TP-Link TL-WA501G Support Question
TP-Link TL-WA501G Support Question
Find answers below for this question about TP-Link TL-WA501G.Need a TP-Link TL-WA501G manual? We have 1 online manual for this item!
Current Answers
Related TP-Link TL-WA501G Manual Pages
User Guide - Page 8
Package Contents
The following items should be found in your package: ¾ One TL-WA501G 54Mbps Wireless Access Point ¾ One AC power Adapter for TL-WA501G 54Mbps Wireless Access Point ¾ One Resource CD, including:
z This User Guide z Other Helpful Information
) Note:
Make sure that the package contains the above items. If any ...
User Guide - Page 9
..., Point to 855.36m tested in this guide will make configuring the AP easy. Even though you for installation and management. TL-WA501G 54M Wireless Access Point User Guide
Chapter 1 Introduction
Thank you may differ from the actual situation. It adopts 2x to 3x eXtended Range™ WLAN transmission technology so that transmission distance...
User Guide - Page 10
TL-WA501G 54M Wireless Access Point User Guide
Chapter 2 Hardware Installation
2.1 The Front Panel
Figure 2-1
The LED indicators displayed on the front panel, ... The AP is initialising Flashing The AP is working circs. For details, please refer to the corresponding port Off The Wireless Radio function is disabled
Flashing The Wireless Radio function is enabled
2.2 The Back Panel
Figure 2-2 3
User Guide - Page 11
...'s power, until the system LED lights up (about 3 seconds). Consult with the TL-WA501G 54Mbps
Wireless Access Point, use the power adapter supplied with your home or
office). Quickly install the... space on all sides
of the AP, please do the following: 1. TL-WA501G 54M Wireless Access Point User Guide
¾ Wireless antenna ¾ Factory Default Reset button ¾ There are three ways ...
User Guide - Page 12
...Connect the Ethernet Broadband Router to your PC(s) will wirelessly connect. If you desire, as you are connecting a desktop PC or laptop to the TL-WA501G AP. Power on Network
Connections.
5 Figure 2-3 The... Example of the antenna. The best place is usually near the center of the TL-WA501G 54Mbps Wireless Access Point is 192.168.1.1, and the default Subnet Mask is a good direction. ...
User Guide - Page 13
TL-WA501G 54M Wireless Access Point User Guide
Figure 2-4 2. In the General tab of Internet Protocol (TCP/IP) Properties menu, highlight Internet
Protocol (TCP/IP) under "This connection uses the following items:" by clicking on LAN (Local Area Connection), then click
Properties. Figure 2-5 3. In the Network Connections window, right-click on it once.
Click on the Properties button.
6
User Guide - Page 14
TL-WA501G 54M Wireless Access Point User Guide
Figure 2-6 4.
Click OK. Configure the IP address manually. Figure 2-7 7
User Guide - Page 15
... PC and the AP has been established.
If the TCP/IP configuration for your PC is 192.168.1.1, your PC's IP address must be lit. TL-WA501G 54M Wireless Access Point User Guide
1) Open TCP/IP Properties of the LAN card in your PC, enter the IP address as 192.168.1.* (* is any...
User Guide - Page 16
.... There are six main menus on the page, please click the Save button.
9 TL-WA501G 54M Wireless Access Point User Guide
Chapter 3 Software Configuration
This User Guide recommends using the "Quick ...this chapter and configure advanced settings through the Web-based Utility.
3.1 Login
The TL-WA501G 54Mbps Wireless Access Point is easy to configure and manage With a Web-based (Internet Explorer ...
User Guide - Page 17
This field displays the current settings or information for wireless function, including
Operating Mode, SSID, Channel, Mode, MAC Address and IP...basic information or status for the Network, including the
MAC address, IP address and Subnet Mask. ¾ Wireless - TL-WA501G 54M Wireless Access Point User Guide There are the detailed explanations for each web page's key functions below.
3.2 Status
...
User Guide - Page 18
TL-WA501G 54M Wireless Access Point User Guide
) Note:
If you select client mode in Figure 3-7 the wireless status in Figure 3-3 will change, as it showed below:
3.3 Network
You can 't be in dotted-decimal notation (factory default:
192.168.1.1). ¾ Subnet Mask - An ...
User Guide - Page 19
...) to a different value. But it is not necessary to change the IP Address, you must be able to 32 characters. TL-WA501G 54M Wireless Access Point User Guide
) Note:
If you change the wireless channel unless you notice interference problems with another nearby access point.
12 This value is NOT the same as tp...
User Guide - Page 20
....
) Note:
Limited by local law regulations, version for assistance. Only 802.11b wireless stations can be used. The options are shown below . When you have region selection option. TL-WA501G 54M Wireless Access Point User Guide ¾ Mode - Select the desired wireless mode. Select your local government agency for North America does not have altered...
User Guide - Page 22
... LAN. Enter the SSID of how to access.
• Enable SSID Broadcast - Enter the MAC address of its stations and the root AP for greater wireless range. If WDS is associated. Configure the Operating Mode of the TL-WA501G Access Points.
• Configure AP1 on the air.
¾ Client - The...
User Guide - Page 23
... LAN segment should be able to
connect to the Internet or share files and printers with wireless antenna accessories. ¾ Bridge (Point to
connect two wired LANs. TL-WA501G 54M Wireless Access Point User Guide
Figure 3-8 Wireless repeating 2. Verify the wireless security parameters for all access points, if any other AP in bridge mode to Point...
User Guide - Page 24
... same Channel and security settings if security is in Bridge (Point to configure multi-point bridging. Configure the TL-WA501G (AP1) on either LAN segment
should be able to connect to the Internet or share files and printers of... to Point Bridge 1. Please input the MAC address of how to Multi-Point) mode. TL-WA501G 54M Wireless Access Point User Guide
Figure 3-9 Point to Multi-Point) -
User Guide - Page 25
... APs' MAC addresses.
3. Verify connectivity across the LANs. • A computer on LAN 3 in Point-to Multi-point Bridge 1. If you require wireless stations to any LAN segment.
18 TL-WA501G 54M Wireless Access Point User Guide
Figure 3-10 Point to -Point Bridge mode with any other PCs or servers connected to any of the...
User Guide - Page 26
Then the basic settings will show again. TL-WA501G 54M Wireless Access Point User Guide
) Note:
You can view all of APs around you on the Figure 3-7, you have altered on the page, please click the ...
User Guide - Page 27
It is recommended 20 The wireless security function can select one of the following security options:
Figure 3-12 Wireless Securities ¾ Disable Security - TL-WA501G 54M Wireless Access Point User Guide
3.4.4 Security Settings
You can be able to connect the AP without encryption. If disabled, the
wireless stations will be enabled or disabled.
User Guide - Page 28
...Authentication Type.
¾ WPA/WPA2 - Select WPA or WPA2 automatically based on the wireless station's capability and request.
21 Enter the IP address of the four keys will ...enable security.
¾ WEP - Select WPA based on the wireless station's capability and request.
2) Shared Key - TL-WA501G 54M Wireless Access Point User Guide
strongly that radius service used and enter the...
Similar Questions
How To Connect Wireless Tp-link Tl-wr542g To The Main Router Thomson
How to connect wireless TP-Link TL-WR542G as acess point to the main router Thomson
How to connect wireless TP-Link TL-WR542G as acess point to the main router Thomson
(Posted by taniamaz 8 years ago)
Tl-wr740n Won't Reset
(Posted by invsou 9 years ago)
Tl-wr740n Installation
I have a new wireless TL-WR740n from China, please tell me how to install in my computer ?????
I have a new wireless TL-WR740n from China, please tell me how to install in my computer ?????
(Posted by albaluchim 12 years ago)