., walk faster. The bail
engages and disengages the blade.
The Sens-a-Speed handle telescopes and as on a zone start model, pull the top bail down . That will activate the drive too aggressively and the mower will jump forward. Lawn-Boy...
Similar Questions
Will Not Stay Running
having problems keeping running. Starts up but bogs down.
having problems keeping running. Starts up but bogs down.
(Posted by dbergeon15 8 years ago)
Torro Lawn Mower Won't Stay Running
(Posted by scmultip 10 years ago)
Toro Recycler Mower 20331 Wont Stay Running
(Posted by grmgr 10 years ago)
My Toro Mower Starts But Won't Stay Running.acts Like It Is Starving For Fuel.
(Posted by jshilling45 11 years ago)
Toro 22 In. Low Wheel Recycler (20330) Started And Then Shut Off.
I was in the process of mowing my lawn with the Toro 22 in. Low Wheel Recycler (20330) the mower sta...
I was in the process of mowing my lawn with the Toro 22 in. Low Wheel Recycler (20330) the mower sta...
(Posted by damianbourne 12 years ago)