2011 Subaru Legacy Support Question
2011 Subaru Legacy Support Question
Find answers below for this question about 2011 Subaru Legacy.Need a 2011 Subaru Legacy manual? We have 1 online manual for this item!
Question posted by Asdju on October 14th, 2013
Where 2011 Legacy Hood Button, Manual
The person who posted this question about this Subaru automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Gugurekas on November 19th, 2013 1:33 PM
Gugurekas
Member since:
July 31st, 2012 Points: 1,797,420
Member since:
July 31st, 2012 Points: 1,797,420
Here 2011 Subaru Legacy, manual
Related Manual Pages
Owner's Manual - Page 2
This manual describes the following types of the Legacy series.
1) Legacy 2) Outback
Owner's Manual - Page 7
Engine hood
Washer
Trunk lid (Legacy)
Door lock (transmitter)
Fan speed
Door unlock (transmitter) Trunk lid open (Legacy) or rear gate unlock (Outback) (transmitter)
Instrument panel outlets Instrument panel outlets and foot outlets Foot outlets Windshield defroster and foot outlets Windshield defroster Rear ...
Owner's Manual - Page 18
...) Vehicle Dynamics Control OFF switch (page 7-31) Remote control mirror switch (page 3-51) Illumination brightness control (page 3-30) Light control switch (page 3-27) Audio control buttons (page 5-31) Combination meter (page 3-5) Cruise control (page 7-38) Paddle shift (page 7-22) Wiper control lever (page 3-31) Horn (page 3-52) SRS airbag (page 1-38...
Owner's Manual - Page 34
... button
NOTE
For Legacy, it is occupied, raise the head restraint to the
- CONTINUED - When the seats are located on the top of the seatback. Fold down while pressing the release button on... used (retracted position) When used at the lowest position. To remove: While pressing the release button, pull out the head restraint. To lower: Push the head restraint down the rear seatback and...
Owner's Manual - Page 54
Legacy
9. Outback
8. Pull at the shoulder portion of the belt to verify that it down into the seat cushion and then tightening... that it and restore the ELR function of the seat. To remove the child restraint system, press the release button on the seatbelt buckle and allow the belt to retract fully. Sometimes a child restraint can be pulled out (ALR properly functioning).
Owner's Manual - Page 60
Seat, seatbelt and SRS airbags
1-37
! Legacy 1. restraint while pressing the release button. Remove the head restraint at the seating position where the child restraint system has been installed with a top tether. Fold down the rear seatback" F1-9. ...
Owner's Manual - Page 99
... inside the key head. The transmitter for compliance
could void the user's authority to operate the equipment. Opening the trunk lid (Legacy) without a key . For detailed information, refer to prevent the buttons of the remote transmitter is approximately 30 feet (10 meters). The operable distance of home electronic appliances. However, this device...
Owner's Manual - Page 100
...rear gate/trunk lid) are not properly closed. The trunk lid opens when the " " button is pressed continuously for unlocking of all of the doors and the rear gate) is not... doors
& Unlocking the doors
& Opening the trunk lid (Legacy)
Press the " " button to lock all doors and the rear gate (Outback), briefly press the " " button a second time within 5 seconds.
An electronic chirp will ...
Owner's Manual - Page 107
... map lights and dome light notification is now activated.
& Arming the system
! To stop the alarm Perform any button on " and the horn sounds once, indicating that the engine hood (and the trunk lid (Legacy)) are locked. 5. If the system was previously activated: The trip meter screen displays "AL oF" and the horn...
Owner's Manual - Page 108
To arm the system using the remote trans" button with the remote transmitter. Open the doors and get out of the following actions is locked. 5. Make sure that the engine hood is done during this period. . Press the front side ("... trunk using power door locking switch 1. Close the door.
The system is a Legacy and you that they are not properly closed before arming the system. .
Owner's Manual - Page 109
...unlocked using the remote transmitter. - Any door (including the rear gate (Outback) or the trunk (Legacy)) is opened. - Ignition switch is turned to the "ON" position.
& Valet mode
When ... light will result in this mode, DOORS MUST BE MANUALLY LOCKED. ! To unlock all other doors and the rear gate (Outback), briefly press the " " button a second time within 5 seconds. ! Emergency disarming ...
Owner's Manual - Page 110
... for a short time when the sensed impact is cut. Close the doors. Disarming the system To disarm the system, briefly press the " " button on the vehicle. When the trunk (Legacy) was opened : 4 times . NOTE
. Keys and doors
2-19
"LOCK" position and remove the key from trains . Examples: - Vibration from construction site - Vibration...
Owner's Manual - Page 115
...opener switch, perform the same procedure again. Refer to "Glove box" F6-6. 2. 2-24
Keys and doors
Trunk lid (Legacy)
WARNING
. To prevent dangerous exhaust gas from being stolen.
Also make certain that the trunk is closed while driving. . ...trunk lid by using the remote keyless entry system. Refer to "Opening the trunk lid (Legacy)" F2-9. Press the trunk lid opener lock button.
Owner's Manual - Page 163
... vehicle, firmly press, hold for 2 seconds and release the HomeLink® button that was programmed in the U.S.A. If it is pressed. !
tion manual. Programming for it clears the memory of all three buttons.
Proceed to complete the programming procedure. 1. Press and release the button a second time to step 3 within 30 seconds. 3. The exact location...
Owner's Manual - Page 170
... door openers in the U.S.A. The garage door opener should activate when the HomeLink ® button is difficult to locate the training button, refer to complete the programming. 4. Proceed to complete the programming procedure. 1. tion manual. Press the training button on the garage door opener motor head unit (which activates the "training light" on the...
Owner's Manual - Page 172
... Press and hold the two outer buttons (button 1 and button 3) until the indicator light begins... to move the mirror. 3. Do not use the convex mirror to judge the distance of objects that you want to flash (after programming, contact HomeLink® at www.homelink.com or call 1-800-3553515 for assistance. The mirrors can also be adjusted manually...
Owner's Manual - Page 177
4-4
Climate control 1) 2) 3) 4) 5) 6) Fan speed control dial Temperature control dial Airflow control buttons Air conditioner button Air inlet selection button Rear window defogger button (Refer to "Defogger and deicer" F3-34.)
Manual climate control system (if equipped)
& Control panel
Owner's Manual - Page 183
... AUTO mode operation:
you operate any of the temperature control OFF button
! When the "OFF" button is pressed, the outside air circulation mode (air inlet selection OFF) is pressed. You can then manually control the system as desired using the button
The automatic climate control system turns off (the air conditioner compressor and fan...
Owner's Manual - Page 200
...the following sequence starting from the last FM radio band that you selected. Press the "FM" button when the radio is off to turn the "TUNE/TRACK/CH" dial counterclockwise to select AM ...AM radio operation
Press the "FM" or "AM" button when the radio is on to select FM1, FM2 or FM3 reception. Manual tuning
& FM selection
Press the "AM" button when the radio is on to decrease it.
Each ...
Owner's Manual - Page 201
... listening to will continue until a station is weakened by distance from the station or proximity to
Press the "PTY/CAT" button to change to the scan mode. In such a situation, perform manual tuning to cancel the SCAN mode. This function may not function properly if the station reception is found. Press the...
Similar Questions
